Fire Stopping in Tradeston
Fire-rated and intumescent sealing of service penetrations and linear gaps in Tradeston. CHAS accredited and fully insured, with a 12-month guarantee.
- Unsealed openings around new pipes and cables
- Old intumescent sealant that has split away
- Penetration schedules that need working through
Fire stopping for Tradeston sites
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Different surfaces, different methods
Drylining partitions
Plasterboard partitions are tested as a specific construction. We check that the product’s detail covers that partition type and board thickness before sealing.
Small ducts
Ducts are only sealed with sealant where the detail allows it. The ductwork, its supports and any dampers are for the ductwork contractor.
Fire stopping in Tradeston, done properly
No fire sealant works on its own: its test evidence covers one product in one kind of wall or floor, with set services, gaps, depths and backing. Before we seal anything, we check the opening against the detail it is meant to follow, and raise it with you if it falls outside. If you have open linear gaps along the top of fire-resisting walls and expanding foam used as fire stopping, we can put it right, on pipe penetrations, joints between fire-resisting walls and floors and small duct penetrations where the tested detail allows alike. Facilities teams, main contractors and managing agents in Tradeston tend to want the same three things: a fixed quote, no surprises on site and a 12-month guarantee behind the result.
Large city estates in Scotland, from universities to hospitals and offices, are re-serviced constantly, and new cabling and pipework through compartment walls is a common reason fire stopping gets breached. New openings are closed with the specified fire-rated product, following its test evidence.
A 12-month guarantee applies to all our work. If an installation problem shows up, ring 01277 525 020 or email the details over and we’ll arrange a return visit.
- Location
- Tradeston (G2, G5, G1)
- Wider area
- Glasgow
- Guarantee
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
When to bring in a specialist
For most general trades, sealant is a sideline. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
A short, simple internal joint is often within reach of a maintenance team. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
What sealant work can’t fix
We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Approving the work on behalf of building control
- Gaps in walls that were never built as compartment walls
If in doubt, give us a call on 01277 525 020 or send photos by email and we will say what we think.
What we seal
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Cable penetrations
- Joints between fire-resisting walls and floors
- Pipe penetrations
Nearby places to Tradeston
Other services in Tradeston
Questions about Tradeston
Will you plan work around the academic year at somewhere like University of Strathclyde?
Yes. Tell us the term dates, vacation periods and access windows, and we’ll plan the work around them. We’re CHAS accredited and a Constructionline member, and paperwork such as RAMS is confirmed with the quote.
What do Scotland’s building standards say about service penetrations in Tradeston?
Scotland’s non-domestic Technical Handbook covers it in clause 2.1.14: penetrations keep at least the element’s fire resistance duration, with products tested for their end use. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
Can one quote cover more than one building?
Yes. Multi-site work and planned programmes are a core part of the service, planned site by site to suit how each building is used.
Who decides which product is used?
The specification comes first, if there is one. Without one, the joint decides: how much it moves, what it bonds to and whether it’s wet, trafficked or fire-rated.
Do your applicators hold CSCS cards?
Yes. Should the site need card details in advance, tell us and we will confirm them with the quote.
Do you offer coloured sealant?
It depends on the product. Some ranges are wide, others limited, so we’ll confirm the colours available for the specified product with the quote.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and the quote will be based on it.
Our process
Diagnose, treat, sign off: that’s the shape of every visit. We inspect the joints and confirm what’s in scope, then we prepare and seal each joint with the specified product, and the job ends with a walk round and sign-off. Work on a big city site in Scotland typically involves inductions and permits. Tell us the rules and we will work to them.
- We ask for the product and detail your designer has specified.
- Openings are measured and grouped by detail.
- Improvised fillers and failed sealant are removed.
- Mineral wool or other backing is fitted where required.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
Getting the site ready
- Move anything stored against the joints
- Let us know about inductions and permits
- For older buildings, check the asbestos register before work
Getting a fixed quote
A handful of photos and a postcode is the fastest way to a quote. Upload them with the quote form, or call the office on 01277 525 020 or use the quote form to discuss it first.
Advice
Service penetrations in Tradeston buildings
Plenty of hotels sit less than 2 miles from Tradeston. Bedroom-to-corridor walls in hotels are normally fire-resisting, so new cabling or pipework through them has to be sealed to the tested detail. In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, with proprietary products, intumescent ones included, tested for their end use. We install what’s specified, to the product’s tested detail.
For a unit at a site such as Tradeston Industrial Estate, under half a mile south-west of Tradeston, new power or data runs between office and warehouse can breach a compartment wall. For a hospital such as Glasgow Royal Infirmary, 1.4 miles north-east of Tradeston, penetration sealing is normally phased ward by ward, with infection-control rules agreed first.
Tradeston is about 1 mile east of Glasgow, in Glasgow. We cover commercial sites throughout Tradeston, for single jobs and planned programmes alike. We work across 171 places in Glasgow.
Commercial sites across G2, G5 and G1 are covered. Buildings on Bishop Lane, Paisley Road and Cleland Lane are within our area. Sites close to Tradeston are covered too, including Laurieston (1 mile south-east), Glasgow (1 mile west), Blythswood Hill (1 mile north), Plantation (1 mile west) and Hutchesontown (1 mile south-east). Further afield, our area takes in Kelvinside (3 miles north-west), Hyndland (3 miles north-west), Wyndford (3 miles north-west), Yoker (5 miles north-west), High Ruchill (3 miles north) and Hillpark (3 miles south-west).
Landmarks near Tradeston
Locally, jobs take us to sites close to Stirling's Library, Glasgow Academy and 40 pub, among other places. Nearby too are St Vincent Street Church (0.6 miles north), Kelvingrove Park (1.4 miles north-west) and John Bosco Secondary School (1.2 miles south-east). Tradeston has its own railway station: Glasgow Central station. Other landmarks nearby include Scotland Street School Museum (0.5 miles south-west) and Glasgow Dental Hospital and School (0.9 miles north). Open spaces near Tradeston include Cathkin Braes and Hogganfield Loch.
What we’re called out for in Tradeston
Some service penetrations were never sealed at all because they sat out of sight above a ceiling or inside a riser. They come to light during inspections, refits or when another trade lifts a tile.
Most enquiries start with one or more of the following:
- Builders’ foam or ordinary silicone in compartment walls
- Fire sealant pulled out of the opening
- Seals that don’t match their tested detail
- Seals disturbed by maintenance and left open
Workshops and IT rooms at colleges like City of Glasgow College - Riverside Campus (0.6 miles east of Tradeston) are re-serviced often, leaving penetrations to seal.
What to look for in a quote
- How they handle RAMS and site documents
- How the existing material will be dealt with
- Who will actually carry out the work
- What level of public liability insurance do they hold?
Owners, agents and contractors
If you look after buildings for someone else, clear figures and clear communication matter. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative, plus a 12-month guarantee.
FMs need a contractor who is easy to get on site. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.