Fire stopping in Yoker
Fire-rated and intumescent sealing of service penetrations and linear gaps throughout Yoker and nearby, carried out by CSCS-carded applicators. Fully insured and CHAS accredited.
- Openings found when ceilings come down for a refit
- Service penetrations left open after M&E works
- Expanding foam used as fire stopping
Fire stopping across Yoker
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Compartment walls and floors in Yoker
The 2 miles around Yoker include two care or nursing homes. Care settings depend on compartmentation, so service penetrations made during maintenance or refurbishment need sealing with the specified product. Where that’s fire-rated sealant, we install it to the manufacturer’s tested detail. Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with products tested for that end use. Where fire-rated sealant is specified, that’s what we install, to the tested detail.
At a university such as University of Glasgow Garscube Campus, 2.6 miles east of Yoker, labs, lecture blocks and residences are re-serviced often, so penetration seals are best checked after M&E work. At a college such as West College Scotland - Clydebank Campus (1 mile west of Yoker), checking penetration seals after summer M&E works is good practice. Hotels like Douglas Hotel (to the west of Yoker) are refurbished in phases, and each phase can open up compartment walls.
Yoker is about 2 miles south-east of Clydebank, in Glasgow. We cover Yoker, with the same fixed quotes and 12-month guarantee as everywhere else. Yoker is one of 171 places in Glasgow on our list.
Commercial sites across G13, G81 and G14 are covered. Buildings on Mill Road, Helm Road and Dyke Road are within our area. Access to Yoker is via the A741. Just outside Yoker, we also work in Garscadden (1 mile south-east), Scotstounhill (1 mile south-east), Renfrew (1 mile south), Knightswood (1 mile east) and Scotstoun (2 miles south-east). A short drive away, we cover Glasgow (5 miles south-east), Hillhead (4 miles east), Dowanhill (3 miles east), Woodlands (4 miles east), Woodside (4 miles east) and North Kelvinside (4 miles east).
Local landmarks in Yoker
Around Yoker, our work takes us to commercial buildings near Robertson Park and Wheatsheaf Public House and the streets around them. There’s a railway station in Yoker itself: Yoker station. A little further out are Drumchapel Hospital (1.2 miles north-east) and Renfrew Museum (1 mile south). Open spaces near Yoker include Kilmardinny and Castle Hill.
About our fire stopping in Yoker
On a fit-out or refurbishment, we follow the services contractors floor by floor. We work from your penetration schedule or marked-up drawings. Tell us what records you need and we’ll confirm with the quote. If you are dealing with fire stopping installed outside its tested range and non-fire-rated filler around services, we can help, whatever the surface. For commercial sealant work in Yoker, you deal with one contact from quote to sign-off, whether it’s one building or several.
Scotland’s non-domestic Technical Handbook says a service penetration ought to match, as a minimum, how long the wall or floor resists fire. For a building in Yoker, specified fire-rated sealant is installed as the maker’s tested detail describes.
Every job ends the same way: guaranteed. You get a 12-month guarantee on our workmanship, and we explain exactly what that covers when we quote.
- Place
- Yoker (G13, G81, G14)
- Wider area
- Glasgow
- Cover
- 12 months on our workmanship
- Price
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Updated
- 3 November 2026
Other services in Yoker
Questions about Yoker
Will you work in a care home in Yoker without moving residents out?
Yes. Care settings are planned area by area, at times agreed with the home. Any site rules, from signing in to infection control, are agreed before we start.
Would you work within a site like Golden Jubilee National Hospital?
Yes. Healthcare sites are among the places we work. Each area is agreed with the ward or department and the estates team in advance.
Do you guarantee your work?
Yes, for 12 months. If our installation fails in that time, we return and fix it.
How many days will you need on site?
It depends on the scope, though a typical visit typically takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence. For bigger or phased jobs, we will set out a timescale with the quote.
What site paperwork can you supply?
Tell us what site paperwork you need (RAMS, insurance certificate, CSCS details) and we’ll confirm with the quote.
Do you work in Yoker?
Yes. Yoker is in our area and the rest of Glasgow. To discuss a job, speak to us on 01277 525 020 or email drawings and photos.
What do you charge?
That depends on the job: the volume of work, the access, the specified product and how it’s phased. Call for a quote.
What affects the price in Yoker
What shapes the price:
- Travel to remote or island sites
- Any access equipment needed
- The product specified
- Phasing around occupants
The product called for affects the cost, as does the preparation each joint needs. Access, phasing and site requirements come into it too.
Sending details for a quote
The more we know, the firmer the quote. Helpful details to send:
- Rough lengths or quantities, or drawings if you have them
- Any dates the work must fit around
- Access details, including height
- The product your specification calls for
Send details, get a quote, we seal, guaranteed: that’s how every job runs. The first step is to give us a call on 01277 525 020 or email drawings and photos with what you know.
Commercial clients in Yoker
We take on planned maintenance as well as one-off repairs: resealing failed joints building by building, on a schedule that suits your budget. Sites in Yoker can sit alongside others in a wider programme.
Facilities managers want contractors who arrive with the paperwork sorted. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm with the quote.
Why deal with it now?
Sealing behind the M&E trades area by area beats a sweep at the end. Openings are visible, access is open and nothing has to be taken down. Failed sealant in a shared building in Yoker can affect more than one owner, which makes early repair simpler for everyone. Acting early avoids disputes and bigger repairs.
Quantities, awkward access and phased working all shape the price. Site requirements like inductions and permits play a part as well.
Why appoint us
- Old sealant cut out, never sealed over
- Clear, fixed quotes
- CSCS-carded applicators
- CHAS accredited contractor
Take a look at our cost guide and our accreditations.
Keeping the joints sound
Your facilities or cleaning team can help the joints last. Share these points with them:
- Keep general-purpose fillers away from compartment walls
- Ask the designer to confirm details early on refits
- Have penetrations checked while they can still be seen
- Make fire stopping part of every scope that crosses a fire-resisting wall
Allow the manufacturer’s stated cure time before boxing in or decorating. Some fire-rated sealants accept paint and some don’t, and the data sheet says which.
Regular walk-rounds of service areas are worth the time. Catching a damaged seal early keeps the fix small; found late, it can be one of many.
From enquiry to sign-off
A typical day starts with protection: masking tape along the joint edges and sheeting over anything nearby. The work itself usually takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence, and our waste is bagged and taken away as we go. In a Scottish city, kerbside space and loading need planning, especially near the centre. Shared closes, stairs and the property factor may need to be part of the plan.
- We ask for the product and detail your designer has specified.
- Openings are measured and grouped by detail.
- Improvised fillers and failed sealant are removed.
- Where the detail needs backing, it goes in at the stated depth.
- We gun the sealant in to the specified depth around each service and tool it.
- Completed areas are checked with you, with the records agreed when we quoted.
Before we start on site
- Let us know about inductions and permits
- Point out parking and an unloading spot
- Share your working hours and any access restrictions
Quotes
To get a fixed quote, phone 01277 525 020 or email a schedule or drawings with the site address and an outline of the work. You can also send details through our quote form.
Read more
How the job changes by surface
Cables and cable bundles
Single cables and small bundles are often within a fire-rated sealant’s tested detail. Bundle size, cable type and the space between cables all matter.
Drylining partitions
Holes in board are often cut larger than needed. An oversized hole may be outside the sealant’s range, and the detail may call for board patching or another product.