Fire stopping in Ruchill
Fire stopping for Ruchill, from a contractor working since 2005. Fully insured and CHAS accredited.
- Openings found when ceilings come down for a refit
- Damaged fire seals in risers and voids
- Non-fire-rated filler around services
Fire stopping in Ruchill
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
About our fire stopping in Ruchill
We should be clear about what we do and don’t do. The designer, fire engineer or building control decides which fire stopping is required; sign-off sits with them too. We fit the specified fire-rated sealant following that specification and the maker’s installation guidance. Most enquiries involve fire-stopping items raised at inspection or handover and non-fire-rated filler around services, across small duct penetrations where the tested detail allows, joints between fire-resisting walls and floors and pipe penetrations. One point of contact handles commercial sealant work in Ruchill from the first photos to the final walk-round, whether it’s one building or several.
Older stone and tenement buildings in Scotland’s cities have usually been re-serviced many times. Before sealing, we confirm the wall or floor and the services passing through, so the product matches the detail.
What our 12-month guarantee covers is the way we did the job: preparation, application and finish. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Location
- Ruchill (G20, G22, G23)
- Wider area
- Glasgow
- Guarantee
- A 12-month guarantee
- Quotes
- Quoted before any work starts
- Call
- 01277 525 020
- Updated
- 3 November 2026
Maintenance after handover
For the best life from the joints:
- Agree the fire-stopping specification before services go in
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Record which product was used where
- Check with the data sheet before painting over fire sealant
New services after handover are a common way fire stopping gets breached. Building it into each contractor’s sign-off keeps the walls intact.
On fit-outs, get the fire-stopping specification agreed before the services go in. Details can then be picked to suit the actual pipes, cables and ducts, and the work runs in step with the M&E.
On site: what to expect
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, the manufacturer’s primer is applied where it’s called for, and the sealant is tooled off neatly. City jobs in Ruchill typically need parking and loading planned. Shared closes, stairs and the property factor may need to be part of the plan.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- We fit the backing the detail asks for, to the stated depth.
- We apply the specified sealant to the depth and around the services as the detail shows.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Preparing the site
- Point out any areas we must not close
- Let us know about inductions and permits
- Explain the parking and delivery arrangements
Getting a fixed quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. The first step is to ring 01277 525 020 or email a schedule or drawings with what you know.
Read more
Also in Ruchill
Common problems we fix in Ruchill
When a seal departs from its tested detail, the evidence no longer covers it. An oversized gap, too shallow a bead, missing backing or two makers’ products combined are the usual culprits.
It’s worth sending us details if you spot any of the following:
- Old intumescent sealant that has split away
- Improvised or mixed-product fire seals
- Snag lists that include open service penetrations
- Damaged fire seals in risers and voids
At a university such as University of Glasgow Gilmorehill Campus (1.3 miles south-west of Ruchill), labs, lecture blocks and residences are re-serviced often, so penetration seals are best checked after M&E work.
What to look for in a quote
- Health and safety accreditation such as CHAS
- Proof of insurance
- How long is the guarantee, and what does it include?
- Do they follow the manufacturer’s priming guidance?
Why act early in Ruchill
Fire stopping is a regular point raised at inspections and handover. Late discoveries can delay handover while openings are reopened and resealed. Scottish city buildings take plenty of rain, so a split or hardened joint lets water into the wall. Renewing them early protects the fabric.
Cost follows what’s involved: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a fixed quote.
What you get with us
- Constructionline member for supplier checks
- One phone line for London, the South East and Scotland
- Old sealant cut out, never sealed over
- 12 months’ guarantee on every job
Take a look at how commercial sealant jobs are priced or our accreditations and insurance.
When it isn’t the sealant
Sealant solves a lot, but not everything, and we’d rather tell you before you spend money. These need a different solution:
- Large openings beyond what any sealant detail covers
- Approving the work on behalf of building control
- Deciding what a wall or floor needs, which belongs to the designer
Not sure which it is? You can call the office on 01277 525 020 or send photos by email and we’ll tell you honestly before you book.
Surfaces we seal
- Linear gaps at wall heads
- Cable penetrations
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
Ruchill: questions and answers
Can you seal penetrations in a hotel in Ruchill after a refit?
Yes, where fire-rated sealant is the specified product. Each seal follows the tested detail, and rooms are done in turn.
What do Scotland’s building standards say about service penetrations in Ruchill?
Under Scotland’s non-domestic Technical Handbook (clause 2.1.14), service penetrations should keep at least the wall or floor’s fire resistance duration, using products tested for their end use. The detail is set by the designer and goes through the warrant process; we install the specified product to its tested detail.
How many days will you need on site?
That varies with the scale of the job, but the work usually takes a single visit for a short list of penetrations, or a phased programme for a whole building. Larger or phased jobs take longer, and we will give you a timescale with the quote.
Do you need to see the site first?
Many jobs can be quoted from photos, drawings or a joint schedule. If the job needs a look first, we will arrange a visit before quoting.
Can the building stay open while you work?
Yes, as long as we plan it. We agree a sequence with your contact so just one area at a time is disrupted.
Do you take on multi-site work?
Yes. Multi-site work and planned programmes are a core part of the service, with each site phased to suit its occupants.
Can weather delay the job?
Outside, yes. Sealant needs a dry joint and a temperature within the product’s range, so damp, frosty or very cold days can stop external work. Internal work is rarely affected.
Commercial clients in Ruchill
Building owners and managing agents use us on sealant work across single buildings or whole portfolios. Several sites can go on one quote, which keeps the paperwork simple.
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, with each stage agreed with your site contact.
Fire stopping around Ruchill: how the place shapes the job
Ruchill has plenty of hotels close by, all within 2 miles. A hotel refit often runs new services through compartment walls between bedrooms and corridors, and each opening needs the specified seal. Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with products tested for that end use. Our part is installing the specified fire-rated sealant to its tested detail.
On a hospital site such as Nuffield Health Glasgow Hospital (1.4 miles west of Ruchill), fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits. Colleges such as Glasgow Kelvin College - West End Campus (to the south-west of Ruchill) add IT and services as courses change, and each new penetration through a fire-resisting wall needs sealing with the specified product.
Ruchill is about 2 miles north of Glasgow, in Glasgow. We cover commercial sites throughout Ruchill, for single jobs and planned programmes alike. 171 places across Glasgow fall within our area, Ruchill among them.
We cover the G20, G22 and G23 postcode districts. For a building on Firhill Road, Balmore Road and Hillend Road or nearby, send details and we will quote for service penetrations. Close to Ruchill, our area also takes in Lambhill (1 mile north), High Ruchill (1 mile west), North Kelvinside (1 mile south-west), Hamiltonhill (1 mile south-east) and Possilpark (1 mile east). A short drive away, we cover Calton (3 miles south-east), Langside (4 miles south), Yoker (4 miles west), Mount Florida (4 miles south), Hillpark (5 miles south) and Shawlands (4 miles south).
Around Ruchill
Around Ruchill, our work takes us to commercial buildings near Glasgow University Library, College of Piping and The Crosslands pub. For rail, the closest station is Possilpark & Parkhouse station, roughly 0.5 miles north-east. Nearby you’ll also find Chinatown (1.3 miles south) and Scottish Jewish Archives Centre (1.4 miles south). The countryside around Ruchill includes Bardowie Loch and Lenzie Moss.