Vidlin expansion joint sealing
We carry out expansion and movement joint sealing in walls, decks and floors in Vidlin and the surrounding area. Send details for a fixed quote.
- Damp inside where a wall movement joint has failed
- Layers of sealant in a movement joint
- Movement joints with split or torn sealant
Need expansion joint sealing in Vidlin?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
How we handle expansion joint sealing in Vidlin
Internal floor joints take trolleys, pallet trucks and forklifts. Unsupported edges break up under wheels, so the right filler or sealant for the traffic and movement matters. If the arrises are already broken, we will say so before sealing. We work on cladding panel joints, precast concrete panel joints and car park decks and ramps, and what we’re called in for most is rain penetration at brick or block movement joints and sealant pulling off the joint face. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, in Vidlin it comes down to the same thing: failed joints cut out, faces prepared and the right sealant laid to the right depth.
For floor or movement joints around smaller places like Vidlin, we plan to finish in one visit where we can. Send photographs, joint widths and details of the traffic first.
Every job we finish is backed by a 12-month workmanship guarantee, in Vidlin as everywhere else we work. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Location
- Vidlin (ZE2)
- Region
- Shetland Islands
- Cover
- A 12-month guarantee
- Price
- A fixed quote before we start
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Traffic, movement and joints around Vidlin
The sea is no more than about 1 mile from Vidlin. Coastal yards and decks give their joints salt and wet weather to deal with, not just wheels, so it pays to keep them sealed. Vidlin is on Scotland’s drier eastern side. Frost and winter road salt still work into open joints in car parks and yards. Autumn is a sensible time to seal them.
Around Vidlin, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Vidlin is in the Shetland Islands. Any commercial site in Vidlin is covered. Vidlin is one of 63 places in the Shetland Islands on our list for movement joints.
Work on movement joints is covered throughout ZE2, for business premises of every kind. Just outside Vidlin, we also work in Dury (4 miles south), Hamister (4 miles east), Voe (4 miles west), Symbister (4 miles south-east) and Sandwick (4 miles south-east). Remote and island addresses take more planning, from travel and ferries to the weather, so mention the location when you speak to us on 01277 525 020 or email drawings and photos.
Landmarks near Vidlin
Other landmarks nearby include The Cabin Museum (1.5 miles south-west). Open spaces near Vidlin include Kirkhouse Loch and Setter Hill.
Different surfaces, different methods
Podium joints
On podiums, the joint can belong to a larger waterproofing detail. Where the specification calls for sealant, we reseal, and tell you if the problem looks like the waterproofing below.
Concrete and precast panel joints
Joints between precast panels open and close with temperature and loading. We use a sealant classed for the movement, laid over backing to depth.
How the quote is worked out
The price varies from site to site. It mainly depends on:
- Distance, for remote addresses
- Backing rod, priming and other preparation
- The product specified
- Removal of failed or old sealant
The product called for affects the cost, as does the preparation each joint needs, from cutting out to priming and backing rod. Access, phasing and site requirements come into it too.
What we need to price the job
A good diagnosis starts with the right details. Tell us:
- Where the site is, with the postcode
- Drawings or a marked-up plan, if available
- A wide shot and a close-up of the area
- Your programme or deadline
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, ring 01277 525 020 or send details through our quote form.
How a job runs
Where the site stays busy, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then reopened once the sealant allows before the next one starts. For a building near Vidlin, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- We look at the joints, their width and how they’ve failed.
- A fixed quote follows, naming the sealant and its movement class.
- The failed seal is removed and both faces are cleaned until sound and dry, flagging any broken edges that need repair before sealing.
- Closed-cell backing rod is set to depth, or bond-breaker tape in shallow joints.
- After any primer the maker requires, the bead is applied and tooled so it grips two sides only.
- Finished joints are checked and backed by our 12-month guarantee.
What we need from you
- Point out any areas we must not close
- Arrange parking or a loading space
- For older buildings, check the asbestos register before work
Quotes
We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To start the process, speak to us on 01277 525 020 or send details through our quote form.
Read more
Signs you need expansion joint sealing in Vidlin
The edges of the material can fail rather than the sealant. Weak or crumbling concrete, brick or render edges give the sealant nothing sound to grip so edge repair has to come before resealing.
These are often picked up first by site or facilities staff:
- Weathered movement joint sealant that no longer flexes
- Movement joints with split or torn sealant
- Sealant peeling off one face of the joint
- Rain penetration at brick or block movement joints
Once a joint near Vidlin opens up, grit and water get in and the edges start to break; we’ll tell you if the edges need repairing first.
What your quote should include
- Will RAMS and insurance details be available?
- How they’ll work around occupants
- Are they CHAS accredited or on Constructionline?
- Will failed sealant be removed rather than covered?
Questions we are asked in Vidlin
Must our site in Vidlin stop work while the joints are done?
Typically not: we work in sections and hand each one back once it has cured. We agree the sequence and timings with you before we start.
Is Vidlin inside the area you cover, given it’s on an island?
Yes. Our area covers all of Scotland, cities, towns and islands alike, and that includes island locations such as Vidlin. We group island work where we can and plan around the crossings.
Can you fit around our working hours?
Mention the site’s hours and access windows in your enquiry, and we will schedule the work to suit. Our office runs Monday to Friday, 8am until 5pm.
Are your applicators CSCS-carded?
Yes. Should the site need card details in advance, tell us and we’ll confirm them with the quote.
Is it fine to apply new sealant on top of old?
No. We cut the old material out and clean the joint back before sealing, since fresh sealant will not bond reliably to aged material.
What happens if it rains on the day?
Outside work depends on conditions because a damp or frozen joint won’t take a proper bond. Indoor joints can typically carry on regardless.
Can you work on car park ramps and decks?
Yes. Let us know the opening hours and which levels or bays have to stay available, and we’ll plan the phasing around it.
Leave it or put it right?
A like-for-like reseal of a joint that keeps splitting rarely lasts. If the joint is too narrow or the product wrong for the movement, it needs a different approach, and we’ll say so before quoting. Around smaller places like Vidlin, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Early resealing prevents it.
A quote for movement joints depends on how many there are, their condition and the access, plus any specification you’re working to. Ask us for a fixed quote.
Why choose Mastic Doctor in Vidlin
- CSCS-carded applicators
- A fixed quote before work starts
- Failed material removed, not covered up
- CHAS accredited contractor
Commercial clients in Vidlin
Building owners and managing agents use us on sealant work across single buildings or whole portfolios around Vidlin. One quote can cover more than one site, which keeps the paperwork simple.
FMs need a contractor who is easy to get on site. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.