Floor Joint Sealing in Kemptown
Our CSCS-carded applicators take on floor joint sealing and filling in warehouses, factories and industrial units in Kemptown. Send details for a fixed quote.
- Joint fill separating from the concrete
- Drivers complaining about joints on a route
- Failing joints at loading bays and dock doors
Floor joint sealing across Kemptown
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
How we handle floor joint sealing in Kemptown
Open joints take a beating from forklift and pallet-truck wheels. Every pass chips at the bare concrete edge until a crisp saw cut becomes a wide, broken groove. Filling the joint properly gives the edges back their support, which is kinder to trucks, loads and operators. If you are dealing with flexible sealant torn out by wheels and a gap opening alongside old joint filler, we can put it right, whatever the surface. Whoever orders the work in Kemptown, the brief is typically the same: a clear scope, tidy work and joints that don’t fail again.
Around Kemptown, most floor and movement joint jobs are single buildings or yards, so we gather photographs and measurements first. Getting widths, depths and traffic details up front means one visit, not two.
What our 12-month guarantee covers is the way we did the job: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Place
- Kemptown (BN2)
- Wider area
- Brighton and Hove
- Cover
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Our process
Before any cutting starts, the area is protected: masking tape along the joint edges and sheeting over anything nearby. On site, the work usually takes between a day and a number of days, set by the joint lengths, the edge condition and the phasing you need, and we clear our waste as we work. Several jobs near Kemptown can be grouped on one trip. Tell us your site hours and we’ll plan around them.
- We agree the traffic routes and phasing with your site team.
- Any joints with broken edges are flagged before work starts.
- We clear each run back to clean concrete.
- We fill the joints with the agreed product, finished level.
- Each area is handed back when ready for traffic.
Before we start on site
- Point out any areas we must not close
- For older buildings, check the asbestos register before work
- Make sure the joints can be reached
Getting a fixed quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. The first step is to speak to us on 01277 525 020 or email a schedule or drawings with what you know.
Read more
Places near Kemptown
More services for Kemptown
Commercial clients in Kemptown
Facilities managers want contractors who arrive with the paperwork sorted. Tell us what site paperwork you need, such as RAMS, an insurance certificate or CSCS details, and we will confirm with the quote.
When you manage a building on behalf of an owner, you need clear quotes and clear reporting. You get a fixed quote, an agreed scope and a walk round at the end, plus a 12-month guarantee.
What we are called out for in Kemptown
Joints near dock doors see colder air, rain blown in and water off vehicles, as well as the tightest turning loads. They are often the first on a site to break down.
Common reasons buildings call us in:
- Brittle joint filler breaking up
- Sealant pulled out along a truck route
- A rough ride across broken joints
- Saw-cut joints left open and packed with grit
For an estate such as Eye Hospital, less than half a mile to the north-west of Kemptown, the joints in ramps, decks and long building elevations all need attention over time.
Questions to ask before you book
- Their approach to joint depth and backing
- Proof of insurance
- What the guarantee covers, and for how long
- Whether primer will be used where the manufacturer specifies it
Leave it or put it right?
While the arrises are intact, filling a joint is straightforward. Left until they break, it needs an edge repair before any filling can start which means more downtime in that zone. Sealant hardens, cracks and loses grip with age, UV and movement. Renewing it in good time keeps the building weathertight.
Pricing floor joints depends on quantities, condition and access, and any specification that applies. Call for a quote.
Why appoint us
- Health and safety: CHAS accredited
- One number for every site we cover
- Our applicators hold CSCS cards
- Workmanship guaranteed for 12 months
See our cost guide or how we’re accredited.
FAQs: Kemptown
Is Kemptown too far out for you?
No. Small places get the same service as large ones. London and every South East county are within our area. Where we can, we group nearby jobs to make the most of each trip.
Does a coastal location like Kemptown affect which sealant is used?
It can, yes: buildings near the sea take more wind-driven rain, and salt in the air nearer the shore. We check the specified product suits the exposure and pay close attention to preparation.
Will your applicators have CSCS cards?
Yes. We use CSCS-carded applicators, as many construction sites ask for.
What information helps you price floor joint sealing?
Use our quote form, or email photographs and a plan and tell us what runs on the floor. A fixed quote follows with the product and phasing set out.
Are you fully insured?
Yes. We’re fully insured, and the certificate can go with your quote.
Can the sealant be colour-matched?
That depends on the product. Some ranges offer many colours, others very few, so the available colours are confirmed with the quote.
Can you send site paperwork?
Requirements differ from site to site, so list what you need, whether RAMS, insurance or CSCS details, and we’ll confirm with the quote.
Warehouse floors and decks around Kemptown
The sea is no more than about 1 mile from Kemptown. Near the sea, external slabs, ramps and decks see salt air and driven rain as well as their usual loads, so a failed joint lets more in and the edges break up sooner. Kemptown has at least three named business or industrial parks inside a 3-mile radius. Floors, loading bays and yards on sites like these are where floor and movement joints work hardest.
At a retail site such as Churchill Square, 1.4 miles west of Kemptown, trolleys, cages and cars run over floor and slab joints all day. Campuses like University of Brighton Moulesecoomb Campus, 1.9 miles to the north of Kemptown, mix old and new buildings, with movement joints wherever they meet.
Kemptown is about 1 mile south-east of Brighton, in Brighton and Hove. Any commercial site in Kemptown is covered, for single jobs and planned programmes alike. We work across 29 places in Brighton and Hove, large and small.
We cover the BN2 postcode districts for floor joints. Among the streets we cover are Abbey Road, Manor Road and Eastern Road, and sites on any of them can send details for a fixed quote. Close to Kemptown, our area also takes in Whitehawk (1 mile north-east), Carlton Hill (1 mile north-west), Hanover (1 mile north-west), Brighton (1 mile north-west) and West Hill (2 miles north-west). Nearby towns on our patch include Brighton and Hove (3 miles north-west), Hove (3 miles west), Portslade (5 miles north-west), Aldrington (3 miles west), Withdean (3 miles north-west) and Hangleton (4 miles north-west).
What’s near Kemptown
We work on buildings around St John the Baptist Catholic Primary School, Queen's Park and Saint George's Inn, among other places. Kemptown’s nearest station is Brighton station, roughly 1.3 miles north-west of the centre. A little further out are Brighton Motor Museum (under half a mile south-west) and Churchill Square (1.4 miles west). The countryside around Kemptown includes Newmarket Hill and Whitehawk Hill.
When to bring in a specialist
Some joints are best left to specialists: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
A short, simple internal joint is often within reach of a maintenance team. Where it goes wrong is preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.
When something else is needed
Honesty saves time and money. Fresh joints won’t solve:
- A floor that rocks at the joints, which needs a structural fix
- Structural cracking in the slab
- Spalled arrises, which need an edge repair first
Not sure which it is? You can phone 01277 525 020 or email drawings and photos and we’ll tell you honestly.
What we seal
- Retail and showroom floors
- Saw-cut induced joints
- Loading bays
- Joints along racking aisles
- Construction joints
- Forklift and pallet-truck routes