Expansion Joint Sealing in Ollaberry
Need expansion joint sealing in Ollaberry? It’s simple: send details, get a quote, we seal, guaranteed.
- Water getting into the wall through a failed joint
- Debris jammed in movement joints
- Arrises breaking up along floor joints
Expansion joint sealing for businesses in Ollaberry
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Different surfaces, different methods
Concrete and precast panel joints
Precast and concrete panel joints move daily. We use a sealant classed for the movement, laid over backing to depth.
Joints between different materials
Hybrid or MS polymer sealants bond to many substrates. The choice depends on the substrates and how much the joint moves.
How we handle expansion joint sealing in Ollaberry
The seal is what lets a movement joint do its job. When the sealant splits or lets go, the gap fills with dirt and water, the joint can’t close properly and its edges begin to crumble. Resealing at the first signs of failure is far cheaper than repairing the material either side. We work on car park decks and ramps, cladding panel joints and podiums and floor movement joints, and the usual reasons a site gets in touch are leaks through car park deck joints onto the level below and water getting into the wall through a failed joint. Looking for mastic applicators who cover Ollaberry? Mastic Doctor has worked for contractors, FMs and building owners since 2005, with CSCS-carded applicators.
Travel to smaller places like Ollaberry is planned so the work is done in one trip where possible. Photos, approximate widths and what uses the floor help us bring the right materials.
Building owners and contractors get the same cover: twelve months on the work we carried out. It doesn’t extend to damage, faults in the building or work by others, and we’re upfront about that.
- Location
- Ollaberry (ZE2)
- Wider area
- Shetland Islands
- Guarantee
- 12 months on every job
- Quotes
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Also in Ollaberry
Floors, slabs and movement joints in Ollaberry
With the shore within about 1 mile, Ollaberry counts as a coastal location. Near the sea, external slabs, ramps and decks see salt air and driven rain as well as their usual loads, and edges left open tend to break up faster. Being on an island, Ollaberry means planning around ferry times as well as the weather. Photos and joint sizes help us load the right products.
Around Ollaberry, each joint gets a filler or sealant matched to what crosses it and how much it moves. A joint near Ollaberry that has lost its sealant lets in water and grit, and the edges suffer next.
Ollaberry is in the Shetland Islands. We send applicators to Ollaberry for movement joints, handled exactly as we handle every other area. Across the Shetland Islands, 63 places are covered, including Ollaberry.
Business premises anywhere in ZE2 are within our area. Close to Ollaberry, our area also takes in Hogaland (1 mile south-west), Urafirth (4 miles west), Sullom (5 miles south), Hillswick (5 miles west) and Scatsta (5 miles south). For island and remote sites, we plan travel and materials carefully, so include the location in your enquiry.
Around Ollaberry
Green spaces nearby include Burgan Loch and Hill of Skea.
General trades versus a specialist
There’s also the paperwork. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and we’ll confirm the paperwork you need with the quote.
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class.
When it isn’t the sealant
Our job is the joint, not everything around it. Sealant alone won’t deal with:
- Movement on a scale no sealant is meant to absorb
- Leaks coming from the membrane rather than the joint seal
- Proprietary pre-formed expansion joint systems
If you’re not sure, just call the office on 01277 525 020 or send photos by email and we’ll give you a straight answer before you book.
What we seal
- Car park decks and ramps
- Brickwork movement joints
- Cladding panel joints
- Blockwork control joints
- Precast concrete panel joints
- Podiums and floor movement joints
Common questions from Ollaberry clients
Do we have to stop operations in Ollaberry while the joints are sealed?
Rarely. Work is phased around your operations. We agree the sequence and timings with you before we start.
Does the sea air around Ollaberry change the choice of sealant?
It can. Coastal exposure works external joints harder than inland weather. We check the specified product suits the exposure and pay close attention to preparation.
How do you deal with asbestos in old sealant?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. Before we disturb old sealant in an older building, we ask to see the asbestos register or survey, and work stops until any suspect material has been tested. Removing asbestos is a job for asbestos specialists, not us.
Do you hold CHAS accreditation?
Yes. We’re CHAS accredited, we’re a Constructionline member and we use CSCS-carded applicators.
Is movement joint sealing guaranteed?
The workmanship is guaranteed for 12 months from sign-off. Regular sweeping and inspection help the joints last.
Do you work to architects’ specifications?
Yes. The specification and the manufacturer’s installation guidance are what we work to, and any queries are raised before we start.
Do you seal on top of existing sealant?
No. Failed sealant is removed and the faces cleaned back to sound, dry material first, since fresh sealant will not bond reliably to aged material.
Leave it or put it right?
A failed joint seal doesn’t mean the slab, panel or wall needs replacing. If the material either side is sound, a properly prepared reseal restores the joint. We will flag where edges need repair before sealing. Around smaller places like Ollaberry, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Resealing early avoids that.
Access often affects the price as much as the sealing: joints within easy reach take less time than ones that need access equipment. Tell us how the joints are reached and call for a quote.
Why choose Mastic Doctor in Ollaberry
- Fully insured, including public liability cover
- Our applicators hold CSCS cards
- One number for every site we cover
- Products installed to the manufacturer’s instructions
Read our cost guide or our accreditations.
On site: what to expect
Before we leave any area, we remove the tape, clean down and inspect every joint with your site contact. Where the sealant needs time to cure before use, we tell you and sign the area. For a building near Ollaberry, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We look at the joints, their width and how they’ve failed.
- Next, we fix a price and confirm the sealant we propose for the movement.
- Old sealant and filler are cut out and the joint faces cleaned back to sound material, flagging any broken edges that need repair before sealing.
- We control the depth with backing rod or, in shallow joints, bond-breaker tape.
- Where the maker calls for primer, it’s applied first, then the bead goes in and is tooled to a concave finish.
- We check every joint before sign-off, and the work carries our 12-month guarantee.
Getting the site ready
- Have the specification and drawings to hand
- Clear stock, furniture or equipment away from the joints
- Tell us your opening times and when work is allowed
Getting a fixed quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.
Related advice
How the quote is worked out
To price the job, we consider:
- Joint width, depth and condition
- Any access equipment needed
- The total length or number of joints
- Location, for remote and island sites
We don’t publish prices, since every building and every scope is different. For a fixed figure, call for a quote.
What we need to price the job
Good information means a firmer quote. When you get in touch, include:
- Rough lengths or quantities, or drawings if you have them
- Your programme or deadline
- Photos of the joints, close up and from further back
- The site address and postcode
For a fixed quote, phone 01277 525 020 or email a schedule or drawings, telling us the site location and the nature of the job. Our quote form is another easy route.