Floor Joint Sealing in Scalloway
Floor joint sealing and filling in warehouses, factories and industrial units throughout Scalloway and nearby, carried out by CSCS-carded applicators. Fully insured and CHAS accredited.
- Open saw cuts full of debris
- Joint fill separating from the concrete
- Grimy joint lines spoiling a showroom floor
Floor joint sealing for businesses in Scalloway
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Floor joint sealing in Scalloway
Forklifts and pallet trucks are hard on open joints. Every pass chips at the bare concrete edge, and over time a neat cut turns into a ragged channel. A properly filled joint carries the wheel over and protects both arrises. It also smooths the route for drivers and stock. We work on joints along racking aisles, loading bays and forklift and pallet-truck routes, and the failures we’re asked to look at most are soft sealant dragged out of trafficked joints and open saw cuts full of debris. Searching for sealant specialists in Scalloway? We’ve been sealing commercial buildings since 2005, CHAS accredited and a Constructionline member.
For floor or movement joints around smaller places like Scalloway, we plan to finish in one visit where we can. Send photographs, joint widths and details of the traffic first.
A 12-month guarantee applies to all our work. If an installation problem shows up, speak to us on 01277 525 020 or email the details over and we will arrange a return visit.
- Location
- Scalloway (ZE1)
- Wider area
- Shetland Islands
- Cover
- A 12-month guarantee
- Quotes
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
What we’re called out for in Scalloway
Unfilled joints soon pack with grit, shrink-wrap scraps and pallet splinters. That debris is hard and levers at the edges as wheels pass, speeding up the damage.
What tends to prompt an enquiry:
- Scruffy, dirty joint lines on a shop or showroom floor
- Joint edges breaking up under truck wheels
- Joint fill separating from the concrete
- Loading bay joints breaking down
Around Scalloway, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Before you book anyone
- Health and safety accreditation such as CHAS
- How they’ll work around occupants
- How long is the guarantee, and what does it include?
- Proof of insurance
FAQs: Scalloway
Is Scalloway inside the area you cover, given it’s on an island?
Yes, Scalloway is within the area we cover. We work across every Scottish council area. We group island work where we can and plan around the crossings.
Can you work on a hospital site such as Gilbert Bain Hospital?
Yes. Healthcare sites are among the places we work. Each area is agreed with the ward or department and the estates team in advance.
What do you need from us to quote?
Send details through our quote form or by email, with the traffic on each area. A fixed quote follows with the product and phasing set out.
How long before trucks can use the joints?
Each product has its own cure time and cooler floors take longer. Phasing is planned with that in mind.
How many days will you need on site?
It depends on the scope, though a typical visit typically takes between a day and a number of days, set by the joint lengths, the edge condition and the phasing you need. Larger or phased jobs take longer, and we will give you a timescale with the quote.
Why has the filler pulled away from one side?
Young concrete carries on shrinking for a long time and a stiff filler can separate down one side. A top-up normally puts it right.
Can you fill joints where the arrises have spalled?
We check the edges as part of the survey. Damaged edges are flagged up front, so nothing is filled that won’t hold.
What affects the price in Scalloway
What shapes the price:
- How much existing material needs removing
- Phasing around occupants
- How much there is to seal
- Access and working height
Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
Sending details for a quote
For an accurate fixed quote, we need a clear picture of the site. Useful things to include:
- Your programme or deadline
- The product your specification calls for
- Access details, including height
- The type of building and who uses it
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Send what you have, and we will arrange a site visit if anything is unclear.
How a job runs
We bring the products specified for the job, along with primers and backing rod. Any old material is cut back to clean, sound faces, primer goes on where the manufacturer specifies it, and the sealant is tooled off neatly. For work around Scalloway, we aim for one trip, so photographs, sizes and a full list matter. External joints need a dry spell as well.
- We agree the traffic routes and phasing with your site team.
- We point out joints whose edges need repairing first.
- We clear each run back to clean concrete.
- The chosen filler or sealant goes in flush with the slab.
- You get a time for each zone to reopen.
Before we start on site
- Move anything stored against the joints
- Point out any areas we must not close
- Have the specification and drawings to hand
Quotes
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or give us a call on 01277 525 020 or send details through our quote form to discuss it first.
Advice
What we can’t put right
Being straight saves everyone time. New sealant won’t cure:
- Joint edges that have already broken away, which need repairing before filling (we will tell you if so)
- A floor that is out of level for the racking or trucks
- Slab panels that rock or move under load
Not sure which it is? You can ring 01277 525 020 or send photos by email and we will tell you honestly before you book.
What we seal
- Construction joints
- Forklift and pallet-truck routes
- Joints along racking aisles
- Loading bays
- Saw-cut induced joints
- Retail and showroom floors
Warehouse floors and decks around Scalloway
With the shore within about 1 mile, Scalloway counts as a coastal location. Near the sea, external slabs, ramps and decks see salt air and driven rain as well as their usual loads, which is why split joints are worth sealing before the edges deteriorate. Scalloway is on Scotland’s drier eastern side. Cold winters and gritting are hard on any yard or deck joint left open. Sealing them before winter limits the damage.
Hospitals like Gilbert Bain Hospital (to the east of Scalloway) have multi-storey or surface car parks whose joints carry vehicles round the clock.
Scalloway is in the Shetland Islands. Scalloway sits inside our coverage, with the same fixed quotes and 12-month guarantee as everywhere else. We work across 63 places in the Shetland Islands.
Work on floor joints is covered throughout ZE1, whatever the building. If your site is on Main Street, Craigpark Road and Meadowfield Road or close by, send details and we’ll quote for floor joints. You will find Scalloway on or near the B9074. Just outside Scalloway, we also work in Gulberwick (2 miles east), Hamnavoe (3 miles south-west), Veensgarth (3 miles north-east), Sound (4 miles east) and Toogs (4 miles south-west). As one of the bigger centres in the Shetland Islands, Scalloway has a broad mix of commercial, public and industrial buildings. For island and remote sites, we plan travel and materials carefully, so the full address helps from the start.
Near you in Scalloway
Locally, jobs take us to sites close to Fisherman's Arms, among other places. A little further out are Castle Holm (4.9 miles north) and Gilbert Bain Hospital (4.3 miles east). Open spaces near Scalloway include Hill of Berry and Loch of Burwick.
Different surfaces, different methods
Saw-cut induced joints
Sawn joints make up most of the joint length in a typical industrial floor. Each one is cleaned out and filled to the specified depth, finishing flush with the slab.
Flexible floor sealants
Polyurethane sealants suit floor joints with larger movement. They don’t hold the arrises up as firmly as a semi-rigid fill, so they suit lighter traffic or movement joints.
Owners, agents and contractors
Whether you are a managing agent, a property factor or an owner’s representative: send details, get a fixed quote, we seal, guaranteed. Keys, access and contacts can be agreed in advance.
Hospitality, education, healthcare, office and retail clients come to us directly as well. The work is planned around how the building runs, so the building keeps working while we do.