
Fire-rated sealing and fire stopping in Hilton, Highland
Planning work on a service penetration in Hilton? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Service penetrations left open after M&E works
- Unsealed joints where partitions meet the slab
- Builders’ foam or ordinary silicone in compartment walls
Need fire stopping in Hilton?
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Common questions from Hilton clients
Can you work on a hospital site such as Lawson Memorial Hospital?
Yes. Healthcare sites are among the places we work. Before anything starts, the estates team agrees permits, inductions and infection-control measures with us.
Do you work on fire-rated sealing in hotels in Hilton?
Yes, where fire-rated sealant is the specified product. We match the product to the wall or floor and the services, and say if something other than sealant is needed.
Do you cover Hilton?
Yes. We cover Hilton, and you can give us a call on 01277 525 020 or email a schedule or drawings to get started.
Can the sealant be colour-matched?
In many cases, yes. Sealants are made in a wide range of standard colours, and matching to RAL references or nearby finishes is commonly requested. We’ll confirm the colours available for the specified product.
Do you hold CHAS accreditation?
Yes. We are CHAS accredited and a Constructionline member, which helps with supplier vetting.
Is it fine to apply new sealant on top of old?
No. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
Can you handle several sites?
Yes. A group of buildings can go on one quote, and you deal with one contact throughout.
How we handle fire stopping in Hilton
No fire sealant works on its own: the evidence covers a specific product, wall or floor type, service, gap, depth and backing. Before we seal anything, we check the opening against the detail it is meant to follow. If you have unsealed openings around new pipes and cables and improvised or mixed-product fire seals, we can put it right, on small duct penetrations where the tested detail allows, pipe penetrations and joints between fire-resisting walls and floors alike. Most enquiries from Hilton start with one failed joint and grow into a wider look at the building: we look at the rest while we’re there and tell you what we find.
Travel to smaller places like Hilton is planned so every penetration is sealed on one trip. Photos of the gaps, the services and the wall or floor type help us bring the right products.
We sign every job off with a 12-month guarantee. It’s a plain promise: if the work we did fails within twelve months, we return to fix it.
- Place
- Hilton (IV25)
- Wider area
- Highland
- Guarantee
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Last updated
- 3 November 2026

Fire-rated sealing for Hilton buildings
In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, using products tested for the way they’re used. We install fire-rated sealant to that tested detail where it is specified. There are a number of hotels within about 2 miles of Hilton. In hotels, bedroom and corridor walls are normally fire-resisting, so services added in a refit need sealing with the specified product.
Hotels like Burghfield House Hotel, 1.2 miles to the south of Hilton, are refurbished in phases, and each phase can open up compartment walls. Holiday works at schools like Dornoch Academy often leave service openings to seal before pupils return.
Hilton is about 22 miles north of Nairn, in Highland. If you are looking for fire stopping in Hilton, we can help. Hilton is one of 256 places in Highland on our list.
Postcode districts covered here: IV25 for service penetrations. For a building on Birchwood and Embo Street or nearby, send details and we’ll quote for service penetrations. Just outside Hilton, we also work in Embo (1 mile north-east), Dornoch (1 mile south), Camore (2 miles south-west), Skelbo Muir (2 miles north-west) and Littleferry (3 miles north). A short drive away, we cover Tain (6 miles south), Invergordon (15 miles south), Brora (10 miles north-east), Cromarty (15 miles south) and Balintore (11 miles south). Where a site is remote or on an island, travel and materials need planning ahead, so the full address helps from the start.
Near you in Hilton
Around Hilton, our work takes us to commercial buildings near Pilgudy Holiday Park, among other places. A little further out are Historylinks Museum (1.3 miles south) and Lawson Memorial Hospital (5.3 miles north). Green spaces nearby include Loch Tarbhaidh and Loch Fleet National Nature Reserve.
Places near Hilton
More services for Hilton
Surface by surface
Masonry and concrete
Openings through concrete vary from tidy cores to rough break-outs. The gap is measured at the widest point against the detail’s limits.
Linear joints
Head-of-wall joints often have to absorb slab deflection. We use the product and backing the detail names for that movement, along the full length of the run.
After the work
Problems stay small when the joints are checked regularly. In particular:
- Include service cupboards in routine inspections
- Leave fire sealant to cure fully before covering it
- Foam or ordinary sealant is never a fire-seal repair
- Put resealing into every M&E and fit-out package
Never top up a fire seal with foam, ordinary silicone or filler. Repairs need the same product and detail as the original unless the designer specifies otherwise.
The simplest way to keep compartment walls intact is to plan fire stopping into every job that crosses them. Then the seal goes in while the area is open, not months later.
How a job runs
Where the site stays busy, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed before the next one starts. For a building near Hilton, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- Each opening is checked for wall or floor type, service, gap and depth.
- Foam, ordinary sealant and debris come out first.
- The specified backing and sealant go in to depth and are finished neatly.
- We tell you about openings that need a different product.
Preparing the site
- Clear stock, furniture or equipment away from the joints
- Send asbestos survey details if the building is pre-2000
- Warn occupants and staff about the work
Quotes
To get a fixed quote, call the office on 01277 525 020 or email drawings and photos with the site address and an outline of the work. You can also send details through our quote form.
Related advice
Cost factors for service penetrations
These are the things that shape the price:
- How much there is to seal
- Backing rod, priming and other preparation
- Any access equipment needed
- Location, for remote and island sites
Access often affects the price as much as the sealing: easy-to-reach joints are quicker than those that need equipment to get to. Tell us how the joints are reached and call for a quote.
What to include in your enquiry
A good diagnosis starts with the right details. Let us know:
- Anything awkward about access or site hours
- The product your specification calls for
- Drawings or a marked-up plan, if available
- Whether the building will be occupied during the work
Let us know the site, the scope and your timescale, and a fixed quote will follow. To get it moving, give us a call on 01277 525 020 or email a schedule or drawings.
Why act early in Hilton
A seal that doesn’t match its tested detail gives false comfort. The fix is to remove it and reinstall to the detail, so it makes sense to get it right first time. Exposed buildings in Scotland take a lot of weather, and for a smaller place like Hilton, a repair visit takes planning, so it’s better to act early.
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we will put a fixed figure on it.
Why us?
- A Constructionline member, so easy to vet
- CSCS-carded applicators
- Commercial sealant work since 2005
- CHAS accredited contractor
Read how commercial sealant jobs are priced or how we’re accredited.
Do you need fire stopping in Hilton?
Damage plays a part too. Seals get knocked during maintenance, cut back to add a cable or pulled out when services are swapped and the opening isn’t always resealed.
Site and facilities staff are often the first to spot these:
- Fire-stopping items raised at inspection or handover
- Expanding foam used as fire stopping
- Improvised or mixed-product fire seals
- Openings found when ceilings come down for a refit
Wherever services are added at a hospital such as Lawson Memorial Hospital (to the north of Hilton) the compartment line has to be made good with the specified product.
What to look for in a quote
- The terms of the workmanship guarantee
- Will CSCS-carded applicators be on site?
- Their pre-qualification and accreditations
- Do they follow the manufacturer’s priming guidance?