Fire stopping in Freshwater
Commercial sealant work in Freshwater for contractors, FMs and building owners: fire-rated and intumescent sealing of service penetrations and linear gaps, with a fixed quote first.
- Unsealed joints where partitions meet the slab
- Fire seals cut back for extra cables and never reinstated
- Expanding foam used as fire stopping
Need fire stopping in Freshwater?
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Cost factors for service penetrations
Each job is priced on its own details. The things that drive the figure:
- Phasing around occupants
- How much existing material needs removing
- Induction, permit and paperwork requirements
- Which sealant the job calls for
There’s no price list, because the scope varies so much from one building to the next. For a fixed figure, call for a quote and we will price your job on its own details.
Before you send an enquiry
For an accurate fixed quote, we need a clear picture of the site. Send us:
- Photos of the joints, close up and from further back
- The type of building and who uses it
- Any dates the work must fit around
- Rough lengths or quantities, or drawings if you have them
Photos, drawings or a schedule of the joints are often enough for a fixed quote. Where a site visit makes more sense, we will arrange one.
Fire stopping in Freshwater, done properly
Opened ceilings and riser doors often reveal service openings nobody sealed. If a specification already covers those walls and floors, we can reseal to it. Where there isn’t one, the designer or fire engineer needs to set one first. If you have fire sealant pulled out of the opening and penetration schedules that need working through, we can help, on small duct penetrations where the tested detail allows, joints between fire-resisting walls and floors and linear gaps at wall heads alike. Facilities teams, main contractors and managing agents in Freshwater tend to want the same three things: a fixed quote, no surprises on site and a 12-month guarantee behind the result.
Converted and extended buildings around places like Freshwater can mix old and new construction, so it’s worth confirming the wall or floor type before choosing the seal. We match the product to the substrate and service, and say so if a collar, wrap or batt is the specified item.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Location
- Freshwater (PO40)
- Region
- Isle of Wight
- Guarantee
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Diagnose, treat, sign off
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. The work itself typically takes anything from one day to a planned run of visits, depending on the number of seals and the access, and we clear our waste as we work. For a job in Freshwater, the main thing is a clear picture of the work, so send photos of each area. A fixed quote follows.
- The specification and schedule come first, so we know which details apply.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
Before we start on site
- Share the asbestos register for older buildings
- Have the specification and drawings to hand
- Tell staff and tenants when we will be in
Ask for a quote
Quotes are fixed against the scope you send, so the cost is agreed before work starts. To ask for one, speak to us on 01277 525 020 or send photos by email.
Read more
Owners, agents and contractors
Hotels, schools, healthcare sites, offices and retail units book us directly too. The work is planned around how the building runs, so guests, pupils, patients or staff are disturbed as little as possible.
As a CHAS accredited contractor and Constructionline member, we make supplier vetting simple. Our insurance certificate can be sent along with the quote.
Places near Freshwater
What else we do in Freshwater
Why it’s worth doing now in Freshwater
Sealing behind the M&E trades area by area beats a sweep at the end. While the area is still open, every opening is easy to see and reach. In a smaller place such as Freshwater, getting a contractor back for a second visit takes time, so we’d suggest renewing all the joints that are going, not just the worst.
Whether it’s a single area or a whole estate, the same things set the price: scope, access, product and programme. Call for a quote, and you’ll have a fixed figure to work with.
Why appoint us
- One contact handling all your sites
- Health and safety: CHAS accredited
- Specification-led, product-correct work
- Fully insured
Take a look at how commercial sealant jobs are priced and how we’re accredited.
Site staff or a sealant specialist?
There’s also the paperwork. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and we’ll confirm the paperwork you need with the quote.
Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
What the job involves on each surface
Masonry and concrete
Core-drilled holes are neat; broken-out ones rarely are. Each gap is measured where it is widest so we know it sits within the tested range.
Drylining partitions
Plasterboard partitions are tested as a specific construction. We check that the product’s detail covers that partition type and board thickness first.
Common questions from Freshwater clients
Is Freshwater too small for you to travel to?
No. Places such as Freshwater are covered as much as the big towns. We work across Greater London and the South East. Send photos and a list of what needs doing, and we’ll plan the job to need as few trips as possible.
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Freshwater?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. The designer or fire engineer sets the specification, and we install the product to the manufacturer’s tested detail.
Are your applicators CSCS-carded?
Yes. If you need card details for site access, let us know and we’ll send them with the quote.
Do you take on small jobs?
Small jobs are welcome alongside larger packages. Send details for a fixed quote.
When can you be on site?
Give us your site hours and any access windows in your enquiry, and we’ll plan around them. Our office runs Monday to Friday, 8am until 5pm.
Is it fine to apply new sealant on top of old?
No. Sealing over old material is one of the classic causes of early joint failure, so it all comes out first.
Do you offer coloured sealant?
In many cases, yes. Sealants are made in a wide range of standard colours, and matching to RAL references or nearby finishes is commonly requested. We confirm what’s available for the specified product when we quote.
Service penetrations in Freshwater buildings
In England, Approved Document B covers fire stopping of openings and penetrations. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. Our part stays the same: the specified product, installed to its tested detail. A good number of hotels sit less than 2 miles from Freshwater. Hotels are divided into compartments, and refurbishments that add pipes and cables through bedroom and corridor walls leave gaps to close.
For a school such as All Saints Church of England Primary School, penetration sealing fits best at the end of the summer works. Older community buildings such as All Saints' Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification. Hotels like Albion Hotel (1 mile south-east of Freshwater) are refurbished in phases, and each phase can open up compartment walls.
Freshwater is about 5 miles south of Lymington, in the Isle of Wight. Our applicators travel to Freshwater for work on service penetrations. 125 places across the Isle of Wight fall within our area, including Freshwater. Our Southampton page has more on work in that area, about 17 miles away.
Anyone looking for fire stopping in PO40 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. We cover commercial and managed buildings on Dall Square, High Street and The Square. Close to Freshwater, our area also takes in Easton (1 mile south-east), Colwell (1 mile north-west), Norton Green (1 mile north), Afton (1 mile south-east) and Totland (1 mile west). Further afield, our area takes in Newport (10 miles east), Cowes (11 miles north-east), Shanklin (15 miles east), Ventnor (15 miles south-east), East Cowes (12 miles north-east) and Barton (10 miles east). For island and remote sites, travel and materials need planning ahead.
Around Freshwater
Recent enquiries here include premises near The Red Lion pub and the streets around them. Other landmarks nearby include Yarmouth Castle (1.9 miles north-east) and Ferguson Family Museum (0.7 miles north-east). Not far away are Lymington and Keyhaven Marshes Nature Reserve and Afton Down.