Fire-rated sealing and fire stopping in Yarbridge, Isle of Wight
Fire stopping in Yarbridge, backed by over 20 years in commercial sealing. Fully insured, with a 12-month guarantee.
- Damaged fire seals in risers and voids
- Builders’ foam or ordinary silicone in compartment walls
- Fire sealant pulled out of the opening
Need fire stopping in Yarbridge?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
What we can’t put right
A few problems need another trade or a different fix, and we point that out rather than sealing over them:
- Signing off or certifying a building’s fire stopping
- Fire doors, dampers or other fire safety equipment
- Designing or specifying fire stopping, which sits with the designer or fire engineer
Not sure which it is? You can call the office on 01277 525 020 or use the quote form and we will tell you honestly.
Joints and surfaces we work on
- Joints between fire-resisting walls and floors
- Cable penetrations
- Service gaps in risers
- Pipe penetrations
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
Fire stopping in Yarbridge, done properly
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind. We close the openings listed on your schedule, using the specified sealant and detail. If you are dealing with builders’ foam or ordinary silicone in compartment walls and improvised or mixed-product fire seals, we can help, whatever the surface. Searching for sealant specialists in Yarbridge? Mastic Doctor has worked for contractors, FMs and building owners since 2005, with CSCS-carded applicators.
Smaller places such as Yarbridge still have buildings with fire-resisting walls and floors: schools, halls, care homes and commercial conversions. If sealant is what the specification names, we install it around the services exactly as the maker’s detail sets out.
Work we carry out in the Isle of Wight comes with a 12-month guarantee. If an installation problem shows up, phone 01277 525 020 or send details through our quote form and we’ll arrange a return visit.
- Location
- Yarbridge (PO36)
- Wider area
- Isle of Wight
- Cover
- A 12-month guarantee
- Quote
- A fixed quote before we start
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Cost factors for service penetrations
Your fixed quote is built from the real scope. It takes account of:
- Distance, for remote addresses
- Phasing around occupants
- Induction, permit and paperwork requirements
- Joint width, depth and condition
The price depends on the quantity of joints, how much old material needs removing and how the joints are reached. Call for a quote when you are ready.
Details that help us quote
The more we know, the firmer the quote. Helpful details to send:
- Anything awkward about access or site hours
- Your programme or deadline
- What the building is and how it’s used
- The site address and postcode
Specifications, drawings and tender packages are welcome with any enquiry, and we will price the work to it. For smaller jobs, photos and a description will do.
Maintenance after handover
Regular inspection catches problems early. Specifically:
- Look above ceilings when tiles are lifted for other jobs
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Keep product data and details in the fire safety file
- Agree the fire-stopping specification before services go in
Once the seals are in, tell other trades they exist and must not be disturbed. Any seal cut back for a new service needs reinstating to its tested detail using the same product.
Regular walk-rounds of service areas are worth the time. Catching a damaged seal early keeps the fix small; found late, it can be one of many.
FAQs: Yarbridge
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Yarbridge?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Can you work at a site such as Spithead Business Centre, by Yarbridge?
Yes. Our area takes in Yarbridge and its surroundings, with estates and business parks such as Spithead Business Centre included. Send details of the unit and the work through our quote form for a quick quote.
How do you deal with asbestos in old sealant?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. Removing asbestos is a job for asbestos specialists, not us.
How much does the work cost?
Each job is quoted on its own details. For yours, call the office on 01277 525 020 or email us.
Can you handle several sites?
Yes. Multi-site work and planned programmes are a core part of the service, planned site by site to suit how each building is used.
What’s the quickest route to a quote?
The quote form is the simplest route, though you can also ring 01277 525 020 or email us. Photos, drawings or a joint schedule help us quote quickly.
Is any job too small?
Small jobs are welcome alongside larger packages. Send details for a fixed quote.
Other services in Yarbridge
Fire stopping in Yarbridge: the local picture
Approved Document B is the English guidance that covers fire stopping around openings and penetrations. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. Our part stays the same: the specified product, installed to its tested detail. A 2-mile radius around Yarbridge takes in a good number of hotels. In hotels, bedroom and corridor walls are normally fire-resisting, so services added in a refit need sealing with the specified product.
Office fit-outs on sites such as Spithead Business Centre (to the south-west of Yarbridge) add cabling and pipework through fire-resisting walls, and fire-rated sealant goes in where the specification calls for it. Older community buildings such as St. Mary's Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification. In a hotel such as Sandown Manor Hotel, 0.8 miles to the south-east of Yarbridge, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
Yarbridge is about 2 miles north-east of Sandown, in the Isle of Wight. Commercial clients in Yarbridge can call on us for service penetrations, as part of our coverage of the Isle of Wight. We work across 125 places in the Isle of Wight, from busy centres to rural villages. Sites around Portsmouth have their own page, roughly 10 miles from Yarbridge.
Work on service penetrations is covered throughout PO36, for business premises of every kind. For a building on New Road, Morton Road and Church Lane or nearby, we can quote for service penetrations. With the A3055 nearby, Yarbridge is straightforward for us to reach. We also cover Morton (1 mile south-west), Brading (1 mile north), Adgestone (1 mile west), Yaverland (1 mile south-east) and Sandown (2 miles south-west). Further afield, our area takes in Newport (7 miles west), Ryde (4 miles north), Cowes (9 miles north-west), Shanklin (3 miles south-west), Ventnor (6 miles south-west) and East Cowes (8 miles north-west). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you ring 01277 525 020 or send details through our quote form.
Near you in Yarbridge
Locally, jobs take us to sites close to Sandown Bay Academy, The Bugle Inn and The Bay Church of England School. For rail, the closest station is Brading station, roughly 0.5 miles north-east of the centre. Well-known places in the area include Arthur Webster Memorial Hospital for Children (3.1 miles south-west) and Sandown Castle (1.2 miles south). For a walk, there’s Brading Marshes RSPB reserve and Brading Down.
From enquiry to sign-off
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, primer goes on where the manufacturer specifies it, and each bead is tooled to a neat concave finish. Smaller jobs around Yarbridge can be grouped with others nearby. You’ll have a fixed quote before work starts.
- First we confirm the product and tested details named in the specification.
- We sort the openings by the detail each one needs.
- Old or wrong materials are cut out.
- Mineral wool or other backing is fitted where required.
- Fire-rated or intumescent sealant goes in around the services and is tooled off.
- Completed areas are checked with you, with the records agreed when we quoted.
Getting the site ready
- Confirm the product named in the specification
- Tell us which areas need to stay in use
- Move anything stored against the joints
Quotes
Let us know the site, the scope and your timescale, and we’ll put a fixed quote together. To get it moving, phone 01277 525 020 or email drawings and photos.
Advice
General trades versus a specialist
Site maintenance staff can often handle a short internal joint. Where it goes wrong is preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.
Certain joints really need a specialist: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
Work for main contractors and building owners
Agents, factors and owners’ representatives all follow the same route: send the details, accept a fixed quote, and we carry out and guarantee the work. Keys, access and contacts can be agreed in advance.
When you manage a building on behalf of an owner, clear figures and clear communication matter. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.