Fire stopping in Ravenscraig
Fire-rated and intumescent sealing of service penetrations and linear gaps across Ravenscraig, carried out by CSCS-carded applicators. CHAS accredited and fully insured.
- Open linear gaps along the top of fire-resisting walls
- Seals that don’t match their tested detail
- Seals disturbed by maintenance and left open
Fire stopping near Ravenscraig
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Fire stopping in Ravenscraig
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. New cable runs, replaced pipework and extra data routes all punch holes in compartment walls, often unnoticed. Those on your schedule are closed with the specified product. The enquiries we see most involve unsealed penetrations discovered above suspended ceilings and damaged fire seals in risers and voids, on pipe penetrations, linear gaps at wall heads and service gaps in risers. Searching for sealant specialists in Ravenscraig? Mastic Doctor has worked for contractors, FMs and building owners since 2005, with CSCS-carded applicators.
Around smaller places such as Ravenscraig, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
Every job we finish is backed by a 12-month workmanship guarantee, in Ravenscraig as everywhere else we work. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Where
- Ravenscraig (ML1)
- Wider area
- North Lanarkshire
- Guarantee
- 12 months on every job
- Price
- A fixed quote before we start
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Service penetrations in Ravenscraig buildings
The area within 2 miles of Ravenscraig holds a number of hotels. In hotels, bedroom and corridor walls are usually fire-resisting, so services added in a refit need sealing with the specified product. In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, and products should be tested for their end use. Our part is installing the specified fire-rated sealant to its tested detail.
At a college such as New College Lanarkshire - Motherwell Campus, which lies south of Ravenscraig, checking penetration seals after summer M&E works is good practice. For a unit at a centre such as Brandon Shopping Centre (0.9 miles west of Ravenscraig), penetration seals are worth checking after each shop fit.
Ravenscraig is about 1 mile south-east of Motherwell, in North Lanarkshire. Our applicators travel to Ravenscraig for work on service penetrations. Across North Lanarkshire, 100 places are covered, including Ravenscraig. Sites around Glasgow have their own page, roughly 13 miles from Ravenscraig.
Business premises anywhere in ML1 are within our area for service penetrations. Streets here include New Craig Road, Robberhall Road and Prospecthill Road. Sites close to Ravenscraig are covered too, including Motherwell (1 mile north-west), Airbles (1 mile south-west), Muirhouse (1 mile south), Netherton (2 miles south-east) and Wishaw (2 miles south-east). Further afield, our area takes in Cumbernauld (11 miles north), Coatbridge (5 miles north-west), Airdrie (5 miles north), Bellshill (3 miles north-west), Kilsyth (13 miles north) and Viewpark (4 miles north-west).
What’s near Ravenscraig
In Ravenscraig, that means premises near The Raven's Cliff pub and Duchess of Hamilton Park, among other places. For rail, the closest station is Shieldmuir station, roughly 1.1 miles south. Nearby you’ll also find University Hospital Wishaw (1.6 miles south-east) and Dalzell House (1.4 miles south). For a walk, there’s Strathclyde Loch and Baron's Haugh RSPB Reserve.
Ravenscraig: questions and answers
Can work at a site such as New College Lanarkshire - Motherwell Campus fit around teaching?
Yes. Tell us the term dates, vacation periods and access windows, and we’ll plan the work around them. Tell us which site documents you need, such as RAMS, our insurance certificate or CSCS details, and they’re confirmed with the quote.
Can you seal penetrations in a hotel in Ravenscraig after a refit?
Yes, to the specification and the product’s tested detail. It goes in to the manufacturer’s tested detail for the wall or floor and the services passing through, and we will tell you if the detail calls for a collar, wrap or batt instead.
Can you fit around our working hours?
The office is staffed Monday to Friday, from 8am until 5pm. Tell us your site hours and access windows and the work will be fitted around them.
Is your workmanship covered by a guarantee?
Yes, for 12 months. If our installation fails in that time, we return and fix it.
Can one quote cover more than one building?
Yes. A group of buildings can go on one quote, with one point of contact across South East England, Greater London and Scotland.
How long will the new sealant last?
There isn’t a single answer, since movement, weather, cleaning and use all affect it. Regular checks let you plan resealing before leaks or damage.
Can you quote from photos?
That depends on the size and complexity of the job. Simple work can often be priced from photographs, while larger or less clear jobs get a site visit first.
What we can’t put right
Part of a good diagnosis is knowing where sealant stops. We’ll tell you if the real problem is one of these:
- Plastic pipes whose detail calls for a collar or wrap
- Signing off or certifying a building’s fire stopping
- Reviewing a building’s overall fire safety
If you are not sure, just phone 01277 525 020 or email the details over and we will give you a straight answer before you book.
Surfaces we seal
- Cable penetrations
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
- Service gaps in risers
- Joints between fire-resisting walls and floors
- Pipe penetrations
Cost factors for service penetrations
There’s no standard rate for sealant work, since sites vary so much. What we look at:
- How much there is to seal
- Phasing around occupants
- The size and state of each joint
- Induction, permit and paperwork requirements
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we will put a fixed figure on it.
Before you send an enquiry
Good information means a firmer quote. Helpful details to send:
- Where the site is, with the postcode
- Any dates the work must fit around
- What the building is and how it’s used
- Specification clauses that apply
Pricing a project or setting a maintenance budget? We’ll quote against your scope and drawings you can plan around. If you have questions first, give us a call on 01277 525 020 or email the details over.
Keeping the joints sound
After handover, these steps help:
- Foam or ordinary sealant is never a fire-seal repair
- Look above ceilings when tiles are lifted for other jobs
- File the specified details where the next contractor can find them
- Ask which product is in place before decorating
Add risers, plant rooms and ceiling voids to routine fire-stopping checks. Watch for cracked sealant, new services with no seal and openings that have grown.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
Do you need fire stopping in Ravenscraig?
Fire stopping can get squeezed at the end of a programme, or done by whoever is on site. That is how unsuitable products and improvised details end up in compartment walls.
If one of these sounds familiar, it’s time for a closer look:
- Expanding foam used as fire stopping
- Snag lists that include open service penetrations
- Unsealed joints where partitions meet the slab
- Fire seals cut back for extra cables and never reinstated
Wherever services are added at a hospital such as University Hospital Wishaw, 1.6 miles south-east of Ravenscraig, the compartment line has to be made good with the specified product.
Questions to ask before you book
- How long is the guarantee, and what does it include?
- The named product and why it was chosen
- Who will actually carry out the work
- Will RAMS and insurance details be available?
Other services in Ravenscraig
Our process
We begin with a short walk round with whoever looks after the building, agreeing which joints are in scope, where to start and what must stay open. After that, any old or failed material is removed, each joint is prepared and the new sealant goes in. Where we can, we combine work around Ravenscraig with other jobs nearby, to make the most of each trip. Tell us how flexible your dates are.
- We read the specification, drawings or penetration schedule you send and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- We apply the specified sealant to the depth and around the services as the detail shows.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Getting the site ready
- Warn occupants and staff about the work
- Point out any areas we must not close
- Share your working hours and any access restrictions
Ask for a quote
To get a fixed quote, call 01277 525 020 or send details through our quote form. You can also send details through our quote form.
Advice
Why deal with it now?
It is cheaper to seal service penetrations as each services package finishes than to come back for them later. Openings are visible, access is open and nothing has to be taken down and each detail can be checked as we go. Buildings that aren’t in daily use, such as halls and seasonal premises, may let water in unnoticed, giving water time to get in. Resealing early avoids that.
Every site prices differently: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
What you get with us
- Joints cleaned back to sound surfaces
- Specification-led, product-correct work
- One contact handling all your sites
- CSCS-carded applicators
Take a look at how commercial sealant jobs are priced and our accreditations and insurance.