Fire Stopping in Longhope
Need fire stopping in Longhope? It’s simple: send details, get a quote, we seal, guaranteed.
- Snag lists that include open service penetrations
- Hidden openings found during inspections
- Openings left by services added after handover
Fire stopping in Longhope
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
How we handle fire stopping in Longhope
On a fit-out or refurbishment, we follow the services contractors floor by floor. We work from your penetration schedule or marked-up drawings and the specified product data. Tell us what records you need and we’ll confirm with the quote. If you are dealing with fire sealant pulled out of the opening and service penetrations left open after M&E works, we can put it right, on cable penetrations, linear gaps at wall heads and small duct penetrations where the tested detail allows alike. One point of contact handles commercial sealant work in Longhope from the first photographs to the final walk-round, whether it’s one building or several.
In smaller Scottish places like Longhope, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
Building owners and contractors get the same cover: twelve months on the work we carried out. Faults in the structure, damage and other trades’ work fall outside it, and we say so plainly.
- Location
- Longhope (KW16)
- Region
- Orkney Islands
- Cover
- A 12-month guarantee
- Quotes
- Quoted before any work starts
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Why act early in Longhope
Inspections and handover checks often pick up fire stopping. Finding unsealed or improvised openings late can hold up a programme, so earlier action pays back. Renewing every failing joint on one visit is the sensible approach for a place like Longhope. Send photos and we will quote for everything together.
We don’t publish prices, because the scope varies so much from one building to the next. For a fixed figure, call for a quote.
Why appoint us
- One number for every site we cover
- Failed material removed, not covered up
- Fixed quotes based on photos, drawings or a visit
- Work to your specification and the manufacturer’s guidance
Take a look at our cost guide and how we’re accredited.
Different surfaces, different methods
Small ducts
We seal around ducts only within what the tested detail covers. Dampers and ductwork systems themselves are outside our work.
Cables and cable bundles
Cable penetrations are frequently sealed with fire-rated sealant where the detail allows. Bundle size, cable type and the space between cables all matter and we work within those limits.
How a job runs
Before we leave any area, the masking comes off, the area is cleaned and every joint is checked, ready for your sign-off. Where the sealant needs time to cure before use, we tell you and sign the area. For a building near Longhope, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- Each opening is checked for wall or floor type, service, gap and depth.
- Unsuitable material is removed and the opening cleaned first.
- Backing and fire-rated sealant are installed to the detail and tooled.
- We tell you about openings that need a different product.
Getting the site ready
- Flag any permit to work we’ll need
- Explain the parking and delivery arrangements
- Share the asbestos register for older buildings
Get a fixed quote
Send details, get a quote, we seal, guaranteed: that’s how every job runs. To take the first step, call the office on 01277 525 020 or email the details over.
Read more
When it isn’t the sealant
We seal joints; we don’t mend everything behind them. On its own, sealant can’t deal with:
- Designing or specifying fire stopping, which sits with the designer or fire engineer
- Reviewing a building’s overall fire safety
- Issuing fire ratings or certificates for seals
If in doubt, call 01277 525 020 or send details through our quote form and we will say what we think before you book.
Where we work in Longhope
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
- Pipe penetrations
- Service gaps in risers
- Cable penetrations
- Joints between fire-resisting walls and floors
Aftercare for building managers
To get the most from the new sealant:
- Leave fire sealant to cure fully before covering it
- Get seals inspected before ceilings and boxing close
- Keep product data and details in the fire safety file
- Treat an open penetration as a priority repair
New services after handover are a common way fire stopping gets breached. A short check at the end of each job saves a long hunt later.
Looking at service areas on a regular cycle pays off. Catching a damaged seal early keeps the fix small.
What else we do in Longhope
Where services cross fire walls in Longhope
Island jobs, Longhope among them, are planned around the ferry and the forecast. With the specification and photographs of the openings, the right fire-rated products travel with us. In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, and products should be tested for their end use. Our part is installing the specified fire-rated sealant to its tested detail.
Buildings near Longhope get the fire-rated product that’s specified, installed to its tested detail. In a hotel such as Stromabank Hotel, 1 mile to the south-east of Longhope, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
Longhope is about 15 miles south-west of Kirkwall, in the Orkney Islands. We cover Longhope, with the same fixed quotes and 12-month guarantee as everywhere else. Longhope is one of 51 places in the Orkney Islands on our list for service penetrations.
If you need fire stopping in KW16, the process matches everywhere else we work: details, then a fixed price, then sealing and a 12-month guarantee. Sites close to Longhope are covered too, including Lyness (2 miles north), Scarfskerry (11 miles south), Rattar (11 miles south), Brough (12 miles south-west) and Canisbay (12 miles south). Where a site is remote or on an island, we plan travel and materials carefully, so the full address helps from the start.
Near you in Longhope
Other landmarks nearby include Longhope Lifeboat Museum (1.5 miles south-west). Green spaces nearby include Binga Fea and Loch of Greenhill.
Questions about Longhope
Which Scottish guidance covers penetration seals in Longhope?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. Design sits with the designer and the verifier; installation to the tested detail is our part.
Will you design a fire-stopping scheme for our building in Longhope?
No. The designer or fire engineer sets the detail and building control accepts it. We install fire-rated and intumescent sealant around service penetrations and linear gaps where it is specified, to the manufacturer’s tested detail.
Can you send site paperwork?
Each site asks for different documents, so list what you need, whether RAMS, insurance or CSCS details, and we’ll confirm with the quote.
What’s the quickest route to a quote?
It works in four steps: send details, get a quote, we seal, guaranteed. Step one needs little more than photos and a postcode.
Can weather delay the job?
It can, when the joints are outside. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so external work may be moved if conditions aren’t right. Internal work is far less affected.
Can you fit around our working hours?
The office is staffed Monday to Friday, from 8am until 5pm. Tell us your site hours and access windows and the work will be fitted around them.
How long before the joints can be used?
The product and site conditions decide that. Some take light use quickly, others need longer to cure, and we confirm it before leaving site.
How the quote is worked out
We price every job individually. The things that drive the figure:
- The site’s rules and procedures
- Specialist products, such as fire-rated or hygienic sealants
- Phasing around occupants
- Removal of failed or old sealant
Small jobs and large programmes are priced from the same things: scope, access, product and programme. Call for a quote and we’ll put a fixed figure on it.
What we need to price the job
For an accurate fixed quote, we need a clear picture of the site. Send us:
- Clear photographs of the problem areas
- The product your specification calls for
- Approximate linear metres or a joint schedule
- Where the site is, with the postcode
Send us photos, drawings or a joint schedule and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.