Fire Stopping in Kaimhill
Planning work on a service penetration in Kaimhill? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Builders’ foam or ordinary silicone in compartment walls
- Unsealed openings around new pipes and cables
- Hidden openings found during inspections
Fire stopping near Kaimhill
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Keeping the joints sound
Cleaning and maintenance staff play a part too. Pass these on to them:
- Record which product was used where
- Foam or ordinary sealant is never a fire-seal repair
- Settle who seals which penetrations at the start of a project
- Make fire stopping part of every scope that crosses a fire-resisting wall
Allow the manufacturer’s stated cure time before boxing in or decorating. Some fire-rated sealants accept paint and some don’t, so check the product data first.
Keep a register of where seals are and what they are made of. It tells the next contractor exactly what to reinstate.
Fire stopping in Kaimhill
Our applicators are CSCS-carded, and we are CHAS accredited and a Constructionline member. We hold no third-party fire-stopping installer certificate, and we won’t pretend otherwise. We install the specified fire-rated sealant to its tested detail, and our workmanship carries a 12-month guarantee. Most enquiries involve openings left by services added after handover and old intumescent sealant that has split away, on joints between fire-resisting walls and floors, small duct penetrations where the tested detail allows and linear gaps at wall heads. A single leaking joint is often how a building in Kaimhill first comes to us: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Older stone and tenement buildings in Scotland’s cities have normally been re-serviced many times. Wall type and service type decide the product, so both are checked before sealing.
A 12-month guarantee applies to all our work in Aberdeen. Should something we installed fail, give us a call on 01277 525 020 or email a schedule or drawings and we will come back to it.
- Place
- Kaimhill (AB10, AB12, AB15)
- Wider area
- Aberdeen
- Guarantee
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Last updated
- 3 November 2026
Also in Kaimhill
Compartments and services around Kaimhill
Kaimhill has seven care or nursing homes no more than 2 miles away. Care settings depend on compartmentation, so service penetrations made during maintenance or refurbishment need sealing with the specified product. Where that’s fire-rated sealant, we install it to the manufacturer’s tested detail. The area within 2 miles of Kaimhill holds plenty of hotels. In hotels, bedroom and corridor walls are usually fire-resisting, so services added in a refit need sealing with the specified product.
Older community buildings such as Ruthrieston West Church And Hall that have been rewired or given new heating can have service gaps through walls worth checking against the specification. For a hotel such as Palm Court Hotel, 0.9 miles north-west of Kaimhill, penetration seals are worth checking after any refit or services upgrade. Large healthcare estates like Albyn Hospital (1.2 miles north of Kaimhill) change their services often, so penetration seals are worth checking after M&E work.
Kaimhill is about 2 miles south of Aberdeen, in Aberdeen. If you’re looking for fire stopping in Kaimhill, we can help, as we do across Aberdeen. 40 places across Aberdeen fall within our area, Kaimhill among them.
Work on service penetrations is covered throughout AB10, AB12 and AB15, for business premises of every kind. Among the streets we cover are Ruthrie Road, Norfolk Road and Deevale Road, and sites on any of them can send details for a fixed quote. Close to Kaimhill, our area also takes in Broomhill (1 mile north), Garthdee (1 mile south-west), Kincorth (1 mile south-east), Braeside (1 mile north-west) and West End (1 mile north-west). Nearby towns on our patch include Dyce (6 miles north-west), Tillydrone (3 miles north), Donside Village (3 miles north), Cummings Park (3 miles north), Danestone (4 miles north) and Mastrick (3 miles north-west).
Landmarks near Kaimhill
Around Kaimhill, our work takes us to commercial buildings near Lochside Academy, Albyn School and Duthie Park and the streets around them. Kaimhill’s nearest station is Aberdeen station, about 1.6 miles north-east of the centre. A little further out are Gordon Highlanders Museum (1.1 miles north-west) and Pitfoddels Castle (1 mile south-west). The countryside around Kaimhill includes Upper Lake and Portlethen Moss.
Your questions answered
Will you plan work around the academic year at somewhere like Robert Gordon University?
Yes. Tell us the term dates, vacation periods and access windows, and we’ll plan the work around them. Let us know which documents your site asks for, and we’ll confirm them alongside the quote.
How do the Scottish rules apply to fire-rated sealing in Kaimhill?
Under Scotland’s non-domestic Technical Handbook (clause 2.1.14), service penetrations should keep at least the wall or floor’s fire resistance duration, using products tested for their end use. Design sits with the designer and the verifier; installation to the tested detail is our part.
What happens if old sealant might contain asbestos?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. Removing asbestos is a job for asbestos specialists, not us.
Are you insured?
Yes. We’re fully insured, and the certificate can go with your quote.
Are you CHAS accredited?
Yes. CHAS accredited, Constructionline member, and our applicators hold CSCS cards.
How do I request a quote?
The quote form is the simplest route, though you can also call the office on 01277 525 020 or email us. Include photos or drawings if you have them.
Is it fine to apply new sealant on top of old?
No. Failed sealant is removed and the faces cleaned back to sound, dry material first, since fresh sealant will not bond reliably to aged material.
What the job involves on each surface
Small ducts
Small ductwork can sometimes be sealed with sealant where the tested detail includes it. Larger or fire-rated ductwork normally needs a different solution set by the designer and we flag that rather than guess.
Cables and cable bundles
New data and power cables are the most common breach we see. We reseal around them to the specified detail, and any bundle too large for sealant alone is flagged.
Why deal with it now?
Open service penetrations matter on ordinary days, not just in a fire: they also carry noise, draughts and smells between rooms. The specified fire seal closes the gap for all of these and the building feels the difference. In Kaimhill, as across Scotland, rain finds any gap, so a split or hardened joint lets water into the wall. Renewing them early protects the fabric.
Whether it’s a single area or a whole estate, the same things set the price: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote, and you’ll have a fixed figure to work with.
Why clients in Kaimhill choose us
- CHAS accredited
- Workmanship guaranteed for 12 months
- CSCS-carded applicators
- Specification-led, product-correct work
Take a look at what affects the cost and how we’re accredited.
When to bring in a specialist
General builders and handymen seal joints, but it isn’t their main trade. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
Paperwork matters too. Many sites expect CSCS cards, RAMS and proof of insurance, and our CSCS-carded applicators are used to working under those rules.
Commercial clients in Kaimhill
Whether you’re a managing agent, a property factor or an owner’s representative: send the details, accept a fixed quote, and we carry out and guarantee the work. We can agree access arrangements and keyholder contacts beforehand.
Main contractors use us as their sealant subcontractor on new-build and refurbishment projects. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
Diagnose, treat, sign off
Site rules come first: signing in, inductions and any permit to work. With the paperwork done, we take the joints in the sequence agreed with you, and each area is checked before we leave it. For premises in Kaimhill, tell us about access times, shared entrances and any building rules, and we’ll plan the work to suit, phased where areas need to stay in use.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Getting the site ready
- Clear stock, furniture or equipment away from the joints
- Point out any areas we must not close
- Let us know about inductions and permits
Getting a fixed quote
We quote a fixed sum against the scope you give us, so the cost is agreed before work starts. To ask for one, speak to us on 01277 525 020 or email a schedule or drawings.