Fire Stopping in Hanover
Fire stopping in Hanover, backed by over 20 years in commercial sealing. Fully insured and CHAS accredited.
- Unsealed penetrations discovered above suspended ceilings
- Seals disturbed by maintenance and left open
- Fire stopping installed outside its tested range
Fire stopping for Hanover sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Cost factors for service penetrations
These are the things that shape the price:
- Any access equipment needed
- The site’s rules and procedures
- Distance, for remote addresses
- Phasing around occupants
Access often affects the price as much as the sealing: easy-to-reach joints are quicker than those that need equipment to get to. Tell us how the joints are reached and call for a quote.
What we need to price the job
Diagnosis starts before we arrive. Let us know:
- Photos of the joints, close up and from further back
- Access details, including height
- What the building is and how it’s used
- Your programme or deadline
Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To ask for one, give us a call on 01277 525 020 or send details through our quote form.
How we handle fire stopping in Hanover
It helps to set out our role at the start. The designer, fire engineer or building control decides which fire stopping is required. We fit the specified fire-rated sealant following that specification and the maker’s installation guidance on buildings around Hanover. If you’re dealing with head-of-wall gaps with no fire seal and openings found when ceilings come down for a refit, we can put it right, on service gaps in risers, cable penetrations and linear gaps at wall heads alike. A specialist sealant contractor works differently from a general builder: on jobs in Hanover, preparation and product choice get the time they need.
Around smaller places like Hanover, many commercial buildings are conversions or extensions of older ones, so it’s worth confirming the wall or floor type before choosing the seal. The right product depends on the wall or floor and the services passing through, and we will tell you if the detail calls for something other than sealant.
Whoever the client is, the cover is the same: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we’re upfront about that.
- Place
- Hanover (BN2, BN1, BN50)
- Region
- Brighton and Hove
- Cover
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Updated
- 3 November 2026
For managing agents and facilities managers
When you manage a building on behalf of an owner, you need clear quotes and clear reporting. You get a fixed quote, an agreed scope and a walk round at the end, plus a 12-month guarantee.
Agents, factors and owners’ representatives all follow the same route: send details, get a fixed quote, we seal, guaranteed. Keys, access and contacts can be agreed in advance.
Places near Hanover
Other services in Hanover
Why act early in Hanover
The longer openings stay, the more there tend to be: each new service adds to the list. Keeping on top of it after each round of works keeps the job small and avoids a much larger catch-up later. Sealant hardens, cracks and loses grip with age, UV and movement. Renewing it in good time keeps the building weathertight.
What a job costs comes down to how many linear metres there are, what has to come out first and the access. Call for a fixed quote once you have the details.
Why us?
- CHAS accredited
- 12 months’ guarantee on every job
- One contact handling all your sites
- Specification-led, product-correct work
Read what affects the cost or our accreditations and insurance.
From enquiry to sign-off
We schedule the visit to fit the site hours and access windows you give us. On the day, the work area is kept contained and tidy, and we check in with your contact before moving on to each new area. Several jobs near Hanover can be grouped on one trip. Mention the building’s opening times and we will work within them.
- First we confirm the product and tested details named in the specification.
- Openings are measured and grouped by detail.
- Old or wrong materials are cut out.
- Mineral wool or other backing is fitted where required.
- We gun the sealant in to the specified depth around each service and tool it.
- We walk the completed areas with you and confirm the records agreed at quote stage.
Before we start on site
- Send asbestos survey details if the building is pre-2000
- Explain the parking and delivery arrangements
- Share your working hours and any access restrictions
Quotes
Specifications, drawings and tender packages are welcome with any enquiry, and we will price against exactly what is specified. Smaller jobs need nothing more than photos and a few notes.
Related advice
Maintenance after handover
After handover, a little attention goes a long way:
- Arrange inspection before areas are covered up
- Leave fire sealant to cure fully before covering it
- Foam or ordinary sealant is never a fire-seal repair
- Include service cupboards in routine inspections
Allow the manufacturer’s stated cure time before boxing in or decorating. Not every fire-rated product can be painted, and the data sheet says which.
Keep a register of where seals are and what they are made of. It tells the next contractor exactly what to reinstate.
Fire stopping around Hanover: how the place shapes the job
Approved Document B is the English guidance that covers fire stopping around openings and penetrations. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. Our part stays the same: the specified product, installed to its tested detail. A 2-mile radius around Hanover takes in plenty of hotels. Hotels are divided into compartments, and refurbishments that add pipes and cables through bedroom and corridor walls leave gaps to close.
For a unit at a site such as Freshfield Industrial Estate, 0.5 miles to the south-east of Hanover, new power or data runs between office and warehouse can breach a compartment wall. Colleges such as Waterbear College Brighton, 0.7 miles west of Hanover, add IT and services as courses change, and each new penetration through a fire-resisting wall needs sealing with the specified product.
Hanover is about 1 mile south of Brighton, in Brighton and Hove. We cover commercial sites throughout Hanover, for single jobs and planned programmes alike. Hanover is one of 29 places in Brighton and Hove on our list for service penetrations.
Anyone looking for fire stopping in BN2, BN1 and BN50 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. We cover commercial and managed buildings on Elmore Road, London Road and Milton Road. Sites close to Hanover are covered too, including Brighton (1 mile north), Carlton Hill (1 mile south), West Hill (1 mile west), Seven Dials (1 mile west) and Kemptown (1 mile south-east). Bigger towns within reach include Brighton and Hove (3 miles west), Portslade (4 miles west), Aldrington (3 miles west), Hangleton (3 miles north-west), Patcham (3 miles north) and Westdene (3 miles north-west).
Around Hanover
In Hanover, that means premises near Academy of Creative Training, Brighton Girls and The Dover Castle pub and the streets around them. For rail, the closest station is Brighton station, about 0.6 miles west. A little further out are Old Police Cells Museum (0.8 miles south-west) and Brighton General Hospital (0.6 miles east). Green spaces nearby include Whitehawk Hill and Newmarket Hill.
Signs you need fire stopping in Hanover
Openings in fire-resisting walls normally appear when services are added or changed. A new cable pulled by an electrician, a pipe rerouted by a plumber or a data run drilled through a riser can leave the hole behind. Over a few years of fit-outs, a wall can collect a lot of these.
What tends to prompt an enquiry:
- Unsealed openings around new pipes and cables
- Unsealed penetrations discovered above suspended ceilings
- Open linear gaps along the top of fire-resisting walls
- Non-fire-rated filler around services
For a hotel such as Part Of The Greenwood Lodge Hotel, less than half a mile south-west of Hanover, penetration seals are worth checking after any refit or services upgrade.
What to look for in a quote
- Whether their applicators hold CSCS cards
- What site paperwork they can supply
- How long is the guarantee, and what does it include?
- Their approach to joint depth and backing
FAQs: Hanover
Can you take on a job at a hospital such as Brighton General Hospital?
Yes, healthcare and care buildings are part of our work. The estates team’s permit system and infection-control rules come first, and the work is planned around them.
Can you work at a site such as Freshfield Industrial Estate, by Hanover?
Yes. Estates, retail parks and business parks around Hanover, Freshfield Industrial Estate among them, are all within reach. Photos and a short description are enough for a first look.
Is your workmanship covered by a guarantee?
Yes, for 12 months. If a joint fails because of how we installed it, we come back and put it right.
Do you take on small jobs?
We quote for single jobs as well as large packages and programmes. Photos and a description are enough to start.
Do you need to see the site first?
That depends on the size and complexity of the job. Straightforward work can often be priced from photographs and measurements, while larger or less clear jobs get a site visit first.
Do you design or specify fire stopping?
No. The specification comes from your designer, fire engineer or building control. Our role is installing what they specify, to the product’s tested detail.
What do you charge?
Each job is quoted on its own details. For yours, phone 01277 525 020 or email drawings and photos with a description of the work.