Fire-rated sealing and fire stopping in Godshill, Isle of Wight
Our CSCS-carded applicators take on fire-rated and intumescent sealing of service penetrations and linear gaps in Godshill and the surrounding area. Send details for a fixed quote.
- Expanding foam used as fire stopping
- Openings found when ceilings come down for a refit
- Fire sealant pulled out of the opening
Fire stopping near Godshill
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping in Godshill
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind. We close the openings listed on your schedule, using the specified sealant and detail. We work on cable penetrations, small duct penetrations where the tested detail allows and linear gaps at wall heads, and the usual reasons a site gets in touch are fire-stopping items raised at inspection or handover and unsealed joints where partitions meet the slab. Facilities teams, main contractors and managing agents in Godshill tend to want the same three things: a clear scope, tidy work and joints that don’t fail again.
Smaller places such as Godshill still have buildings with fire-resisting walls and floors: schools, halls, care homes and commercial conversions. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
We stand behind the joints we seal with a 12-month guarantee. That covers our preparation and application, and we come back if anything isn’t right.
- Where
- Godshill (PO38)
- Wider area
- Isle of Wight
- Guarantee
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
Site staff or a sealant specialist?
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
Places near Godshill
More services for Godshill
For managing agents and facilities managers
Hotels, schools, healthcare sites, offices and retail units book us directly too. The work is planned around how the building runs, so guests, pupils, patients or staff are disturbed as little as possible.
Building owners and managing agents use us on sealant work across single buildings or whole portfolios around Godshill. Several sites can go on one quote, which keeps the paperwork simple.
Compartment walls and floors in Godshill
Fire stopping of openings and penetrations in England falls under Approved Document B. The national BS 476 classes are due to drop out of it from 2 September 2029, leaving the European BS EN 13501-2 route, subject to transitional arrangements. Our part stays the same: the specified product, installed to its tested detail.
Holiday works at schools like Godshill Primary School often leave service openings to seal before pupils return. Halls and meeting rooms at places like All Saints' Church sometimes gain new services, and any compartment wall crossed needs the specified seal. Large healthcare estates like Whitecroft Hospital (to the north-west of Godshill) change their services often, so penetration seals are worth checking after M&E work.
Godshill is about 5 miles south of Newport, in the Isle of Wight. Looking for fire stopping in Godshill? We can help. Our the Isle of Wight coverage takes in 125 places, large and small. We also cover Portsmouth, some 14 miles away.
If you need fire stopping in PO38, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. Buildings on High Street, Jubilee Close and Yarborough Close are within our area for service penetrations. Nearby places we also cover include Sandford (1 mile east), Rookley Green (1 mile north-west), Rookley (2 miles north-west), Whiteley Bank (2 miles east) and Merstone (2 miles north) for service penetrations. Further afield, our area takes in Newport (5 miles north), Ryde (7 miles north-east), Cowes (9 miles north), Sandown (4 miles east), Shanklin (4 miles east) and Ventnor (4 miles south-east). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so give the site location in your enquiry.
Around Godshill
Around Godshill, our work takes us to commercial buildings near The Essex pub and the streets around them. For rail, the closest station is Shanklin station, roughly 3.5 miles east of the centre. Other landmarks nearby include Whitecroft Hospital (3.2 miles north-west) and Museum of Country And Agriculture (2.6 miles north-east). Open spaces near Godshill include Alverstone Mead and Stenbury Down.
Aftercare for building managers
For the best life from the joints:
- Leave fire sealant to cure fully before covering it
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Keep general-purpose fillers away from compartment walls
- Agree the fire-stopping specification before services go in
Never top up a fire seal with foam, ordinary silicone or filler. A repair should use the original product, installed the same way unless the designer specifies otherwise.
On fit-outs, get the fire-stopping specification agreed before the services go in. Details can then be picked to suit the actual pipes, cables and ducts, and the work runs in step with the M&E.
Questions about Godshill
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Godshill?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
Does your area include sites such as Wroxall Industrial Estate, near Godshill?
Yes. Our area takes in Godshill and its surroundings, with estates and business parks such as Wroxall Industrial Estate included. Send details of the unit and the work through our quote form for a quick quote.
How long does a job like this take?
We plan the time on site around your programme and access. You will have an expected duration with the quote.
What hours do you work?
We’re in the office from 8am until 5pm, Monday to Friday. Tell us your site hours and access windows and the work will be fitted around them.
Is colour matching possible?
Often, yes. Many products come in a range of standard colours, and matching to RAL references or surrounding finishes is often possible. We’ll confirm the colours available for the specified product.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and the quote will be based on it, flagging anything that needs clarifying.
Are you fully insured?
Yes. We’re fully insured, and the certificate can go with your quote.
Diagnose, treat, sign off
We bring the products specified for the job, along with primers and backing rod. Any old material is cut back to clean, sound faces, the manufacturer’s primer is applied where it’s called for, and the sealant is tooled off neatly. For work around Godshill, we aim to finish in one visit, so photos and measurements up front really help. That way the right products come on the day.
- First we confirm the product and tested details named in the specification.
- Openings are measured and grouped by detail.
- Improvised fillers and failed sealant are removed.
- Where the detail needs backing, it goes in at the stated depth.
- We gun the sealant in to the specified depth around each service and tool it.
- Completed areas are checked with you, with the records agreed when we quoted.
What we need from you
- Tell us which areas need to stay in use
- Share the asbestos register for older buildings
- Let building users know which areas are affected
Request a quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.
Advice
How the job changes by surface
Metal pipes
Sealant details often cover copper and steel pipework. The tested detail sets the pipe size range, gap, depth and whether insulation can stay on and we confirm each before sealing.
Drylining partitions
Holes in board are often cut larger than needed. If the gap exceeds the tested range, sealant alone won’t do, and the detail may call for board patching or another product.
When something else is needed
We check first that sealant really is the fix. It isn’t the answer for:
- Writing the fire-stopping specification
- Fire doors, dampers or other fire safety equipment
- Large openings beyond what any sealant detail covers
If in doubt, phone 01277 525 020 or email us and we will say what we think.
Joints and surfaces we work on
- Cable penetrations
- Linear gaps at wall heads
- Pipe penetrations
- Service gaps in risers
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors