The Mastic Doctor team standing beside their branded vans outside an office building
South Ayrshire · Scotland

Fire Stopping in Ayr

Need fire stopping in Ayr? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.

  • Penetration schedules that need working through
  • Openings left by services added after handover
  • Non-fire-rated filler around services
1
Send details
Drawings, photos, a joint schedule or a site visit.
2
Get a quote
A fixed quote for the work, with the scope in writing.
3
We seal
CSCS-carded applicators, the right product for each joint.
4
Guaranteed
Backed by a 12-month workmanship guarantee.
London, the South East & Scotland
Constructionline member
£5m PL insurance

Fire stopping for businesses in Ayr

Photos, a specification or a quick description of the joints is enough to start a fixed quote.

How we handle fire stopping in Ayr

Opened ceilings and riser doors often reveal service openings nobody sealed. If a specification already covers those walls and floors, we can reseal to it, matching the product and detail it names. Where there isn’t one, the designer or fire engineer needs to set one first. We work on service gaps in risers, joints between fire-resisting walls and floors and cable penetrations, and the usual reasons a site gets in touch are non-fire-rated filler around services and improvised or mixed-product fire seals. One point of contact handles commercial sealant work in Ayr from the first photos to the final walk-round, whether it’s one building or several.

In a town like Ayr, who decides the fire-stopping detail matters: design and sign-off sit with the designer, fire engineer or the local authority verifier, and we install what is specified. Records of the work can be discussed when we quote.

Every job we finish is backed by a 12-month workmanship guarantee, in Ayr as everywhere else we work. If a joint we sealed fails because of how it was installed, we come back and put it right.

The Mastic Doctor team beside their liveried vans in front of an office building
Location
Ayr (KA7, KA8, KA6)
Region
South Ayrshire
Cover
12 months on our workmanship
Quote
Fixed quote, scope in writing
Phone
01277 525 020
Last updated
3 November 2026

Where services cross fire walls in Ayr

A 2-mile radius around Ayr takes in a good number of hotels. Bedroom-to-corridor walls in hotels are normally fire-resisting, so new cabling or pipework through them has to be sealed to the tested detail. Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, with products tested for that end use. We install what’s specified, to the product’s tested detail.

In a hotel such as Station Hotel, less than half a mile north-west of Ayr, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product. At a healthcare site like Biggart Hospital, 2.7 miles to the north of Ayr, new services through compartment walls are a constant, and each needs the specified seal.

Ayr is about 31 miles south-west of Glasgow, in South Ayrshire. Our applicators travel to Ayr for work on service penetrations. Ayr is one of 48 places we cover in South Ayrshire for service penetrations. Our Glasgow page has more on work in that area, about 31 miles away.

Postcode districts covered here: KA7, KA8 and KA6 for service penetrations. Streets here include Ellisland Square, Station Road and Burns Statue Square, and sites on any of them can send details for a fixed quote. Access to Ayr is via the A70 and A77, so getting applicators and materials to site is simple. Nearby places we also cover include Belmont (1 mile south), Forehill (1 mile south-east), Montgomerieston (1 mile north-west), Seafield (1 mile south-west) and Alloway (2 miles south) for service penetrations. Further afield, our area takes in Troon (7 miles north), Prestwick (3 miles north), Maybole (7 miles south), Joppa (4 miles east), Dundonald (9 miles north) and Barassie (8 miles north). Ayr is one of the busier places in South Ayrshire, and we take on service penetrations for its commercial and public buildings.

Near you in Ayr

We work on buildings around Railway Tavern and Wellington School. There’s a railway station in Ayr itself: Ayr station. A little further out are Tam Oshanter Museum (0.5 miles north-west) and Seafield Children's Hospital (0.9 miles south-west). Green spaces nearby include Carcluie Loch.

Map of Ayr © OpenStreetMap contributors

Leave it or put it right?

The longer openings stay, the more there tend to be: every new cable or pipe adds another. A schedule that is dealt with regularly stays manageable and avoids a much larger catch-up later. In Ayr, rain and frost work into any failed joint, so small failures grow. Resealing early keeps it a simple job.

We don’t publish prices, because the scope varies so much from one building to the next. For a fixed figure, call for a quote and we will price your job on its own details.

Why choose Mastic Doctor in Ayr

  • Work carried out by CSCS-carded applicators
  • Products installed to the manufacturer’s instructions
  • One number for every site we cover
  • Sealing commercial buildings since 2005

Read what affects the cost and our accreditations.

Surface by surface

Small ducts

We seal around ducts only within what the tested detail covers. Dampers and ductwork systems themselves are outside our work.

Plastic pipes

Plastic pipes soften and collapse in a fire. Small sizes are sometimes covered by an intumescent sealant detail, though larger ones usually call for a collar or wrap. We confirm material and size first and tell you if sealant isn’t the right product.

What we can’t put right

A proper diagnosis includes knowing what sealant can’t do. You’ll hear from us if the cause turns out to be one of these:

  • Fire doors, dampers or other fire safety equipment
  • Designing or specifying fire stopping, which sits with the designer or fire engineer
  • Openings that need collars, wraps, batts or boards rather than sealant

Not sure which it is? You can call 01277 525 020 or send details through our quote form and we’ll tell you honestly.

Joints and surfaces we work on

  • Cable penetrations
  • Service gaps in risers
  • Joints between fire-resisting walls and floors
  • Linear gaps at wall heads
  • Small duct penetrations where the tested detail allows
  • Pipe penetrations

Quoting for work in Ayr

Each job is priced on its own details. The things that drive the figure:

  • Any access equipment needed
  • Quantities, in metres or numbers
  • Removal of failed or old sealant
  • Distance, for remote addresses

A quote for service penetrations depends on how many there are, their condition and the access, and any specification that applies. Ask us for a fixed quote.

Details that help us quote

A few photographs plus some basic facts will normally do. It helps to include:

  • How the joints are reached, and at what height
  • The postcode of the building
  • The product your specification calls for
  • The type of building and who uses it

Pricing a project or setting a maintenance budget? Send the scope and any drawings, and we’ll return a fixed quote you can plan around. For a chat about it beforehand, give us a call on 01277 525 020 or email drawings and photos.

Questions about Ayr

Will you work in a care home in Ayr without moving residents out?

Yes. We work around residents’ routines, a room or two at a time. We follow the home’s own procedures throughout.

Can you work around term dates at a campus such as University of the West of Scotland - Ayr Campus?

Yes, holiday working periods are the norm on campus jobs. Tell us which site documents you need, such as RAMS, our insurance certificate or CSCS details, and they’re confirmed with the quote.

Can one quote cover more than one building?

Yes. Multi-site work and planned programmes are a core part of the service, with each site phased to suit its occupants.

Is it fine to apply new sealant on top of old?

No. Overlaying old sealant is a frequent cause of early failure, so everything comes out first.

How do we ask for a quote?

It works in four steps: send details, receive a fixed quote, we carry out the work, and it’s guaranteed. The first step only needs photographs and a postcode.

Will you write the fire-stopping specification?

No. The specification comes from your designer, fire engineer or building control. Our role is installing what they specify, to the product’s tested detail.

How much does the work cost?

Each job is quoted on its own details. For yours, phone 01277 525 020 or send photos by email.

Diagnose, treat, sign off

Diagnose, treat, sign off: every visit follows that pattern. First comes an inspection and agreement on scope, then the work is carried out to the specified product and detail, and we finish with a walk round so the work can be signed off. In a Scottish town such as Ayr, outside work is planned around the weather and inside work around the occupants. Send photos or drawings and we will quote and plan to suit.

  1. We read the specification, drawings or penetration schedule you send and raise any questions before we price.
  2. Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
  3. Unsuitable fillers and loose debris are taken out of each opening.
  4. Mineral wool or other backing goes in wherever the detail asks.
  5. Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
  6. If an opening needs something other than sealant, we tell you instead of improvising.

Preparing the site

  • Clear stock, furniture or equipment away from the joints
  • Share the asbestos register for older buildings
  • Let us know about inductions and permits

Getting a fixed quote

Send details, get a quote, we seal, guaranteed: that’s how every job runs. The first step is to speak to us on 01277 525 020 or email drawings and photos with what you know.

Get a quick quote

Read more

Do you need fire stopping in Ayr?

Most open service penetrations are left by later work. A new cable pulled by an electrician, a pipe rerouted by a plumber or a data run drilled through a riser can leave the hole behind. Over a few years of fit-outs, a wall can collect a lot of these.

These are often picked up first by site or facilities staff:

  • Fire-stopping items raised at inspection or handover
  • Openings left by services added after handover
  • Old intumescent sealant that has split away
  • Head-of-wall gaps with no fire seal

For a unit at a site such as Newton Trading Estate, 1.2 miles to the north of Ayr, new power or data runs between office and warehouse can breach a compartment wall.

What to look for in a quote

  • Do they follow the manufacturer’s priming guidance?
  • Whether their applicators hold CSCS cards
  • Their pre-qualification and accreditations
  • How long is the guarantee, and what does it include?

Choosing a commercial sealant contractor

Accreditations

Trusted. Accredited. Insured.