Expansion and movement joint sealing in Tulloch, Perth and Kinross
Commercial sealant work in Tulloch for contractors, FMs and building owners: expansion and movement joint sealing in walls, decks and floors, with a fixed quote first.
- Brittle, chalky sealant on external joints
- Joints where the bead has lost adhesion
- Spalled or broken joint edges in floors and decks
Expansion joint sealing for Tulloch sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Diagnose, treat, sign off
Where the site stays busy, we agree a sequence with your contact so the disruption stays in one area at once. Each area is protected, prepared and sealed, then reopened once the sealant allows before we move to the next. For a building near Tulloch, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- First, the joints are inspected for width, movement and the type of failure.
- You get a fixed quote with the product and its movement capability stated.
- Old sealant and filler are cut out and the joint faces cleaned back to sound material, flagging any broken edges that need repair before sealing.
- We control the depth with backing rod or, in shallow joints, bond-breaker tape.
- Where the maker calls for primer, it’s applied first, then the bead goes in and is tooled to a concave finish.
- We check every joint before sign-off, and the work carries our 12-month guarantee.
Before we start on site
- Share your working hours and any access restrictions
- Tell us what induction or permit system the site runs
- Send asbestos survey details if the building is pre-2000
Quotes
Quotes are fixed against the scope you send, so the cost is agreed before work starts. To start the process, ring 01277 525 020 or email the details over.
Related advice
Expansion joint sealing in Tulloch
Our movement joint work takes in walls, panels, decks and floors: vertical joints in brick and block facades, joints between precast or cladding panels, concrete slab and deck joints, ramps, podiums and internal floors. Every one calls for a sealant picked for its movement, exposure and traffic. We work on blockwork control joints, podiums and floor movement joints and precast concrete panel joints, and the failures we are asked to look at most are sealant peeling off one face of the joint and spalled or broken joint edges in floors and decks. A specialist sealant contractor works differently from a general builder: in Tulloch, that means joint design, primers and backing rod as standard.
Around smaller Scottish places like Tulloch, slabs needing attention are often in agricultural buildings, workshops, schools and hotels. Concrete slabs and yards there take vehicles and weather.
What our 12-month guarantee covers is the way we did the job: preparation, application and finish. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Where
- Tulloch (PH1)
- Region
- Perth and Kinross
- Guarantee
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Towns and villages near Tulloch
Also in Tulloch
Warehouse floors and decks around Tulloch
Less than 3 miles from Tulloch there are at least three named estates and business parks. Their warehouses, yards and car parks are exactly where joints take the most punishment. Tulloch is in the east of Scotland, which is drier than the west. Freezing weather and salt still attack open external joints. Sealing them in drier months limits winter damage.
Centres like St Catherine's Retail Park, 1.4 miles to the south-east of Tulloch, have mall floors and service decks whose joints carry steady traffic. Parks like Inveralmond Business Centre (to the north-west of Tulloch) combine paved areas, car parks and building elevations, each with joints that move.
Tulloch is about 1 mile north-west of Perth, in Perth and Kinross. Commercial clients in Tulloch can call on us for movement joints, as part of our coverage of Perth and Kinross. We work across 114 places in Perth and Kinross. Sites around Dundee have their own page, about 19 miles away.
We take on movement joints across the PH1 postcode area, whatever the building. Among the streets we cover are Arran Road, Crieff Road and Milton Road. With the A9 nearby, Tulloch is easy to get to with materials and equipment. Sites close to Tulloch are covered too, including Hillyland (1 mile south-west), Ruthvenfield (1 mile west), Letham (1 mile south), Huntingtower (1 mile south-west) and Stormontfield (3 miles north). Nearby towns on our patch include Blairgowrie and Rattray (13 miles north), Crieff (14 miles west), Auchterarder (12 miles south-west), Kinross (14 miles south), Coupar Angus (12 miles north-east) and Rattray (13 miles north-east). Tulloch is one of the busier places in Perth and Kinross, and its commercial and public buildings are all within our area.
Landmarks near Tulloch
We work on buildings around St John's Academy and North Inch. For rail, the closest station is Perth station, roughly 1.9 miles south-east. A little further out are Murray Royal Hospital (2.1 miles south-east) and Huntingtower Castle (0.8 miles west). Not far away are St Magdalene's Hill.
After the work
For the best life from the joints:
- Plan racking layouts so feet don’t land on a joint
- Record the sealant used and the date in the O&M file
- Keep scrapers and ploughs from dragging across joint sealant
- Inspect exposed joints once the cold weather has passed
Fresh joint sealant needs its full cure time before it takes traffic or water. How long that takes depends on the product, the temperature and the depth of the joint, and we confirm it for each area before we leave. Keeping the area coned off until then avoids tyre marks and damage.
Floor joints with failed fillers break up quickly under wheels. Damaged edges make the floor rough and wear wheels faster. Sealing early protects the edges.
How the job changes by surface
Brickwork and blockwork joints
Vertical movement joints in brick and block walls let the masonry grow and shrink. We use a sealant rated for the movement, typically low-modulus, with backing rod setting the depth.
Concrete and precast panel joints
Precast panels often have surface residues that sealant won’t bond to. We prepare the faces thoroughly and prime where the maker calls for it.
Tulloch: questions and answers
Can you work at a site such as Inveralmond Business Centre, by Tulloch?
Yes. Our area takes in Tulloch and its surroundings, with estates and business parks such as Inveralmond Business Centre included. To start, just give us a call on 01277 525 020 or send photos by email with the unit, the joints involved and your access times.
Do you take on work at healthcare sites like Perth Royal Infirmary?
Yes, healthcare and care buildings are part of our work. Each area is agreed with the ward or department and the estates team in advance.
Can you send site paperwork?
Let us know which documents the site needs, such as RAMS, an insurance certificate or CSCS details, and we will confirm them with the quote.
What’s the difference between an expansion joint and a movement joint?
The general name is movement joint, and expansion joint is one common type. In everyday use the two names are often swapped, and the sealing method is much the same.
Do you guarantee expansion joint work?
Our workmanship on movement joints carries a 12-month guarantee. The guarantee covers how we sealed, not damage caused afterwards.
Can you quote from photographs?
Photos, drawings or a schedule are often enough to quote. If the job needs a look first, we will arrange a visit.
Is Tulloch in your area?
Yes. We take on work across Tulloch, with one number for every area we cover.
Do you need expansion joint sealing in Tulloch?
The edges of the material can fail rather than the sealant. Weak or crumbling concrete, brick or render edges give the sealant nothing sound to grip, so we tell you if the edges need repairing first.
Typical triggers for a call:
- Car park joints leaking onto vehicles below
- Sealant pulling off the joint face
- Joints packed with grit and debris
- Brittle, chalky sealant on external joints
A healthcare site such as Perth Royal Infirmary (to the south-east of Tulloch) depends on car parks, ramps and service yards whose joints take traffic all day.
Questions to ask before you book
- Their public liability cover
- Who will actually carry out the work
- Their pre-qualification and accreditations
- What the guarantee covers, and for how long
Quoting for work in Tulloch
Each job is priced on its own details. The things that drive the figure:
- Joint width, depth and condition
- How much there is to seal
- Any access equipment needed
- Removal of failed or old sealant
A quote for movement joints depends on quantities, condition and access. Ask us for a fixed quote.
Before you send an enquiry
A good diagnosis starts with the right details. Tell us:
- Access details, including height
- Asbestos survey details if the building is older
- Drawings or a marked-up plan, if available
- The product your specification calls for
A handful of photographs and a postcode is the fastest way to a quote. Send them through the quote form, or give us a call on 01277 525 020 or email us to discuss it first.
For managing agents and facilities managers
Hospitality, education, healthcare, office and retail clients come to us directly as well. We plan around the way the building is used, so guests, pupils, patients or staff are disturbed as little as possible.
CHAS accredited and a Constructionline member, we’re straightforward to vet for your supplier list. We are fully insured, and our insurance certificate can go with the quote.