Expansion and movement joint sealing in Gilmerton, Perth and Kinross
Expansion and movement joint sealing in walls, decks and floors in Gilmerton. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.
- Spalled or broken joint edges in floors and decks
- Joints packed with grit and debris
- Sealant peeling off one face of the joint
Expansion joint sealing near Gilmerton
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Expansion joint sealing in Gilmerton
A movement joint only works while its seal does. Once it fails, water, grit and debris get in; the joint jams, its edges take the load and the arrises spall. Dealt with early, it stays a sealant job rather than a concrete or masonry repair. Site teams most often ask us about rain penetration at brick or block movement joints and layers of sealant in a movement joint, on blockwork control joints, precast concrete panel joints and car park decks and ramps. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Gilmerton is the same: the right product in a properly prepared joint.
Around smaller Scottish places like Gilmerton, slabs needing attention are often in agricultural buildings, workshops, schools and hotels. Concrete slabs and yards there take vehicles and weather.
The 12-month guarantee covers our workmanship: the preparation, the sealing and the tooling. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Place
- Gilmerton (PH7)
- Region
- Perth and Kinross
- Guarantee
- A 12-month guarantee
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
For managing agents and facilities managers
Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, and each stage is agreed with your contact.
For main contractors, we work as the sealant subcontractor. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
Gilmerton: questions and answers
Can you take on a job at a hospital such as Crieff Community Hospital?
Yes, provided the work is planned with the site’s estates team. Each area is agreed with the ward or department and the estates team in advance.
Is Gilmerton off your patch?
Not at all. Gilmerton is within our area. We cover the whole of Scotland. Where we can, we group nearby jobs to make the most of each trip.
Are expansion joints and movement joints the same thing?
Movement joint is the broad term for any joint built in to let a structure move. In everyday use the two names are often swapped.
Can staff carry on working while you are here?
Yes, with some planning. Tell us your site hours and access windows and we’ll plan around them.
Can you send site paperwork?
Let us know which documents the site needs, such as RAMS, an insurance certificate or CSCS details, and we’ll confirm them with the quote.
Is any job too small?
Small jobs are welcome alongside larger packages. Photos and a description are enough to start.
Do you work to architects’ specifications?
Yes. Include it with the drawings when you ask for a quote, and the quote will be based on it, flagging anything that needs clarifying.
From enquiry to sign-off
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. On site, the work normally takes a day or so for a modest run of joints, and longer where decks, ramps or floors are done in phases, and our waste is bagged and taken away as we go. Where we can, we combine work around Gilmerton with other jobs nearby. Tell us how flexible your dates are.
- Photos, joint lengths and drawings come to us, or we visit.
- Joint widths and expected movement are checked against what the sealant can take and tell you if the design looks wrong for the movement.
- Every joint is cleared of the failed seal and any grit packed into it.
- Any broken arrises or friable edges are flagged before work goes further.
- A sealant suited to the movement and traffic is laid to depth and tooled.
- Each area is handed back after its cure time, under our 12-month guarantee.
Getting the site ready
- Warn occupants and staff about the work
- Point out any areas we must not close
- Explain the parking and delivery arrangements
Getting a fixed quote
The quickest route to a quote is a few photographs and the site postcode. Send them through the quote form, or give us a call on 01277 525 020 or email a schedule or drawings if you’d rather talk the job through.
Related advice
Warehouse floors and decks around Gilmerton
Gilmerton is on Scotland’s drier eastern side. Cold winters and gritting are hard on any yard or deck joint left open. Sealing them in drier months limits winter damage.
Hospitals like Crieff Community Hospital, 2.1 miles south-west of Gilmerton, have multi-storey or surface car parks whose joints carry vehicles round the clock.
Gilmerton is about 14 miles west of Perth, in Perth and Kinross. Any commercial site in Gilmerton is covered, for single jobs and planned programmes alike. 114 places across Perth and Kinross fall within our area, Gilmerton among them. Our Dundee page has more on work in that area.
We cover the PH7 postcode districts. Streets here include Grahame Terrace and Perth Road, and sites on any of them can send details for a fixed quote. Nearby places we also cover include Crieff (2 miles south-west), St David's (4 miles south-east), Muthill (4 miles south), Madderty (4 miles south-east) and Tullibardine (6 miles south) for movement joints. Bigger towns within reach include Perth (14 miles east), Auchterarder (8 miles south-east), Letham (13 miles east), Tulloch (13 miles east), Oakbank (13 miles east) and Hillyland (12 miles east).
Landmarks near Gilmerton
Well-known places in the area include Crieff and Strathearn Museum (1.9 miles south-west) and Castle Cluggy (2.9 miles west). For a walk, there’s Loch Monzievaird.
When something else is needed
Our job is the joint, not everything around it. On its own, sealant can’t deal with:
- Cracking or settlement that calls for an engineer’s assessment
- Mechanical expansion joint covers, cover plates or proprietary joint systems (a specialist supplier’s job)
- Concrete or masonry repairs along the arrises
Not sure which it is? You can call the office on 01277 525 020 or use the quote form and we will tell you honestly.
Joints and surfaces we work on
- Brickwork movement joints
- Car park decks and ramps
- Blockwork control joints
- Cladding panel joints
- Precast concrete panel joints
- Podiums and floor movement joints
Nearby places to Gilmerton
Also in Gilmerton
Why act early in Gilmerton
A torn seal left alone typically gets worse. Grit and water fill the gap and the material either side breaks up and the job grows to repairs as well as sealing. Resealing early keeps the work to sealant. Exposed buildings in Scotland take a lot of weather, so it’s worth renewing joints around Gilmerton before they leak.
The product called for affects the cost, as does the preparation each joint needs, from cutting out to priming and backing rod. Access, phasing and site requirements come into it too.
Why appoint us
- CHAS accredited contractor
- Our applicators hold CSCS cards
- Clear, fixed quotes
- Constructionline member for supplier checks
Take a look at how commercial sealant jobs are priced and our accreditations and insurance.
What we’re called out for in Gilmerton
When a bead pulls away from one face, it has lost adhesion. Dusty, damp or contaminated faces, a missing primer and three-sided adhesion are the usual causes and it often shows on rushed work.
Look out for the following:
- Spalled or broken joint edges in floors and decks
- Torn sealant in brick or block movement joints
- Sealant peeling off one face of the joint
- Layers of sealant in a movement joint
Office parks like Crioch Business Centre, 2.1 miles to the south-west of Gilmerton, have decks, ramps and clad elevations whose joints take movement every day.
Before you book anyone
- Will failed sealant be removed rather than covered?
- How they’ll work around occupants
- Is the sealant right for the movement and the substrate?
- What level of public liability insurance do they hold?
When to bring in a specialist
There’s also the paperwork. Many sites expect CSCS cards, RAMS and proof of insurance, and we’ll confirm the paperwork you need with the quote.
Site maintenance staff can often handle a short internal joint. The usual problems come from preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.