Washroom Sealing in Scourie
Work needed on a washroom in Scourie? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Split or peeling sealant at shower trays
- Gaps where vanity tops meet the wall
- Failed sealant in a tea point or staff kitchen
Washroom sealing for Scourie sites
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
After the work
Regular inspection catches problems early. Specifically:
- Report split joints at trays and basins early
- Share your site rules when you send details
- Respect the cure time before reopening each room
- Avoid scourers and harsh descalers on silicone
Ask your cleaning team to use gentle products and soft cloths on sealant. Strong acids, solvents and scourers wear the surface and give mould a start.
Leaks through tray and wet-floor joints can go unseen until a ceiling marks below. By then, other trades may be needed as well so failed joints are worth acting on quickly.
Washroom sealing in Scourie, done properly
For clinics, hospitals and care homes, sealed joints matter for infection control as much as appearance. We work to your organisation’s estates and infection-control requirements and any site permits. Tell us what records you need and we will confirm with the quote. If you have black mould inside silicone joints that cleaning can’t shift and split or peeling sealant at shower trays, we can help, whatever the surface. A specialist sealant contractor works differently from a general builder: on jobs in Scourie, preparation and product choice get the time they need.
Hospitality around smaller Scottish places like Scourie tends to be seasonal, and resealing washrooms in the quieter months keeps rooms available when they’re needed.
Every job we finish is backed by a 12-month workmanship guarantee, wherever the site is. If our installation lets you down in that time, we return and fix it.
- Place
- Scourie (IV27)
- Region
- Highland
- Guarantee
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Diagnose, treat, sign off
Where the site stays busy, we agree a sequence with your contact so the disruption stays in one area at once. Each section is protected, cleaned back and sealed, then reopened once the sealant allows before we move to the next. Travel to smaller Scottish places like Scourie is planned so the job is finished in one visit where possible, so photographs, sizes and a full list matter. External joints need a dry spell as well.
- We inspect each washroom and record the joints to be resealed.
- You get a fixed quote with the phasing plan.
- The whole of the old bead is removed.
- Joints are degreased and dried.
- A sanitary silicone bead is laid and given a smooth tooled finish.
- Rooms reopen after the cure time.
Before we start on site
- Explain the parking and delivery arrangements
- Confirm the product named in the specification
- Warn occupants and staff about the work
Get a fixed quote
Need a figure for a tender or a budget? Send the scope and any drawings, and we will return a fixed quote that you can work with. If you have questions first, call 01277 525 020 or email drawings and photos.
Related advice
Commercial washrooms in Scourie
Scourie sits close to the coast, within about 1 mile, and seaside hospitality usually has a peak season that works washrooms hard. Washrooms used guest after guest wear their sanitary silicone faster, so resealing in the quieter months keeps rooms ready. Being in the west of Scotland, Scourie gets more rain than eastern areas. Where ventilation is poor, damp washrooms here tend to see black mould in the sealant sooner.
For a hotel such as Scourie Hotel, less than half a mile west of Scourie, resealing en suites a few rooms at a time keeps the rest available.
Scourie is in Highland. Anywhere in IV27, the process is the same: details in, fixed quote out, then sealing and a 12-month guarantee. Scourie is one of 256 places in Highland on our list.
Business premises anywhere in IV27 are within our area for washrooms and wet areas. Streets here include Moffat Square and Harbour Road, and sites on any of them can send details for a fixed quote. Nearby places we also cover include Scourie More (1 mile south-west), An Druim Beag (8 miles south), Kinlochbervie (8 miles north-east), Stor (12 miles south-west) and Stoer (12 miles south-west). Where a site is remote or on an island, travel and materials need planning ahead, so the full address helps from the start.
Local landmarks in Scourie
Not far away are Loch Bad nam Mult and Handa Island.
Quoting for work in Scourie
To price the job, we consider:
- Joint width, depth and condition
- Whether the work must be split into stages
- Quantities, in metres or numbers
- Whether old sealant has to be cut out first
There’s no price list, because the scope varies so much from one building to the next. For a fixed figure, call for a quote.
Before you send an enquiry
A few photographs plus some basic facts will normally do. It helps to include:
- Whether an asbestos survey exists
- Approximate linear metres or a joint schedule
- Specification clauses that apply
- When you need the work done
Specifications, drawings and tender packages are welcome with any enquiry, and we’ll price the work to it. For smaller jobs, photographs and a description will do.
Also near Scourie
What else we do in Scourie
Do you need washroom sealing in Scourie?
Warmth, moisture and soap residue are exactly what mould needs, and silicone joints hold onto all three. Anti-mould additives help, but in a poorly ventilated room mould can still take hold eventually.
Clients usually get in touch after noticing something like this:
- Split or peeling sealant at shower trays
- Resealing that didn’t last because the old bead stayed
- Panel joints letting water behind
- Stained sealant around pans and urinals
In any commercial washroom in or near Scourie, mouldy sealant is cut out rather than cleaned, and anti-mould sanitary silicone goes on clean, dry joints.
What your quote should include
- How they handle RAMS and site documents
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- The named product and why it was chosen
- Whether their applicators hold CSCS cards
What sealant work can’t fix
Before quoting, we check that sealant is the right answer. It isn’t the answer for:
- A dripping waste or valve behind a panel
- Hollow tiles or loose panels behind the joint
- Water escaping beneath the floor rather than through a joint
If you’re not sure, just call the office on 01277 525 020 or use the quote form and we will give you a straight answer.
Where we work in Scourie
- Showers, trays and wet room floors
- IPS panels and cubicles
- Urinals and WCs
- Vanity units and basins
- Accessible toilets and changing rooms
- Kitchens and tea points
Why it’s worth doing now in Scourie
Leaving the job until a shutdown often means living with it for months. With phasing, the work can go ahead while most facilities stay open. Renewing every failing joint on one visit is the sensible approach for a place like Scourie. Send photographs and we’ll quote for everything together.
Access can matter as much as the joints themselves: easy-to-reach joints are quicker than those that need equipment to get to. Mention the access as part of your enquiry.
Why us?
- Sealing commercial buildings since 2005
- Failed material removed, not covered up
- A Constructionline member, so easy to vet
- Specification-led, product-correct work
Read how commercial sealant jobs are priced and how we’re accredited.
Questions about Scourie
Will our hotel in Scourie need to close for the work?
Almost never. The work is phased so most rooms stay available. The plan is built around your bookings.
Will the toilets in our Scourie building be out of use?
Rarely all at once: work is phased so some facilities are always available. We will tell you the curing time for the product before we start.
Will you quote for a small job?
Whatever the size, the process is the same: send details, get a fixed quote, we seal, guaranteed.
What do you charge?
We don’t publish prices, as every site differs. Send photographs or drawings and we’ll price it at a fixed figure.
Who decides which product is used?
A specification, where there is one, decides it. Without one, the joint decides: its movement, its surfaces and what it has to cope with.
Can you follow the specification on our project?
Yes. Include it with the drawings when you ask for a quote, and the quote will be based on it, flagging anything that needs clarifying.
Are you CHAS accredited?
Yes. We’re CHAS accredited, we are a Constructionline member and we use CSCS-carded applicators.