Industrial and floor joint sealing in Bighton, Hampshire
Sealant work in Bighton for main contractors, managing agents and facilities managers: floor joint sealing and filling in warehouses, factories and industrial units, quoted at a fixed price.
- Old filler gone hard, cracked or loose
- Sealant pulled out along a truck route
- Saw-cut joints left open and packed with grit
Need floor joint sealing in Bighton?
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
General trades versus a specialist
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
For a quick touch-up, site staff may be fine, but anything bigger is another matter: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
About our floor joint sealing in Bighton
We have been sealing commercial joints since 2005. Our CSCS-carded applicators follow your site induction and rules, and we are CHAS accredited and a Constructionline member holding public liability insurance. Finished floor joints in Bighton carry our 12-month guarantee. We work on saw-cut induced joints, joints along racking aisles and construction joints, and what we’re called in for most is untidy open joints in a retail unit and dock area joints that have failed first. Whoever orders the work in Bighton, the brief is usually the same: a clear scope, tidy work and joints that don’t fail again.
Jobs around smaller places like Bighton are planned so the whole job is done in one visit, with the right materials on hand. Note joint widths and the traffic that uses them, and we will take it from there.
We sign every job off with a 12-month guarantee. It’s a plain promise: if the work we did fails within twelve months, we return to fix it.
- Place
- Bighton (SO24)
- Wider area
- Hampshire
- Cover
- 12 months on our workmanship
- Quotes
- Quoted before any work starts
- Phone
- 01277 525 020
- Updated
- 3 November 2026
On site: what to expect
Where the site stays busy, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then handed back before the next one starts. For a building around Bighton, tell us how to find it and who will meet us. Send that with the details and we will confirm the plan with the quote.
- We look at joint widths, edge condition and the traffic on each route.
- A fixed quote follows, listing the treatment for each area and the order of work.
- Old filler, debris and contamination are cut or routed out back to clean concrete.
- Dust is extracted from the joint and primer applied where the manufacturer specifies it.
- We fill each joint to depth and finish it flush so wheels roll straight across.
- Each phase reopens when the product is ready for wheels, then we start the next.
What we need from you
- Arrange parking or a loading space
- Point out any areas we must not close
- Let building users know which areas are affected
Ask for a quote
Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To ask for one, call the office on 01277 525 020 or send photos by email.
Related advice
Looking after the joints
Once the work is signed off, a little attention goes a long way:
- Allow for topping up joints as a new slab settles
- Mention any aggressive cleaning regime at quote stage
- Make joint checks part of your floor inspections
- Photograph any joint that starts to chip
Keep traffic off fresh joints until the time we give you, and it’s worth enforcing. Cones or barriers stop the first driver cutting the corner.
A broken joint on a main route is crossed by every truck on that route. Early treatment protects wheels, loads and drivers as much as the floor.
Traffic, movement and joints around Bighton
Bighton has two named business or industrial parks inside a 3-mile radius. That puts plenty of warehouse floors, service yards and car parks close by, all with joints under traffic. Bighton is in the South East, one of the UK’s drier regions. External joints still wait for dry conditions, while winter salting gets into any joint left open.
Phasing is what makes joint work possible on busy sites such as Lower Soldridge Business Park (2.6 miles east of Bighton): one bay, aisle or car park row at a time. Schools like Perins School often have long brick elevations with movement joints that age quietly. If you manage units on an estate such as Barton Industrial Estate, 2.5 miles north-east of Bighton, the floor joints under forklifts and pallet trucks and the slab joints in the yard are the ones to watch.
Bighton is about 7 miles south-west of Alton, in Hampshire. We cover commercial sites throughout Bighton, for single jobs and planned programmes alike. Across Hampshire, 723 places are covered, including Bighton. We also cover Southampton, around 17 miles from Bighton.
If you need floor joint sealing in SO24, the process matches everywhere else we work: send details, get a quote, we seal, guaranteed. Just outside Bighton, we also work in Old Alresford (1 mile west), Upper Wield (3 miles north-east), Northington (3 miles north-west), Totford (3 miles north-west) and Brown Candover (4 miles north-west). Further afield, our area takes in Basingstoke (11 miles north), Winchester (9 miles west), Eastleigh (13 miles south-west), Horndean (15 miles south), Chandler's Ford (14 miles south-west) and Alton (7 miles north-east).
Near you in Bighton
We work on buildings around Three Horseshoes Public House and the streets around them. Well-known places in the area include Barton Castle (2.4 miles north). Open spaces near Bighton include Red Hill.
What the job involves on each surface
Construction joints
Where a day joint crosses a truck route, its edges take heavy punishment. Movement and traffic are both checked before we decide what goes in.
Loading bays and dock areas
Joints at dock doors need a product that copes with the traffic and the conditions. Phasing is planned around your delivery schedule.
Nearby places to Bighton
What else we do in Bighton
Your questions answered
Will you take on work at estates like Barton Industrial Estate, close to Bighton?
Yes, sites like Barton Industrial Estate are within our area, along with the rest of Bighton. A few photographs and the unit address let us price the work.
Is a smaller place like Bighton outside your area?
No. Small places get the same service as large ones. Our area covers London and the South East counties. We plan jobs in smaller places so return trips are kept to a minimum.
Which sealant will you use?
The specification comes first, if there is one. Without one, the joint decides: its movement, its surfaces and what it has to cope with.
Can the warehouse stay open while you work?
We phase it. Areas are taken out of use a section at a time around the site hours and access windows you give us.
What site paperwork can you supply?
Each site asks for different documents, so list what you need, whether RAMS, insurance or CSCS details, and we will confirm with the quote.
What if there’s asbestos in the old mastic?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and work stops until any suspect material has been tested. We don’t remove asbestos-containing materials.
What do you need from us to quote?
Send details through our quote form or by email, with the traffic on each area. A fixed quote follows that shows the products and zones.
What affects the price in Bighton
What shapes the price:
- Working within restricted access windows
- Access and working height
- Induction, permit and paperwork requirements
- Location, for remote and island sites
Cost follows what’s involved: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a fixed quote and we’ll explain how it’s made up.
What we need to price the job
We can often quote from photos and a few details. It helps to include:
- When you need the work done
- Anything awkward about access or site hours
- What the building is and how it’s used
- Rough lengths or quantities, or drawings if you have them
Pricing a project or setting a maintenance budget? We’ll quote against your scope and drawings you can plan around. If you have questions first, speak to us on 01277 525 020 or use the quote form.
Why act early in Bighton
A floor coating laid over open joints soon cracks along the joint lines. Joints need their own treatment, whether or not the floor is coated. Converted and older buildings near places like Bighton tend to move, and aged sealant cracks. A sealant with the right movement capability, correctly sized, lasts far better.
Larger quantities, tricky access or phasing all shape the price. Site requirements like inductions and permits play a part as well.
Why appoint us
- 12-month guarantee on workmanship
- Clear, fixed quotes
- One number for every site we cover
- Fully insured, including public liability cover
See what affects the cost or our accreditations and insurance.