Fire-rated sealing and fire stopping in Torness, Highland
Looking for fire stopping in Torness? It’s simple: send details, get a quote, we seal, guaranteed.
- Openings found when ceilings come down for a refit
- Fire-rated sealant that has cracked or shrunk back
- Service penetrations left open after M&E works
Fire stopping for Torness sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Why act early in Torness
An open or wrongly sealed service penetration lets fire and smoke reach the next compartment much sooner than the building was designed for. Putting it right is normally a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Renewing every failing joint on one visit is the sensible approach for a place like Torness. Photos of each area help us quote the whole job.
What a job costs comes down to how many linear metres there are, how much old material needs removing and the access. Call for a fixed quote when you are ready.
Why us?
- Specification-led, product-correct work
- Old sealant cut out, never sealed over
- One number for every site we cover
- CSCS-carded applicators
Read how commercial sealant jobs are priced and how we’re accredited.
Fire stopping for commercial buildings in Torness
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. Each seal follows the manufacturer’s tested detail. If you are dealing with service penetrations left open after M&E works and fire seals cut back for extra cables and never reinstated, we can put it right, whatever the surface. One point of contact handles commercial sealant work in Torness from the first photos to the final walk-round, whether it’s one building or several.
In smaller Scottish places like Torness, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
Every job ends the same way: guaranteed. Our workmanship is backed for 12 months, and the quote explains what it covers.
- Location
- Torness (IV2)
- Region
- Highland
- Guarantee
- A 12-month guarantee
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
Towns and villages near Torness
More services for Torness
What sets the cost
Your fixed quote is built from the real scope. It takes account of:
- Access and working height
- Whether old sealant has to be cut out first
- The total length or number of joints
- Specialist products, such as fire-rated or hygienic sealants
No two sites price the same: joint size, product, access and site hours all play a part. Send the details and a fixed figure follows.
Before you send an enquiry
It doesn’t need to be a full survey. These details are enough to start:
- What the building is and how it’s used
- Photos of the joints, close up and from further back
- Specification clauses that apply
- The postcode of the building
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To start the process, phone 01277 525 020 or email drawings and photos.
Our process
Before we leave any area, we remove the tape, clean down and inspect every joint. Where the sealant needs time to cure before use, we tell you and sign the area. Jobs near Torness are often grouped with others in the same area, to make the most of each trip. Let us know if your dates have any give.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- We apply the specified sealant to the depth and around the services as the detail shows.
- If an opening needs something other than sealant, we tell you instead of improvising.
Preparing the site
- Let building users know which areas are affected
- Flag any permit to work we’ll need
- Point out parking and an unloading spot
Quotes
For a fixed quote, give us a call on 01277 525 020 or email a schedule or drawings. Our quote form is another easy route.
Read more
Common problems we fix in Torness
Damage plays a part too. Seals get knocked during maintenance, cut back to add a cable or pulled out when services are swapped.
What tends to prompt an enquiry:
- Improvised or mixed-product fire seals
- Builders’ foam or ordinary silicone in compartment walls
- Seals disturbed by maintenance and left open
- Fire sealant pulled out of the opening
Buildings near Torness get the fire-rated product that’s specified, installed to its tested detail.
Before you book anyone
- Their approach to joint depth and backing
- Whether primer will be used where the manufacturer specifies it
- Their pre-qualification and accreditations
- Can the work be phased to keep areas open?
Questions about Torness
Is Torness too small for you to travel to?
Not at all. Torness is within our area. Our area covers all of Scotland, cities, towns and islands alike. Good photographs up front let us bring everything on the first visit.
Do you decide the fire-stopping details for buildings in Torness?
No. The designer or fire engineer sets the detail and building control accepts it. Our part is installing the specified product to its tested detail, and telling you if the detail calls for something other than sealant.
Can you handle several sites?
Yes. A group of buildings can go on one quote, and you deal with one contact throughout.
Do your applicators hold CSCS cards?
Yes. Should the site need card details in advance, tell us and we’ll confirm them with the quote.
Can the sealant be colour-matched?
It depends on the product specified. Some ranges are wide, others limited, so the available colours are confirmed with the quote.
How long does a job like this take?
The duration is planned around your programme and the access we’re given. We’ll give you an estimate of time on site when we quote.
Are you CHAS accredited and on Constructionline?
Yes. CHAS accredited, Constructionline member, and our applicators hold CSCS cards.
Aftercare for building managers
A few simple habits keep the new joints working:
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Have penetrations checked while they can still be seen
- Include service cupboards in routine inspections
- Settle who seals which penetrations at the start of a project
During planned inspections, look at seals in risers, cupboards and voids. Look for cracks, unsealed new cables and gaps that have been enlarged.
Keep a register of where seals are and what they are made of. When a new service goes through, everyone knows which product and detail to match, and it helps at inspections.
Service penetrations in Torness buildings
Scottish guidance (non-domestic Technical Handbook, clause 2.1.14) asks that penetrations match at least the fire resistance period of the element they pass through, with proprietary products, intumescent ones included, tested for their end use. We install fire-rated sealant to that tested detail where it is specified.
For any site around Torness, we work to the specification and the manufacturer’s installation guidance, leaving design and sign-off with the designer.
Torness is about 12 miles south-west of Inverness, in Highland. We cover Torness and the rest of Highland, with the same fixed quotes and 12-month guarantee as everywhere else. Our Highland coverage takes in 256 places, from busy centres to rural villages. Sites around Dundee have their own page, roughly 78 miles from Torness.
We cover the IV2 postcode districts. Being close to the B862, Torness is straightforward for us to reach. Nearby places we also cover include Lewiston (4 miles west), Drumnadrochit (4 miles west), Dores (5 miles north), Gorthleck (6 miles south-west) and Farr (8 miles north-east) for service penetrations. Bigger towns within reach include Inverness (12 miles north-east), Cradlehall (14 miles north-east), Merkinch (12 miles north), Hilton (11 miles north-east), Crown (12 miles north-east) and Millburn (13 miles north-east). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you call the office on 01277 525 020 or email drawings and photos.
What’s near Torness
A little further out are Urquhart Castle (2.9 miles west) and Urquhart Castle Visitor Centre (3 miles west). Not far away are Loch Ceo Glais.
Owners, agents and contractors
Hotels, schools, healthcare sites, offices and retail units come to us directly as well. The work is planned around how the building runs, so guests, pupils, patients or staff are disturbed as little as possible.
If you look after buildings for someone else, you need clear quotes and clear reporting. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.