Fire stopping in Scadabhagh
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Scadabhagh and the surrounding area. Send photographs or drawings for a fixed quote.
- Openings found when ceilings come down for a refit
- Builders’ foam or ordinary silicone in compartment walls
- Old intumescent sealant that has split away
Fire stopping for businesses in Scadabhagh
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
What we’re called out for in Scadabhagh
When a seal departs from its tested detail, the evidence no longer covers it. Gaps beyond the tested size, shallow sealant, no backing where it was needed, or products from different systems mixed together are the usual culprits.
Typical triggers for a call:
- Unsealed openings around new pipes and cables
- Seals that don’t match their tested detail
- Unsealed penetrations discovered above suspended ceilings
- Seals disturbed by maintenance and left open
Buildings near Scadabhagh get the fire-rated product that’s specified, installed to its tested detail.
Comparing quotes
- Their plan for phasing and protecting the area
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- Whether old or failed sealant will be cut out, not overlaid
- What level of public liability insurance do they hold?
How we handle fire stopping in Scadabhagh
The test standards are BS EN 1366-3 for penetration seals and BS EN 1366-4 for linear joints, with results classified under BS EN 13501-2. A rating such as EI 60 only holds when the product is installed as it was tested. Reproducing the tested arrangement on site is the part we take care of. Site teams most often ask us about fire seals cut back for extra cables and never reinstated and fire-rated sealant that has cracked or shrunk back, on service gaps in risers, small duct penetrations where the tested detail allows and cable penetrations. A specialist sealant contractor works differently from a general builder: in Scadabhagh, that means joint design, primers and backing rod as standard.
For a building near Scadabhagh, we plan fire-rated sealing so it’s finished in one visit where possible. Photos of the gaps, the services and the wall or floor type help us bring the right products.
Every job we finish is backed by a 12-month workmanship guarantee, in Scadabhagh as everywhere else we work. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Where
- Scadabhagh (HS3)
- Region
- Na h-Eileanan Siar
- Cover
- A 12-month guarantee
- Quotes
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
How a job runs
Inspect, seal, sign off: every visit follows that pattern. First comes an inspection and agreement on scope, then the work is carried out to the specified product and detail, and we finish with a walk round so the work can be signed off. Where we can, we combine work around Scadabhagh with other jobs nearby. Let us know if your dates have any give.
- First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
Getting the site ready
- For older buildings, check the asbestos register before work
- Let building users know which areas are affected
- Tell us what induction or permit system the site runs
Ask for a quote
Tell us about the building, the joints and when you need the work done, and we’ll put a fixed quote together. To get it moving, call 01277 525 020 or email us.
Advice
Penetration seals near Scadabhagh
Scottish guidance (non-domestic Technical Handbook, clause 2.1.14) asks that penetrations match at least the fire resistance period of the element they pass through, with products tested for that end use. We install fire-rated sealant to that tested detail where it is specified. Island jobs, Scadabhagh among them, are planned around the ferry and the forecast. The specification and photographs of each penetration let us bring the right products first time.
Around Scadabhagh, fire-stopping design belongs to the designer and building control; installation to the specification is our part.
Scadabhagh (Gaelic: Scadabay) is in Na h-Eileanan Siar. Any commercial site in Scadabhagh is covered, for single jobs and planned programmes alike. Across Na h-Eileanan Siar, 87 places are covered, Scadabhagh among them.
Commercial sites across HS3 are covered. Just outside Scadabhagh, we also work in Plocrapool (1 mile north), Greosabhagh (1 mile west), Drinisiadar (1 mile north), Miabhaig (3 miles north-west) and Sgalpaigh (3 miles north-east). Where a site is remote or on an island, we plan travel and materials carefully.
Near you in Scadabhagh
Open spaces near Scadabhagh include Loch Laxdale.
Building owners, agents and FMs in Scadabhagh
Hotels, schools, healthcare sites, offices and retail units book us directly too. We plan around the way the building is used, so guests, pupils, patients or staff are disturbed as little as possible.
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, with each stage agreed with your site contact.
FAQs: Scadabhagh
Do you work on the island where Scadabhagh is?
Yes, Scadabhagh is within the area we cover. We work across every Scottish council area. We group island work where we can and plan around the crossings.
Can you produce the fire-stopping design for a job in Scadabhagh?
No. The designer or fire engineer sets the detail and building control accepts it. Our part is installing the specified product to its tested detail, and telling you if the detail calls for something other than sealant.
How long will the new sealant last?
There isn’t a single answer, because life depends on how much the joint moves, how exposed it is and how it’s cleaned and used. Regular inspection is the best way to catch problems early.
Can you handle several sites?
Yes. Several buildings can share a single quote, with one point of contact.
What do you charge?
That depends on the job: the volume of work, the access, the specified product and how it’s phased. Call for a quote and we’ll price it properly.
Will you just go over the old sealant?
No, never. Overlaying old sealant is a frequent cause of early failure, so everything comes out first.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and we will price the work to it.
Maintenance after handover
Problems stay small when the joints are checked regularly. Specifically:
- Check with the data sheet before painting over fire sealant
- Agree the fire-stopping specification before services go in
- Foam or ordinary sealant is never a fire-seal repair
- Look above ceilings when tiles are lifted for other jobs
Keep the product data and installation details with the building’s fire safety information. It makes later repairs much easier to match.
Make reporting new openings part of every permit to work in service areas. It costs little and catches breaches early.
Leave it or put it right?
An open or wrongly sealed service penetration lets fire and smoke reach the next compartment much sooner than the building was designed for. Putting it right is normally a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Renewing every failing joint on one visit is the sensible approach for a place like Scadabhagh. Photos of each area help us quote the whole job.
Larger quantities, tricky access or phasing all shape the price. So do site requirements such as inductions and permits.
Why clients in Scadabhagh choose us
- Fully insured
- Over 20 years of commercial sealing
- Work carried out by CSCS-carded applicators
- One number for every site we cover
Read our cost guide and how we’re accredited.
Towns and villages near Scadabhagh
Also in Scadabhagh
What sealant work can’t fix
Being straight saves everyone time. Fresh joints won’t solve:
- Fire risk assessments, a job for a competent assessor
- Gaps in walls that were never built as compartment walls
- Openings that need collars, wraps, batts or boards rather than sealant
If you are not sure, just give us a call on 01277 525 020 or send details through our quote form and we’ll give you a straight answer.
Surfaces we seal
- Cable penetrations
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Pipe penetrations
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads