Fire stopping in Noranside
Fire-rated and intumescent sealing of service penetrations and linear gaps in Noranside. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.
- Open linear gaps along the top of fire-resisting walls
- Fire-rated sealant that has cracked or shrunk back
- Service penetrations left open after M&E works
Fire stopping in Noranside
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Why deal with it now?
An open or wrongly sealed service penetration lets fire and smoke reach the next compartment much sooner than the building was designed for. Putting it right is normally a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Around smaller places like Noranside, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Resealing early avoids that.
A quote for service penetrations depends on how many there are, their condition and the access, plus any specification you are working to. Ask us for a fixed quote.
What you get with us
- Health and safety: CHAS accredited
- Fully insured
- Our applicators hold CSCS cards
- Work to your specification and the manufacturer’s guidance
How we handle fire stopping in Noranside
Most of our fire stopping work happens after the building is up. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind, and they are easy to forget. We close the openings listed on your schedule, using the specified sealant and detail. If you are dealing with expanding foam used as fire stopping and fire-stopping items raised at inspection or handover, we can put it right. For commercial sealant work in Noranside, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
Around smaller places such as Noranside, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Those penetrations are closed with the product the specification names, built up as tested.
A 12-month guarantee applies to all our work. If an installation problem shows up, phone 01277 525 020 or email the details over and we will arrange a return visit.
- Where
- Noranside (DD8)
- Region
- Angus
- Guarantee
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Call
- 01277 525 020
- Page updated
- 3 November 2026
When to call us in Noranside
Linear gaps fail where a fire-resisting wall meets a slab, soffit or another wall. Movement in the frame or slab can open the joint, and the wrong product can split as a result. The tested detail for a linear joint states the width and movement it covers.
Any of the following is a good reason to get the joints checked over:
- Fire stopping installed outside its tested range
- Unsealed joints where partitions meet the slab
- Fire-stopping items raised at inspection or handover
- Hidden openings found during inspections
At a healthcare site like Whitehills Hospital, which lies south of Noranside, new services through compartment walls are a constant, and each needs the specified seal.
Comparing quotes
- What site paperwork they can supply
- What the guarantee covers, and for how long
- Are they CHAS accredited or on Constructionline?
- Do they follow the manufacturer’s priming guidance?
When something else is needed
We check first that sealant really is the fix. It won’t put right:
- Approving the work on behalf of building control
- Reviewing a building’s overall fire safety
- Construction that lacks the fire resistance the seal relies on
Not sure which it is? You can give us a call on 01277 525 020 or send details through our quote form and we will tell you honestly.
What we seal
- Service gaps in risers
- Cable penetrations
- Joints between fire-resisting walls and floors
- Small duct penetrations where the tested detail allows
- Linear gaps at wall heads
- Pipe penetrations
FAQs: Noranside
Is Noranside off your patch?
No. Places such as Noranside are covered as much as the big towns. Our area covers all of Scotland, cities, towns and islands alike. Where we can, we group nearby jobs to make the most of each trip.
Can you work on a hospital site such as Whitehills Hospital?
Yes, healthcare and care buildings are part of our work. Before anything starts, the estates team agrees permits, inductions and infection-control measures with us.
Is your workmanship covered by a guarantee?
Yes, for 12 months. If our installation fails in that time, we return and fix it.
What changes on 2 September 2029?
From 2 September 2029, Approved Document B in England drops its references to BS 476 classes. The European route, BS EN 13501-2, then applies. Product selection stays with your designer.
Will you just go over the old sealant?
No. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
What do BS EN 1366-3 and BS EN 13501-2 mean?
Penetration seals are tested to BS EN 1366-3 and linear joint seals to BS EN 1366-4. Results are classified under BS EN 13501-2. That rating only holds when the product is installed to its tested detail.
Can you follow the specification on our project?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and any queries are raised before we start.
Owners, agents and contractors
As a CHAS accredited contractor and Constructionline member, we make supplier vetting simple. Our insurance certificate can be sent along with the quote.
Whether you’re a managing agent, a property factor or an owner’s representative: send the details, accept a fixed quote, and we carry out and guarantee the work. We can agree access arrangements and keyholder contacts beforehand.
What else we do in Noranside
Our process
Before we leave any area, the masking comes off, the area is cleaned and every joint is checked. Where the sealant needs time to cure before use, we tell you and sign the area. Travel to smaller Scottish places like Noranside is planned so the job is finished in one visit where possible, which is why we ask for photos and a full list first. External joints need a dry spell as well.
- First we confirm the product and tested details named in the specification.
- We sort the openings by the detail each one needs.
- Improvised fillers and failed sealant are removed.
- Mineral wool or other backing is fitted where required.
- We gun the sealant in to the specified depth around each service and tool it.
- Completed areas are checked with you, with the records agreed when we quoted.
Preparing the site
- For older buildings, check the asbestos register before work
- Make sure the joints can be reached
- Confirm the product named in the specification
Request a quote
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Send what you have, and we’ll arrange a site visit if anything is unclear.
Read more
Maintenance after handover
Keep the joints in good shape with a few simple steps:
- Agree the fire-stopping specification before services go in
- Keep product data and details in the fire safety file
- Check with the data sheet before painting over fire sealant
- Check risers and ceiling voids after each round of works
Once the seals are in, tell other trades they exist and must not be disturbed. Any seal cut back for a new service needs reinstating to its tested detail using the same product.
Looking at service areas on a regular cycle pays off. Catching a damaged seal early keeps the fix small.
Service penetrations in Noranside buildings
In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, with proprietary products, intumescent ones included, tested for their end use. We install fire-rated sealant to that tested detail where it is specified.
In a building such as Old Parish Church And Churchyard, any service penetration through a fire-resisting wall should be sealed to the specified detail.
Noranside is about 6 miles north of Forfar, in Angus. Commercial clients in Noranside use us for work on service penetrations. We work across 65 places in Angus, large and small. For work in that direction, see our Dundee page, about 18 miles away.
Anyone looking for fire stopping in DD8 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. Streets here include Oliver Avenue and Woodlands Avenue, and sites on any of them can send details for a fixed quote. Sites close to Noranside are covered too, including Tannadice (1 mile south), Aberlemno (4 miles south-east), Lunanhead (5 miles south), Forfar (6 miles south) and Padanaram (6 miles south-west). A short drive away, we cover Montrose (15 miles east), Kirriemuir (7 miles south-west), Brechin (8 miles east), Letham (8 miles south-east), Edzell (9 miles north-east) and Hillside (15 miles east).
Local landmarks in Noranside
Well-known places in the area include Vayne Castle (1.4 miles east) and Whitehills Hospital (5.7 miles south).