Midton fire stopping
Planning work on a service penetration in Midton? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Head-of-wall gaps with no fire seal
- Service penetrations left open after M&E works
- Old intumescent sealant that has split away
Fire stopping for Midton sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping for commercial buildings in Midton
For main contractors, our fire stopping package slots in after the M&E trades have finished in an area. To price a package, give us a call on 01277 525 020 or use the quote form with the schedule or marked-up drawings. Tell us what records you need and we’ll confirm with the quote. Most enquiries involve non-fire-rated filler around services and fire-rated sealant that has cracked or shrunk back, across small duct penetrations where the tested detail allows, linear gaps at wall heads and joints between fire-resisting walls and floors. Most enquiries from Midton start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Around smaller places such as Midton, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
Every job is signed off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Where
- Midton (PA19, PA16)
- Wider area
- Inverclyde
- Cover
- 12 months on every job
- Price
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Should maintenance staff do it?
Certain joints really need a specialist: fire-rated seals that must follow a tested detail, trafficked floor joints and external movement joints among them. A poor seal in places like these tends to cost more to put right later.
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
What we’re called out for in Midton
Damage plays a part too. Maintenance work can knock a seal, cut it back for an extra cable or remove it with an old pipe and the opening isn’t always resealed.
Clients typically get in touch after noticing something like this:
- Fire seals cut back for extra cables and never reinstated
- Unsealed joints where partitions meet the slab
- Improvised or mixed-product fire seals
- Fire-rated sealant that has cracked or shrunk back
In a hotel such as Spinnaker Hotel (less than half a mile north-west of Midton), new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
What to look for in a quote
- Health and safety accreditation such as CHAS
- The terms of the workmanship guarantee
- How the existing material will be dealt with
- Do they follow the manufacturer’s priming guidance?
On site: what to expect
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Joint faces are cleaned back to sound, dry surfaces, the manufacturer’s primer is applied where it’s called for, and the sealant is tooled off neatly. For a building near Midton, directions, keys and a contact on the day are worth sorting early. That goes into the plan alongside the quote.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Foam, ordinary sealant and debris come out.
- The specified backing and sealant go in to depth and are finished neatly.
- Anything outside the detail is reported to you rather than sealed.
Preparing the site
- Point out parking and an unloading spot
- Tell us which areas need to stay in use
- Make sure the joints can be reached
Request a quote
Tell us about the building, the joints and when you need the work done, and we’ll put a fixed quote together. The easiest way is to give us a call on 01277 525 020 or email us.
Related advice
FAQs: Midton
Can you work on a hospital site such as Inverclyde Royal Hospital?
Yes, provided the work is planned with the site’s estates team. Each area is agreed with the ward or department and the estates team in advance.
Is Midton off your patch?
No. Small places get the same service as large ones. Every Scottish council area is within our area. Send photographs and a list of what needs doing, and we will plan the job to need as few trips as possible.
How long will the new sealant last?
Nobody can honestly give a figure in years, because life depends on how much the joint moves, how exposed it is and how it’s cleaned and used. Regular inspection is the best way to catch problems early.
What happens if old sealant might contain asbestos?
Managing asbestos is the dutyholder’s responsibility, so we will ask for the register before work on an older building. If anything suspect turns up, we stop until it’s tested.
Is fire stopping in Scotland covered by different guidance?
Building standards in Scotland are separate from England’s, and England uses Approved Document B. Wherever the site is, our work follows the specification and the tested detail.
Is it fine to apply new sealant on top of old?
No. We cut the old material out and clean the joint back before sealing, because fresh silicone will not bond with aged silicone.
How many days will you need on site?
The duration is planned around your programme and the access we are given. We will give you an estimate of time on site when we quote.
Penetration seals near Midton
In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, with proprietary products, intumescent ones included, tested for their end use. Where fire-rated sealant is specified, that’s what we install, to the tested detail.
Shop fits in centres such as Oak Mall, 2.6 miles to the east of Midton, can bring new services through fire-resisting walls between units, which then need the specified seal. Hospital estates such as Inverclyde Royal Hospital (0.9 miles south-east of Midton) are divided into fire compartments, and any service penetration through them should be sealed to the specified, tested detail.
Midton is about 2 miles west of Greenock, in Inverclyde. We cover Midton, with the same fixed quotes and 12-month guarantee as everywhere else. Across Inverclyde, 19 places are covered, Midton among them. Our Glasgow page has more on work in that area, about 22 miles away.
Business premises anywhere in PA19 and PA16 are within our area. We cover commercial and managed buildings on Fife Road, Golf Road and Banff Road and the roads nearby. You’ll find Midton on or near the A770, so getting applicators and materials to site is simple. Just outside Midton, we also work in Ashton (1 mile south-west), Gourock (1 mile east), Trumpethill (1 mile west), Braeside (1 mile south) and Branchton (1 mile south-east). A short drive away, we cover Port Glasgow (6 miles east), Cartsdyke (3 miles east), Kilmacolm (9 miles south-east), Mid Auchinleck (7 miles east), Inverkip (3 miles south-west) and Bogston (5 miles east).
Landmarks near Midton
The nearest railway station is Gourock station, roughly 0.8 miles north-east of the centre. Other landmarks nearby include Oak Mall (2.6 miles east) and McLean Museum and Art Gallery (2.4 miles east). Green spaces nearby include Lyle Hill and Loch Loskin.
How the job changes by surface
Masonry and concrete
Core-drilled holes are neat; broken-out ones rarely are. The gap is measured at the widest point so we know it sits within the tested range, and any that don’t are flagged.
Drylining partitions
Service holes through plasterboard are frequently oversized or ragged. An oversized hole may be outside the sealant’s range and we will tell you what the detail says instead.
What happens if it’s left?
Sealing behind the M&E trades area by area beats a sweep at the end. While the area is still open, every opening is easy to see and reach and each detail can be checked as we go. Exposed buildings in Scotland take a lot of weather, and for a smaller place like Midton, a repair visit takes planning, so it’s better to act early.
A quote for service penetrations depends on quantities, condition and access, plus any specification you are working to. Ask us for a fixed quote.
Why clients in Midton choose us
- One contact handling all your sites
- A fixed quote before work starts
- Work to your specification and the manufacturer’s guidance
- Joints cleaned back to sound surfaces
Take a look at what affects the cost or our accreditations and insurance.
Honest limits
Some faults sit outside our scope, and we say so rather than covering them up:
- Writing the fire-stopping specification
- Openings that need collars, wraps, batts or boards rather than sealant
- Fire doors, dampers or other fire safety equipment
If in doubt, give us a call on 01277 525 020 or email a schedule or drawings and we’ll say what we think before you book.
Surfaces we seal
- Joints between fire-resisting walls and floors
- Small duct penetrations where the tested detail allows
- Cable penetrations
- Service gaps in risers
- Linear gaps at wall heads
- Pipe penetrations