Lower Burgate fire stopping
Sealant work in Lower Burgate for main contractors, managing agents and facilities managers: fire-rated and intumescent sealing of service penetrations and linear gaps, with a fixed quote first.
- Openings found when ceilings come down for a refit
- Open linear gaps along the top of fire-resisting walls
- Non-fire-rated filler around services
Fire stopping across Lower Burgate
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Questions about Lower Burgate
Is Lower Burgate off your patch?
No. Small places get the same service as large ones. We cover Greater London and the counties of the South East. Good photos up front let us bring everything on the first visit.
What does the BS 476 change mean for fire-rated sealant in Lower Burgate?
References to BS 476 classes are being removed from Approved Document B from 2 September 2029, after which BS EN 13501-2 classification is the route, subject to transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
What do you charge?
There isn’t a price list, as every site differs. Send photos or drawings and we will price it at a fixed figure.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and we will price the work to it.
Can you work while the building is occupied?
Yes, as long as we plan it. Tell us your site hours and access windows and we’ll plan around them.
How do you deal with asbestos in old sealant?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. We don’t remove asbestos-containing materials.
Is your workmanship covered by a guarantee?
Yes, for 12 months. If a joint fails because of how we installed it, we come back and put it right.
Fire stopping for commercial buildings in Lower Burgate
On a fit-out or refurbishment, we follow the services contractors floor by floor. To price a package, give us a call on 01277 525 020 or use the quote form with the schedule or marked-up drawings. Tell us what records you need and we will confirm with the quote. We work on small duct penetrations where the tested detail allows, pipe penetrations and linear gaps at wall heads, and the failures we are asked to look at most are penetration schedules that need working through and openings left by services added after handover. Most enquiries from Lower Burgate start with one failed joint and grow into a wider look at the building: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Around smaller places like Lower Burgate, penetration seals come up in schools, halls, pubs with rooms, care homes and farm buildings used as offices. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
Guaranteed is the last step of every job. You get a 12-month guarantee on our workmanship, and the quote explains what it covers.
- Location
- Lower Burgate (SP6)
- Region
- Hampshire
- Cover
- 12 months on every job
- Quotes
- Quoted before any work starts
- Call
- 01277 525 020
- Updated
- 3 November 2026
Leave it or put it right?
Open service penetrations matter on ordinary days, not just in a fire: smoke, noise and draughts pass through them every day. The specified fire seal closes the gap for all of these and the building feels the difference. Around Lower Burgate, it’s better to renew all the failing joints at once, rather than one at a time. Send photos of each area and we will quote for the lot.
There’s no price list, since every building and every scope is different. For a fixed figure, call for a quote.
Why choose Mastic Doctor in Lower Burgate
- 12 months’ guarantee on every job
- Fully insured, including public liability cover
- One number for every site we cover
- Fixed quotes based on photos, drawings or a visit
Take a look at what affects the cost or our accreditations and insurance.
Fire stopping around Lower Burgate: what changes locally
In England, Approved Document B covers fire stopping of openings and penetrations. Its BS 476 references are being withdrawn from 2 September 2029, with BS EN 13501-2 classification taking over, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail.
Older community buildings such as St Mary's Church that have been rewired or given new heating can have service gaps through walls worth checking against the specification. At a healthcare site like Fordingbridge Hospital, 0.8 miles south of Lower Burgate, new services through compartment walls are a constant, and each needs the specified seal.
Lower Burgate is in Hampshire. Businesses, contractors and managing agents in Lower Burgate use us for work on service penetrations, as part of our coverage of Hampshire. Our Hampshire coverage takes in 723 places, from busy centres to rural villages. Our Southampton page has more on work in that area.
Work on service penetrations is covered throughout SP6. Buildings on Kingfisher Drive, Grebe Place and Salisbury Road are within our area for service penetrations. Close to Lower Burgate, our area also takes in Tinkers Cross (1 mile west), Upper Burgate (1 mile north), Fordingbridge (1 mile south-west), Horseport (1 mile south) and Criddlestyle (1 mile south-east). Bigger towns within reach include Totton (12 miles east), Romsey (14 miles east), New Milton (14 miles south-east), Ringwood (6 miles south), Barton on Sea (15 miles south) and Marchwood (15 miles east).
Landmarks near Lower Burgate
Recent enquiries here include premises near Fordingbridge Infant School and The George Inn. Other landmarks nearby include Godshill Castle Hill (1 mile east) and Fordingbridge Museum (0.8 miles south). For a walk, there’s Blashford Lakes.
Do you need fire stopping in Lower Burgate?
A common fault is a product that was never fire-rated in the first place: expanding foam or a general-purpose sealant pushed into a gap to tidy it. It may look closed, but it has no tested fire performance in that position and has to be removed.
Most enquiries start with one or more of the following:
- Service penetrations left open after M&E works
- Hidden openings found during inspections
- Builders’ foam or ordinary silicone in compartment walls
- Improvised or mixed-product fire seals
In a hotel such as Greyhound Hotel, 0.8 miles to the south of Lower Burgate, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
What to look for in a quote
- How the joint faces will be prepared and primed
- Their pre-qualification and accreditations
- How the existing material will be dealt with
- Will CSCS-carded applicators be on site?
Should maintenance staff do it?
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
The visible bead is only part of the job. Backing rod, primer where specified and a joint designed to move with the building are where general trades tend to cut corners.
After the work
Keep the joints in good shape with a few simple steps:
- Report damaged or disturbed seals as soon as they’re spotted
- Settle who seals which penetrations at the start of a project
- Record which product was used where
- Include service cupboards in routine inspections
After the work, brief anyone else working in the area that the openings are now sealed. If a seal has to be opened for a new service, it should be reinstated to the same detail.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
From enquiry to sign-off
Before we leave any area, the masking comes off, the area is cleaned and every joint is checked with your site contact. Where the sealant needs time to cure before use, we tell you and sign the area. Rural sites near Lower Burgate may need directions, gate codes or a contact on site. Add it to your enquiry and we will build it into the plan.
- We read the specification, drawings or penetration schedule you send and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- We apply the specified sealant to the depth and around the services as the detail shows.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Tell us your opening times and when work is allowed
- Point out parking and an unloading spot
- Tell us which areas need to stay in use
Quotes
To get a fixed quote, call 01277 525 020 or use the quote form with the site address and an outline of the work. Our quote form is another easy route.
Read more
Nearby places to Lower Burgate
What else we do in Lower Burgate
Different surfaces, different methods
Cables and cable bundles
Single cables and small bundles are often within a fire-rated sealant’s tested detail. The detail limits bundle size and the gaps between and around cables, so we check before sealing.
Drylining partitions
Service holes through plasterboard are frequently oversized or ragged. If the gap exceeds the tested range, sealant alone won’t do and we’ll tell you what the detail says instead.