Fire Stopping in Inverinate
Work needed on a service penetration in Inverinate? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Unsealed joints where partitions meet the slab
- Fire-rated sealant that has cracked or shrunk back
- Fire-stopping items raised at inspection or handover
Need fire stopping in Inverinate?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Do you need fire stopping in Inverinate?
Physical damage is another reason seals stop doing their job. Maintenance work can knock a seal, cut it back for an extra cable or remove it with an old pipe and the opening isn’t always resealed.
These are often picked up first by site or facilities staff:
- Unsealed joints where partitions meet the slab
- Openings left by services added after handover
- Fire seals cut back for extra cables and never reinstated
- Unsealed penetrations discovered above suspended ceilings
In a hotel such as Kintail Lodge Hotel, 1.1 miles south-east of Inverinate, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
What to look for in a quote
- Will failed sealant be removed rather than covered?
- Whether primer will be used where the manufacturer specifies it
- Who will actually carry out the work
- How they’ll work around occupants
Fire stopping for commercial buildings in Inverinate
Penetration seals are fire tested to BS EN 1366-3 and linear joint seals to BS EN 1366-4, with results classified under BS EN 13501-2. A rating such as EI 60 only holds when the product is installed as it was tested. So our job is to reproduce that arrangement faithfully. If you have fire-rated sealant that has cracked or shrunk back and damaged fire seals in risers and voids, we can put it right. Whether you call it commercial sealant work, mastic application or joint sealing, the work in Inverinate is the same: failed joints cut out, faces prepared and the right sealant laid to the right depth.
For a building near Inverinate, we plan fire-rated sealing so it’s finished in one visit where possible. Photos of the gaps, the services and the wall or floor type help us bring the right products.
The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we’re clear about what is covered before work starts.
- Place
- Inverinate (IV40)
- Wider area
- Highland
- Guarantee
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
Why it’s worth doing now in Inverinate
Inspections and handover checks often pick up fire stopping. Late discoveries can delay handover while openings are reopened and resealed, so earlier action pays back. Renewing every failing joint on one visit is the sensible approach for a place like Inverinate. Send photos and we will quote for everything together.
Whether it’s a single area or a whole estate, the same things set the price: scope, access, product and programme. Call for a quote, and you will have a fixed figure to work with.
Why choose Mastic Doctor in Inverinate
- Failed material removed, not covered up
- Commercial sealant work since 2005
- Products installed to the manufacturer’s instructions
- CHAS accredited contractor
Places near Inverinate
What else we do in Inverinate
What the job involves on each surface
Risers and ceiling voids
Voids hide a lot of unsealed openings. We follow your schedule area by area, and note anything we find that isn’t on it.
Drylining partitions
Plasterboard partitions are tested as a specific construction. The sealant detail has to be tested in that wall type, with the stated board layers.
What we can’t put right
Some faults sit outside our scope, and we point that out rather than sealing over them:
- Issuing fire ratings or certificates for seals
- Fire risk assessments, a job for a competent assessor
- Gaps in walls that were never built as compartment walls
If in doubt, give us a call on 01277 525 020 or email the details over and we’ll say what we think.
Surfaces we seal
- Cable penetrations
- Service gaps in risers
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Pipe penetrations
- Small duct penetrations where the tested detail allows
Inverinate: questions and answers
Is Inverinate off your patch?
Not at all: smaller places are covered as well as towns. We cover the whole of Scotland. We plan jobs in smaller places so return trips are kept to a minimum.
Can you seal penetrations in a hotel in Inverinate after a refit?
Yes, to the specification and the product’s tested detail. Each seal follows the tested detail, and rooms are done in turn.
What site paperwork can you supply?
Tell us what site paperwork you need (RAMS, insurance certificate, CSCS details) and we will confirm with the quote.
Do you hold CHAS accreditation?
Yes. We are CHAS accredited, we are a Constructionline member and we use CSCS-carded applicators.
What will the job cost?
We don’t publish prices, because every site is different. Send photographs or drawings and we’ll price it at a fixed figure.
How long does a job like this take?
The duration is planned around your programme and the access we’re given. We will give you an estimate of time on site when we quote.
Do you seal on top of existing sealant?
No. Failed sealant is removed and the faces cleaned back to sound, dry material first, because fresh silicone will not bond with aged silicone.
Fire stopping in Inverinate: the local picture
Inverinate has a number of hotels close by, all within 2 miles. Bedroom-to-corridor walls in hotels are normally fire-resisting, so new cabling or pipework through them has to be sealed to the tested detail. Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with products tested for that end use. Our part is installing the specified fire-rated sealant to its tested detail.
Halls and meeting rooms at places like Kintail Parish Church sometimes gain new services, and any compartment wall crossed needs the specified seal.
Inverinate is in Highland. Any commercial site in Inverinate is covered. We work across 256 places in Highland, large and small.
We take on service penetrations across the IV40 postcode area, for business premises of every kind. Just outside Inverinate, we also work in Shiel Bridge (2 miles south), Dornie (4 miles north-west), Bundalloch (5 miles north-west), Carndu (5 miles north-west) and Glen More (6 miles west). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so give the site location in your enquiry.
Near you in Inverinate
Other landmarks nearby include Eilean Donan Castle (4.2 miles north-west). Not far away are Loch Shiel and Sgùrr an t-Searraich.
How a job runs
The first thing on site is a walk round with your contact, to confirm the scope, the order of work and any areas we must keep clear. After that, any old or failed material is removed, each joint is prepared and the new sealant goes in. For a building near Inverinate, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We read the specification, drawings or penetration schedule you send and raise any questions before we price.
- On site, each opening is checked against the tested detail it is meant to follow.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Tell us which areas need to stay in use
- Tell us what induction or permit system the site runs
- Clear stock, furniture or equipment away from the joints
Getting a fixed quote
Every quote starts with the facts: what’s there, how much of it, how we reach it and what’s specified. Send what you have, and we’ll arrange a site visit if anything is unclear.
Read more
Cost factors for service penetrations
Before we quote, we look at:
- Phasing around occupants
- Which sealant the job calls for
- The site’s rules and procedures
- Joint width, depth and condition
A quote for service penetrations depends on quantities, condition and access, plus any specification you’re working to. Call for a quote.
What we need to price the job
For an accurate fixed quote, we need a clear picture of the site. Useful things to include:
- Clear photos of the problem areas
- Rough lengths or quantities, or drawings if you have them
- The product your specification calls for
- When you need the work done
To get a fixed quote, phone 01277 525 020 or send details through our quote form. You can also send details through our quote form.