Duror fire stopping
Work needed on a service penetration in Duror? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Builders’ foam or ordinary silicone in compartment walls
- Openings left by services added after handover
- Damaged fire seals in risers and voids
Fire stopping across Duror
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
How we handle fire stopping in Duror
Opened ceilings and riser doors often reveal service openings nobody sealed. Where the walls and floors already have a fire-stopping specification, we can work to it. Where there isn’t one, the designer or fire engineer needs to set one first. We work on small duct penetrations where the tested detail allows, service gaps in risers and pipe penetrations, and what we’re called in for most is openings found when ceilings come down for a refit and expanding foam used as fire stopping. Most enquiries from Duror start with one failed joint and grow into a wider look at the building: we look at the rest while we’re there and tell you what we find.
Around smaller places such as Duror, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
The 12-month guarantee covers our workmanship: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Location
- Duror (PA38)
- Region
- Highland
- Guarantee
- A 12-month guarantee
- Price
- A fixed quote before we start
- Call
- 01277 525 020
- Updated
- 3 November 2026
What happens if it’s left?
Open service penetrations matter on ordinary days, not just in a fire: smoke, noise and draughts pass through them every day. Sealing them to the specified detail deals with the fire risk first. Exposed buildings in Scotland take a lot of weather, and for a smaller place like Duror, a repair visit takes planning, so it’s better to act early.
The product called for affects the cost, and so does the preparation, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
Why choose Mastic Doctor in Duror
- Failed material removed, not covered up
- One contact handling all your sites
- CHAS accredited
- Work carried out by CSCS-carded applicators
See what affects the cost and our accreditations and insurance.
Towns and villages near Duror
Also in Duror
Duror: questions and answers
Is Duror off your patch?
No. Places such as Duror are covered as much as the big towns. We work across every Scottish council area. Good photos up front let us bring everything on the first visit.
What do Scotland’s building standards say about service penetrations in Duror?
Under Scotland’s non-domestic Technical Handbook (clause 2.1.14), service penetrations should keep at least the wall or floor’s fire resistance duration, using products tested for their end use. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
What if there’s asbestos in the old mastic?
The duty to manage asbestos sits with the building’s dutyholder, so we will ask for the register before work on an older building. Work pauses if suspect material is found, until it has been tested.
What’s the quickest route to a quote?
There are four steps: send details, receive a fixed quote, we carry out the work, and it’s guaranteed. The first step only needs photographs and a postcode.
How long do sealant joints last?
There’s no fixed lifespan: movement, exposure, cleaning, traffic and the product all play a part. Treat them as maintenance items and inspect them regularly.
Do your applicators hold CSCS cards?
Yes. If you need card details for site access, let us know and we will send them with the quote.
Will you come and look before quoting?
It depends on the job. Straightforward work can often be priced from photographs and measurements, while larger or less clear jobs get a site visit first.
Our process
Tell us your site hours and access windows and we will plan around them. While we’re working, the area stays contained and tidy, and your contact hears from us before we move to the next area. For a building near Duror, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- The specification and schedule come first, so we know which details apply.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned so the seal starts clean.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
What we need from you
- Flag any permit to work we’ll need
- Send asbestos survey details if the building is pre-2000
- Point out any areas we must not close
Quotes
Send us photos, drawings or a joint schedule and a fixed quote comes back to you. If the job needs a look first, we’ll arrange a site visit.
Related advice
For managing agents and facilities managers
Hospitality, education, healthcare, office and retail clients come to us directly as well. We plan around the way the building is used, so guests, pupils, patients or staff are disturbed as little as possible.
Whether you are a managing agent, a property factor or an owner’s representative: send the details, accept a fixed quote, and we carry out and guarantee the work. We can agree access arrangements and keyholder contacts beforehand.
What the job involves on each surface
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access to these areas is planned with you in advance.
Drylining partitions
Service holes through plasterboard are frequently oversized or ragged. If the gap exceeds the tested range, sealant alone won’t do.
When something else is needed
Before quoting, we check that sealant is the right answer. It won’t put right:
- Construction that lacks the fire resistance the seal relies on
- Plastic pipes whose detail calls for a collar or wrap
- Signing off or certifying a building’s fire stopping
Not sure which it is? You can call the office on 01277 525 020 or email drawings and photos and we will tell you honestly.
Joints and surfaces we work on
- Cable penetrations
- Linear gaps at wall heads
- Joints between fire-resisting walls and floors
- Service gaps in risers
- Pipe penetrations
- Small duct penetrations where the tested detail allows
When to call us in Duror
Most open service penetrations are left by later work. New cabling, rerouted pipework or a data route drilled through a riser can leave the hole behind. Over a few years of fit-outs, a wall can collect a lot of these.
Any of the following is a good reason to get the joints checked over:
- Unsealed openings around new pipes and cables
- Improvised or mixed-product fire seals
- Old intumescent sealant that has split away
- Unsealed joints where partitions meet the slab
Halls and meeting rooms at places like St Adamnan's Episcopal Church sometimes gain new services, and any compartment wall crossed needs the specified seal.
What to look for in a quote
- Who will actually carry out the work
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- How they handle RAMS and site documents
- How they’ll work around occupants
Where services cross fire walls in Duror
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, and products should be tested for their end use. Where fire-rated sealant is specified, that’s what we install, to the tested detail.
Hotels such as Stewart Hotel, under half a mile south of Duror, rely on fire-resisting walls between bedrooms and corridors, and refits that add services leave penetrations to seal where fire-rated sealant is specified.
Duror is in Highland. We cover commercial sites throughout Duror, for single jobs and planned programmes alike. Duror is one of 256 places in Highland on our list. Glasgow is covered too, around 67 miles from Duror.
Work on service penetrations is covered throughout PA38, whatever the building. Nearby places we also cover include Kentallen (2 miles north-east), Clo Mhuillin (5 miles north), Corran (5 miles north), Inchree (5 miles north) and Ballachulish (6 miles east) for service penetrations. Nearby towns on our patch include Fort William (13 miles north-east), Caol (15 miles north-east), Inverlochy (14 miles north-east) and Kinlochmore (13 miles east). Where a site is remote or on an island, travel and materials need planning ahead.
What’s near Duror
For a walk, there’s Ardsheal Hill.