The Mastic Doctor team standing beside their branded vans outside an office building
East Ayrshire · Scotland

Fire stopping in Drongan

Fire-rated and intumescent sealing of service penetrations and linear gaps in Drongan. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.

  • Fire-stopping items raised at inspection or handover
  • Builders’ foam or ordinary silicone in compartment walls
  • Seals that don’t match their tested detail
1
Send details
Drawings, photos, a joint schedule or a site visit.
2
Get a quote
A fixed quote for the work, with the scope in writing.
3
We seal
The right sealant, to the right depth, neatly finished.
4
Guaranteed
12-month guarantee on our workmanship.
London, the South East & Scotland
Constructionline member
£5m public liability

Fire stopping across Drongan

Photos, a specification or a quick description of the joints is enough to start a fixed quote.

Fire stopping in Drongan

The test standards are BS EN 1366-3 for penetration seals and BS EN 1366-4 for linear joints, with results classified under BS EN 13501-2. That classification, such as EI 60 or EI 120, belongs to the product in its tested arrangement. Reproducing the tested arrangement on site is the part we take care of. If you have unsealed penetrations discovered above suspended ceilings and fire stopping installed outside its tested range, we can put it right, whatever the surface. Whoever orders the work in Drongan, the brief is typically the same: a fixed quote, no surprises on site and a 12-month guarantee behind the result.

In smaller Scottish places like Drongan, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.

A 12-month guarantee applies to all our work in East Ayrshire. Should something we installed fail, call 01277 525 020 or email the details over and we’ll come back to it.

Location
Drongan (KA6)
Wider area
East Ayrshire
Cover
12 months on every job
Quote
Fixed quote, scope in writing
Call
01277 525 020
Updated
3 November 2026
The Mastic Doctor team standing beside their branded vans outside an office building

What sets the cost

These are the things that shape the price:

  • The size and state of each joint
  • How much there is to seal
  • Access and working height
  • Induction, permit and paperwork requirements

Cost follows what’s involved: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a quote and we’ll explain how it’s made up.

What we need to price the job

There’s no need for a formal survey. A few details are enough to get going:

  • Rough lengths or quantities, or drawings if you have them
  • Your programme or deadline
  • Asbestos survey details if the building is older
  • Anything awkward about access or site hours

Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To ask for one, ring 01277 525 020 or send photos by email.

Penetration seals near Drongan

Scottish guidance (non-domestic Technical Handbook, clause 2.1.14) asks that penetrations match at least the fire resistance period of the element they pass through, with products tested for that end use. We install fire-rated sealant to that tested detail where it is specified.

On a hospital site such as Ailsa Hospital, 5.1 miles west of Drongan, fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits. Buildings near Drongan get the fire-rated product that’s specified, installed to its tested detail.

Drongan is about 6 miles east of Ayr, in East Ayrshire. Businesses, contractors and managing agents in Drongan use us for work on service penetrations, as part of our coverage of East Ayrshire. Our East Ayrshire coverage takes in 56 places, large and small. We also cover Glasgow, some 30 miles away.

Commercial sites across KA6 are covered. Streets here include Hannahston Avenue, Glencraig Street and Mill of Shield Road, and sites on any of them can send details for a fixed quote. We also cover Millmannoch (1 mile west), Coalhall (1 mile north), Hillhead (2 miles north-west), Hayhill (2 miles south-east) and Sinclairston (2 miles south-east). Further afield, our area takes in Kilmarnock (12 miles north), Cumnock (8 miles east), Annanhill (12 miles north), Galston (12 miles north), Mauchline (6 miles north-east) and New Farm Loch (13 miles north).

Near you in Drongan

A little further out are Ailsa Hospital (5.1 miles west) and Drongan Castle (0.5 miles south-east). Not far away are Lochend Loch.

Map of Drongan © OpenStreetMap contributors

Maintenance after handover

Keep the joints in good shape with a few simple steps:

  • Report damaged or disturbed seals as soon as they’re spotted
  • Check with the data sheet before painting over fire sealant
  • Keep general-purpose fillers away from compartment walls
  • Brief every trade that openings they make must be sealed

New services after handover are a common way fire stopping gets breached. Building it into each contractor’s sign-off keeps the walls intact.

Write fire stopping into the scope of any work crossing a compartment wall or floor. Then the seal goes in while the area is open.

Questions we are asked in Drongan

Which Scottish guidance covers penetration seals in Drongan?

Scotland’s non-domestic Technical Handbook covers it in clause 2.1.14: penetrations keep at least the element’s fire resistance duration, with products tested for their end use. The detail is set by the designer and goes through the warrant process; we install the specified product to its tested detail.

Do you take on work at healthcare sites like Ailsa Hospital?

Yes. We work in healthcare settings as well as offices and schools. We follow the site’s permits, sign-in and infection-control procedures in every area.

What will the job cost?

There isn’t a price list, because every site is different. With photographs or drawings, we can give you a fixed quote.

What about RAMS and site documents?

Each site asks for different documents, so tell us what you need and we will confirm it when we quote.

Can staff carry on working while you’re here?

Yes, as long as we plan it. We agree a sequence with your contact so just one area at a time is disrupted.

How long does a job like this take?

The duration is planned around your programme and the access we’re given. We’ll give you an estimate of time on site when we quote.

How long do sealant joints last?

Nobody can honestly give a figure in years, because life depends on how much the joint moves, how exposed it is and how it’s cleaned and used. Regular inspection is the best way to catch problems early.

Different surfaces, different methods

Small ducts

Ducts are only sealed with sealant where the detail allows it. The ductwork, its supports and any dampers are for the ductwork contractor.

Metal pipes

Sealant details often cover copper and steel pipework. Pipe diameter, annular gap, sealant depth and any pipe insulation all have to match the detail and we confirm each before sealing.

Diagnose, treat, sign off

We follow your site rules from the start: signing in, inductions and any permit to work. Once we’re cleared to begin, the joints are worked through in the order agreed with your site contact, and each area is checked before we leave it. For work around Drongan, we aim for one trip, so photos, sizes and a full list matter. External joints need a dry spell as well.

  1. First we go through the drawings, schedule or specification for the seals.
  2. Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
  3. Unsuitable fillers and loose debris are taken out of each opening.
  4. We fit the backing the detail asks for, to the stated depth.
  5. Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
  6. Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.

Preparing the site

  • Point out parking and an unloading spot
  • Point out any areas we must not close
  • Let us know about inductions and permits

Quotes

Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.

Get a quick quote

Related advice

Should maintenance staff do it?

The visible bead is only part of the job. Backing rod, primer where specified and a joint designed to move with the building are where general trades tend to cut corners.

Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.

What we can’t put right

A few problems need another trade or a different fix, and we point that out rather than sealing over them:

  • Deciding what a wall or floor needs, which belongs to the designer
  • Approving the work on behalf of building control
  • Reviewing a building’s overall fire safety

If you’re not sure, just speak to us on 01277 525 020 or send photos by email and we’ll give you a straight answer.

Surfaces we seal

  • Small duct penetrations where the tested detail allows
  • Linear gaps at wall heads
  • Cable penetrations
  • Service gaps in risers
  • Joints between fire-resisting walls and floors
  • Pipe penetrations
Accreditations

Trusted. Accredited. Insured.