Fire stopping in Balemartine
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Balemartine. Send photos or drawings for a fixed quote.
- Unsealed joints where partitions meet the slab
- Damaged fire seals in risers and voids
- Builders’ foam or ordinary silicone in compartment walls
Fire stopping for Balemartine sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
What happens if it’s left?
Leave a penetration open and smoke and fire can cross into the next compartment far earlier than intended. While the openings can be reached, sealing them is normally straightforward. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Renewing every failing joint on one visit is the sensible approach for a place like Balemartine. Photos of each area help us quote the whole job.
The product called for affects the cost, and so does the preparation, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
Why clients in Balemartine choose us
- CHAS accredited contractor
- A Constructionline member, so easy to vet
- Public liability insurance in place
- Workmanship guaranteed for 12 months
See how commercial sealant jobs are priced and our accreditations and insurance.
About our fire stopping in Balemartine
Our applicators are CSCS-carded, and we are CHAS accredited and a Constructionline member. We don’t hold a third-party fire-stopping installer certificate and we’d rather say that up front. We install the specified fire-rated sealant to its tested detail, and our workmanship carries a 12-month guarantee. Most enquiries involve expanding foam used as fire stopping and open linear gaps along the top of fire-resisting walls, on pipe penetrations, service gaps in risers and linear gaps at wall heads. Sealant contractors, mastic applicators, sealant specialists: whatever the job title on the order, the work in Balemartine is the same: the right product in a properly prepared joint.
In smaller Scottish places like Balemartine, buildings with fire-resisting walls typically include schools, care homes, hotels and health centres. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
What our 12-month guarantee covers is the way we did the job: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Location
- Balemartine (PA77)
- Wider area
- Argyll and Bute
- Cover
- 12 months on our workmanship
- Quotes
- Quoted before any work starts
- Call
- 01277 525 020
- Last updated
- 3 November 2026
What else we do in Balemartine
Compartments and services around Balemartine
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, using products tested for the way they’re used. We install what’s specified, to the product’s tested detail.
Around Balemartine, fire-stopping design belongs to the designer and building control; installation to the specification is our part.
Balemartine is in Argyll and Bute. Commercial clients in Balemartine use us for work on service penetrations, as part of our coverage of Argyll and Bute. Across Argyll and Bute, 124 places are covered, including Balemartine.
Anyone looking for fire stopping in PA77 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. Main routes into Balemartine include the B8066. If your building is just outside Balemartine, we cover Balephuil (1 mile west), Crossapol (2 miles north-east), Scarinish (5 miles north-east), Arinagour (18 miles north-east) and Baile Mòr (21 miles south-east). Remote and island addresses take more planning, from travel and ferries to the weather, so mention the location when you call the office on 01277 525 020 or send details through our quote form.
Landmarks near Balemartine
Well-known places in the area include Skerryvore Lighthouse Museum (1.3 miles south). For a walk, there’s Ben Hynish and Loch Gàrradh a' Chapaill.
On site: what to expect
Before any cutting starts, the area is protected: masking tape along the joint edges and sheeting over anything nearby. The work itself typically takes a single visit for a short list of penetrations, or a phased programme for a whole building, and we clear our waste as we work. Travel to smaller Scottish places like Balemartine is planned so the job is finished in one visit where possible, which is why we ask for photographs and a full list first. Outside work also needs a suitable weather window.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- Each opening is checked for wall or floor type, service, gap and depth.
- Foam, ordinary sealant and debris come out so the seal starts clean.
- The specified backing and sealant go in to depth and are finished neatly.
- Anything outside the detail is reported to you rather than sealed.
Preparing the site
- Let us know about inductions and permits
- Tell us your opening times and when work is allowed
- Arrange parking or a loading space
Getting a fixed quote
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. Where a site visit makes more sense, we will arrange one.
Related advice
Looking after the joints
Problems stay small when the joints are checked regularly. Specifically:
- Report damaged or disturbed seals as soon as they’re spotted
- Foam or ordinary sealant is never a fire-seal repair
- Make fire stopping part of every scope that crosses a fire-resisting wall
- Agree the fire-stopping specification before services go in
New services after handover are a common way fire stopping gets breached. Building it into each contractor’s sign-off keeps the walls intact.
Make reporting new openings part of every permit to work in service areas. Small habits like this stop openings building up.
Doing it in-house
Redoing a failed joint normally costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
Using site staff can make sense for a small touch-up, but larger jobs are different: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
FAQs: Balemartine
Do you design the fire stopping for buildings in Balemartine?
No. Fire-stopping design and sign-off belong to the designer, principal designer, fire engineer or building control. We install what’s specified, to the product’s tested detail.
Is Balemartine off your patch?
Not at all. Balemartine is within our area. We work across every Scottish council area. Send photographs and a list of what needs doing, and we will plan the job to need as few trips as possible.
Do you take on small jobs?
Small jobs are welcome alongside larger packages. Send details for a fixed quote.
How long does a job like this take?
We plan the time on site around your programme and access. You will have an expected duration with the quote.
Can the building stay open while you work?
Yes, with some planning. Tell us your site hours and access windows and we will plan around them.
What happens if old sealant might contain asbestos?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. Before we disturb old sealant in an older building, we ask to see the asbestos register or survey, and if asbestos is suspected, work stops until it’s tested. We don’t remove asbestos-containing materials.
Can the sealant be colour-matched?
It depends on the product. Some ranges offer many colours, others very few, so we will confirm the colours available for the specified product with the quote.
What sets the cost
These are the things that shape the price:
- Backing rod, priming and other preparation
- Which sealant the job calls for
- Location, for remote and island sites
- Site requirements such as inductions and permits
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we’ll put a fixed figure on it.
Before you send an enquiry
Diagnosis starts before we arrive. Let us know:
- The site address and postcode
- When you need the work done
- Asbestos survey details if the building is older
- Drawings or a marked-up plan, if available
A handful of photos and a postcode is the fastest way to a quote. Upload them with the quote form, or speak to us on 01277 525 020 or email the details over if you’d rather talk the job through.
Signs you need fire stopping in Balemartine
Plenty of openings were simply never closed because they sat out of sight above a ceiling or inside a riser. They come to light during inspections, refits or when another trade lifts a tile.
If one of these sounds familiar, it’s time for a closer look:
- Hidden openings found during inspections
- Builders’ foam or ordinary silicone in compartment walls
- Seals disturbed by maintenance and left open
- Fire-stopping items raised at inspection or handover
Buildings near Balemartine get the fire-rated product that’s specified, installed to its tested detail.
Questions to ask before you book
- Proof of insurance
- Do they follow the manufacturer’s priming guidance?
- Health and safety accreditation such as CHAS
- The terms of the workmanship guarantee