Sealant applicators in Stenness
Commercial sealant work in Stenness for contractors, FMs and building owners: sealant work for offices, shops, hotels and other commercial buildings, quoted at a fixed price.
- Wall and floor joints that have lost their seal
- Black mould through washroom sealant that won’t clean off
- External beads that have gone brittle and cracked
Need commercial sealant contractors in Stenness?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
What affects the price in Stenness
Before we quote, we look at:
- How much existing material needs removing
- Site requirements such as inductions and permits
- Travel to remote or island sites
- Phasing around occupants
The specified product makes a difference, as does the preparation each joint needs. Access, phasing and site requirements come into it too.
Sending details for a quote
It doesn’t need to be a full survey. A few details are enough to get going:
- What the building is and how it’s used
- Where the site is, with the postcode
- Specification clauses that apply
- Approximate linear metres or a joint schedule
To get a fixed quote, call the office on 01277 525 020 or use the quote form, telling us the site location and the nature of the job. You can also send details through our quote form.
About our commercial sealant contractors in Stenness
A reseal stands or falls on the preparation underneath it. Old silicone gives new sealant nothing to grip, so every trace of it is removed, then both faces are cleaned back to sound, dry material with no dust or grease on them. Primer is used wherever the manufacturer calls for it on that surface, and a backing rod limits the depth to give the sealant room to work. If you have frame mastic that has hardened and come away from the wall and external beads that have gone brittle and cracked, we can put it right. Searching for sealant specialists in Stenness? Mastic Doctor has worked for contractors, FMs and building owners since 2005.
A lot of what we do in Stenness is replacing sealant that has done its years: split, chalky or peeling, with leaks or mould starting behind it.
In smaller Scottish places like Stenness, commercial buildings are often hotels, pubs, shops, schools, surgeries and farm or estate buildings put to new use. Each has kitchens, washrooms and frames that depend on sound joints.
The 12-month guarantee is for workmanship rather than wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we spell out the cover before we begin.
- Place
- Stenness (KW16)
- Region
- Orkney Islands
- Cover
- 12 months on every job
- Price
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Working on commercial sites near Stenness
Stenness is within about 1 mile of the coast. Shopfronts, frames and external joints on commercial buildings there take wind-driven rain and, closer to the shore, salt in the air. We choose a product rated for the exposure, then confirm the colours available for it. Work on Stenness has to fit the ferry timetable and the forecast. Send photos, a complete list and any colour references first, so nothing is left behind.
In hotels such as Standing Stones Hotel, which lies west of Stenness, refurbishments normally mean bathroom, bar and reception joints where a matched sealant colour has to sit with the finishes.
Stenness is about 9 miles west of Kirkwall, in the Orkney Islands. Anywhere in KW16, the process is the same: send details, get a fixed quote, we seal, and the work is guaranteed. Across the Orkney Islands, 51 places are covered, including Stenness.
Commercial sites across KW16 are covered for sealant joints. Just outside Stenness, we also work in Clouston (1 mile south-west), Grimeston (2 miles north), Germiston (2 miles east), Cairston (2 miles west) and Wasbister (3 miles north-west). For island and remote sites, we plan travel and materials carefully, so include the location in your enquiry.
Local landmarks in Stenness
A little further out are Stromness Museum (3.8 miles south-west). For a walk, there’s Mid Hill and Brodgar RSPB Reserve.
For managing agents and facilities managers
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, with each stage agreed with your site contact.
For main contractors, we work as the sealant subcontractor on new-build and refurbishment projects. We work to your programme, your specification and your site rules, and our applicators hold CSCS cards.
What we are called out for in Stenness
The wrong sealant in the wrong place is a common cause of early failure. Painters’ acrylic in a moving joint, vinegar-smelling silicone on metal or natural stone, or a high-modulus product where a low-modulus one was needed will all fail early. Guidance such as BS 6213 exists to steer sealant selection for exactly this reason.
What tends to prompt an enquiry:
- External beads that have gone brittle and cracked
- Sanitary sealant that has gone black and patchy
- Frame mastic that has hardened and come away from the wall
- Messy, uneven beads from earlier work that let the building down
For any commercial premises in Stenness, a lasting joint depends on full removal of the old sealant and clean, dry faces.
What your quote should include
- Can the work be phased to keep areas open?
- Is the sealant right for the movement and the substrate?
- Whether old or failed sealant will be cut out, not overlaid
- Do they follow the manufacturer’s priming guidance?
Other services in Stenness
How a job runs
We follow your site rules from the start: sign-in, induction and whatever permit system the building uses. With the paperwork done, the joints are worked through in the order agreed with your site contact, and each area is checked before we leave it. For a building near Stenness, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- First, details reach us through the quote form or a site visit.
- The cause is diagnosed and the scope priced as a fixed quote.
- Work is phased around your occupiers where areas need to stay in use.
- Every failed bead is removed rather than covered.
- Each joint gets a suitable sealant, laid to depth and tooled.
- A final walk-round, then the 12-month guarantee applies.
Preparing the site
- Share the asbestos register for older buildings
- Tell us what induction or permit system the site runs
- Explain the parking and delivery arrangements
Ask for a quote
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To start the process, call the office on 01277 525 020 or send photos by email.
Related advice
What sealant work can’t fix
Being straight saves everyone time. New sealant won’t cure:
- Cracking that needs a structural engineer to look at it
- Removing asbestos-containing materials (a licensed or specialist contractor’s job)
- Leaks from pipework, wastes or valves (that’s plumbing)
If in doubt, call the office on 01277 525 020 or email drawings and photos and we’ll say what we think before you book.
Joints and surfaces we work on
- Movement joints in walls and floors
- Kitchen worktops and splashbacks
- Washrooms and tea points
- Window and door perimeters
- External facade joints
- Floor and threshold joints
Stenness: questions and answers
Will you travel to Stenness on the island?
Yes, Stenness is within the area we cover. We cover the whole of Scotland. We group island work where we can and plan around the crossings.
Does a coastal location like Stenness affect which sealant is used?
It can, yes: buildings near the sea take more wind-driven rain, and salt in the air nearer the shore. We choose the product for the exposure, prime where the manufacturer requires it and size the joint for its movement.
Do you seal on top of existing sealant?
No. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
Do you take on multi-site sealant work?
Yes. We take on runs of jobs across portfolios as well as single sites, priced site by site or as one programme.
Do you check for asbestos before removing sealant?
Some older mastics did contain asbestos. That’s why we ask for the asbestos information first, and stop if a material is suspect until it’s tested.
Can you work to our specification?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and any queries are raised before we start.
How long will the new sealant last?
There’s no fixed lifespan: movement, exposure, cleaning, traffic and the product all play a part. Treat them as maintenance items and inspect them regularly.
Leave it or put it right?
Some managers wait for a fit-out before touching the mastic. That’s reasonable for internal joints that are just tired-looking, but a joint letting water in now keeps doing damage until the refurb arrives. Splitting the scope into now and later is often the sensible compromise. Around smaller places like Stenness, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Resealing early avoids that.
Quantities, awkward access and phased working all shape the price. So do site requirements such as inductions and permits, along with the time of year for external work.
Why us?
- A range of standard colours, depending on the product
- Products installed to the manufacturer’s instructions
- RAL and finish matching where the product range allows
- One contact handling all your sites