Tomatin floor joint sealing
Work needed on a floor joint in Tomatin? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Trucks and loads jolting over damaged joints
- Filler that has parted from one face
- Loading bay joints breaking down
Floor joint sealing across Tomatin
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Honest limits
We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:
- Level or flatness problems across the floor
- Damaged or worn floor coatings and screeds
- Spalled arrises, which need an edge repair first
If in doubt, give us a call on 01277 525 020 or email drawings and photos and we’ll say what we think before you book.
Surfaces we seal
- Joints along racking aisles
- Loading bays
- Saw-cut induced joints
- Forklift and pallet-truck routes
- Construction joints
- Retail and showroom floors
Floor joint sealing in Tomatin, done properly
We work on warehouse aisles, dock areas, factory floors, retail units and showrooms. Pricing depends on the length of joint, how worn the edges are and when we can get in, and the quote is fixed before we mobilise. We work on saw-cut induced joints, forklift and pallet-truck routes and construction joints, and the failures we are asked to look at most are open saw cuts full of debris and loading bay joints breaking down. For commercial sealant work in Tomatin, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
Travel to smaller places like Tomatin is planned so the work is done in one trip where possible. Send photos, joint widths and details of the traffic first.
We stand by our work: 12 months, guaranteed. It covers how we prepared and applied the sealant.
- Place
- Tomatin (IV13)
- Region
- Highland
- Guarantee
- A 12-month guarantee
- Quote
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Questions we are asked in Tomatin
Is Tomatin too small for you to travel to?
No. Places such as Tomatin are covered as much as the big towns. We work across every Scottish council area. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
Which documents can you supply for work in Tomatin?
RAMS, insurance certificate, CSCS details: list what the site needs and we’ll confirm it with the quote. Our applicators are CSCS-carded, and we carry £5m public liability insurance.
Can you phase floor joint work around operations?
We phase it. Areas are taken out of use a section at a time around the site hours and access windows you give us.
Do you use semi-rigid filler or flexible sealant on floor joints?
There isn’t one answer for a whole floor. Hard wheels need edge support, which points to a semi-rigid filler, and movement joints or perimeters need something flexible. You’ll see the choice for each area in the quote.
Is colour matching possible?
It depends on the product specified. Some ranges are wide, others limited, so we will confirm the colours available for the specified product with the quote.
Is it fine to apply new sealant on top of old?
No, never. Overlaying old sealant is a frequent cause of early failure, so everything comes out first.
How soon can traffic go back on the floor?
Cure times vary with the product and the conditions. We will give you a time for each zone before we start.
What else we do in Tomatin
From enquiry to sign-off
We begin with a short walk round with whoever looks after the building, agreeing which joints are in scope, where to start and what must stay open. After that, any old or failed material is removed, each joint is prepared and the new sealant goes in. For a building near Tomatin, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We look at joint widths, edge condition and the traffic on each route.
- The quote fixes the price, names the filler or sealant and shows how the floor will be zoned.
- Old filler, debris and contamination are cut or routed out back to clean concrete.
- Dust is sucked out of the joint and a primer used if the product data sheet asks for one.
- The chosen product is placed to its specified depth and trimmed level with the floor.
- We tell you when each zone can carry trucks again and move on to the next.
Preparing the site
- For older buildings, check the asbestos register before work
- Let us know about inductions and permits
- Tell staff and tenants when we will be in
Request a quote
Pricing a project or setting a maintenance budget? Send the scope and any drawings, and we will return a fixed quote you can plan around. For a chat about it beforehand, call 01277 525 020 or email drawings and photos.
Read more
Site staff or a sealant specialist?
There’s also the paperwork. Many sites expect CSCS cards, RAMS and proof of insurance, and our CSCS-carded applicators are used to working under those rules.
What you see is the finished bead, but most of the work is hidden. Backing rod, primer where specified and a joint designed to move with the building are where general trades tend to cut corners.
What happens if it’s left?
Open joints are where dirt collects, out of reach of the floor cleaner. Where the floor is on show or needs to be kept clean, that is a problem. Flush, filled joints leave nothing for cleaners to dig out. Around smaller places like Tomatin, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Resealing early avoids that.
Quantities, awkward access and phased working all shape the price. Site requirements like inductions and permits play a part as well.
Why choose Mastic Doctor in Tomatin
- CHAS accredited contractor
- Fully insured, including public liability cover
- Failed material removed, not covered up
- Over 20 years of commercial sealing
See our cost guide and our accreditations.
After the work
A few simple habits keep the new joints working:
- Treat loading bay joints first if they’re failing
- Sweep debris out of open joints until they can be filled
- Keep photographs of joints that look like they’re failing
- Let us know what the floor is cleaned with
We’ll give you a time before trucks can run over the new joints, and it’s worth enforcing. In a busy building, barriers keep early traffic away.
Every day an open joint stays full of grit, the edges take more punishment. Filling it ends that cycle while it is still a straightforward job.
Different surfaces, different methods
Isolation joints at walls and columns
Isolation joints separate the slab from walls, columns and plinths so it can move independently. A flexible product suits them better than a stiff filler.
Loading bays and dock areas
Loading bays combine the heaviest turning loads with wet tyres and cold air from open doors. These are often the first joints on site to break down, so they are often the place to start.
Joints that move: notes for Tomatin
Tomatin is in the east of Scotland, which is drier than the west. Frost and winter road salt still work into open joints in car parks and yards. Resealing before the cold months helps protect the edges.
A joint near Tomatin that has lost its sealant lets in water and grit, and the edges suffer next. Around Tomatin, each joint gets a filler or sealant matched to what crosses it and how much it moves.
Tomatin is about 13 miles south-east of Inverness, in Highland. We cover Tomatin, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. We work across 256 places in Highland. For work in that direction, see our Aberdeen page, about 71 miles away.
We cover the IV13 postcode districts. If your site is on Old Mill Road, Ard Park and Juniper Drive or close by, send details and we will quote for floor joints. We also cover Carrbridge (8 miles south-east), Farr (8 miles north-west), Duthil (9 miles east), Milton of Leys (10 miles north-west) and Boat of Garten (11 miles south-east). A short drive away, we cover Inverness (13 miles north-west), Cradlehall (12 miles north-west), Merkinch (14 miles north-west), Hilton (12 miles north-west), Aviemore (11 miles south-east) and Crown (13 miles north-west). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you call 01277 525 020 or send photos by email.
What’s near Tomatin
Open spaces near Tomatin include Loch Moy.