The Mastic Doctor team standing beside their branded vans outside an office building
Perth and Kinross · Scotland

Kinfauns floor joint sealing

Floor joint sealing and filling in warehouses, factories and industrial units throughout Kinfauns and nearby, carried out by CSCS-carded applicators. CHAS accredited and fully insured.

  • Unfilled floor joints collecting dirt and grit
  • A rough ride across broken joints
  • Untidy open joints in a retail unit
1
Send details
Photos, drawings or a schedule, or we visit.
2
Get a quote
A fixed price, with what’s included set out clearly.
3
We seal
Prepared joints, the specified product, a tidy finish.
4
Guaranteed
Backed by a 12-month workmanship guarantee.
South East, London & Scotland
CHAS accredited
£5m PL insurance

Floor joint sealing for Kinfauns sites

Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.

About our floor joint sealing in Kinfauns

For sites in Kinfauns and across Perth and Kinross, the process is short: send details, get a fixed quote, we seal, and the work is guaranteed. A rough length of joint, photographs of the worst areas and a site plan let us give a quick quote, or we can arrange a site visit. We work on retail and showroom floors, saw-cut induced joints and construction joints, and the usual reasons a site gets in touch are filler that has parted from one face and sealant pulled out along a truck route. Facilities teams, main contractors and managing agents in Kinfauns tend to want the same three things: a clear scope, tidy work and joints that don’t fail again.

In smaller places such as Kinfauns, the joints we are asked about sit in workshops, farm sheds, schools and halls. Slabs and yards take vehicles, rain and frost.

Every job is signed off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.

Mastic Doctor team members lined up next to their branded vans outside an office building
Where
Kinfauns (PH2)
Wider area
Perth and Kinross
Guarantee
12 months on our workmanship
Quote
Quoted before any work starts
Phone
01277 525 020
Page updated
3 November 2026

Work for main contractors and building owners

We work for building owners and managing agents on sealant work across single buildings or whole portfolios. One quote can cover more than one site, which keeps the paperwork simple.

Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, with each stage agreed with your site contact.

Aftercare for building managers

Problems stay small when the joints are checked regularly. Specifically:

  • Keep trucks off new joints until we say they’re ready
  • Sweep debris out of open joints until they can be filled
  • Record damaged joints with a photo and a location
  • Let us know what the floor is cleaned with

If a joint we filled starts to break up within 12 months, tell us and we’ll arrange a look. Beyond that, an inspection once or twice a year catches failing joints early.

Every day an open joint stays full of grit, the edges take more punishment. Getting it filled stops the damage while it is still a straightforward job.

What we can’t put right

Our job is the joint, not everything around it. Sealant alone won’t deal with:

  • Structural cracking in the slab
  • Worn screed or surface finishes
  • Spalled arrises, which need an edge repair first

If you are not sure, just ring 01277 525 020 or send photos by email and we will give you a straight answer.

Surfaces we seal

  • Joints along racking aisles
  • Saw-cut induced joints
  • Forklift and pallet-truck routes
  • Construction joints
  • Retail and showroom floors
  • Loading bays

Different surfaces, different methods

Saw-cut induced joints

A sawn joint left open soon packs with debris and chips at the edges. Filling them early keeps them tidy and protects the edges.

Semi-rigid joint fillers

If a joint is still opening, a semi-rigid filler may part from one face. A later top-up usually puts that right, and we will explain it when we quote.

Your questions answered

Is hospital work, at somewhere like Murray Royal Hospital, something you do?

Yes, healthcare and care buildings are part of our work. The estates team’s permit system and infection-control rules come first, and the work is planned around them.

Is Kinfauns off your patch?

No. Places such as Kinfauns are covered as much as the big towns. Every Scottish council area is within our area. Where we can, we group nearby jobs to make the most of each trip.

Do you guarantee industrial floor joints?

There is a 12-month guarantee on our workmanship and the work is covered by public liability insurance.

When can forklifts run over new joint filler?

Each product has its own cure time, and cold floors slow it down. Phasing is planned with that in mind.

When is resealing likely to be due?

There’s no fixed lifespan: movement, exposure, cleaning, traffic and the product all play a part. Treat them as maintenance items and inspect them regularly.

What do you need from us to quote?

Send details through our quote form or by email and tell us what runs on the floor. We then send a fixed quote with the product and phasing set out.

Will we need to close the floor?

In the majority of cases, just the area being treated is coned off. Traffic returns to each zone once it has cured and the next zone follows.

On site: what to expect

At the end of each section, we remove the tape, clean down and inspect every joint with your site contact. If an area should be left alone while the sealant cures, we say how long and put signs out. Jobs near Kinfauns are often grouped with others in the same area, to make the most of each trip. Tell us how flexible your dates are.

  1. Each area is assessed for joint width, arris damage and the wheels that cross it.
  2. You get a fixed quote with the product and the phasing set out.
  3. Each joint is cleared of old fill and dirt and taken back to clean, sound edges.
  4. We vacuum each run and prime it if the chosen product requires a primer.
  5. We fill each joint to depth and finish it flush so wheels roll straight across.
  6. The area is handed back once it has cured enough to take traffic.

What we need from you

  • Move anything stored against the joints
  • Tell us your opening times and when work is allowed
  • Explain the parking and delivery arrangements

Getting a fixed quote

Tell us about the building, the joints and when you need the work done, and we will put a fixed quote together. To get it moving, ring 01277 525 020 or send details through our quote form.

Get a price

Read more

Joints that move: notes for Kinfauns

Kinfauns sits close to the coast, within about 2 miles. Coastal yards and decks give their joints salt and wet weather to deal with, not just wheels, which is why split joints are worth sealing before the edges deteriorate. The east of Scotland, where Kinfauns is, gets less rain than the west. Cold winters and gritting are hard on any yard or deck joint left open. Resealing before the cold months helps protect the edges.

Large sites such as Murray Royal Hospital, 2.7 miles north-west of Kinfauns, have car parks, service roads and long elevations with movement joints in brick and panels. In and around Kinfauns, the right filler or sealant for each joint depends on the traffic and the movement it takes.

Kinfauns is about 4 miles east of Perth, in Perth and Kinross. We send applicators to Kinfauns for floor joints. Kinfauns is one of 114 places we cover in Perth and Kinross. Dundee is covered too, some 15 miles away.

We take on floor joints across the PH2 postcode area, whatever the building. Nearby places we also cover include Glencarse (2 miles east), St Madoes (2 miles south-east), Tarsappie (3 miles west), Scoonieburn (3 miles west) and Scone (3 miles north-west). Bigger towns within reach include Perth (4 miles west), Blairgowrie and Rattray (14 miles north), Auchterarder (15 miles south-west), Kinross (12 miles south), Letham (5 miles west) and Tulloch (5 miles north-west).

Landmarks near Kinfauns

The nearest railway station is Perth station, roughly 3.4 miles west. Nearby you’ll also find Perth Museum (3.1 miles west) and Kinfauns Castle (1.1 miles west). Green spaces nearby include Kinnoull Hill.

Map of Kinfauns © OpenStreetMap contributors

General trades versus a specialist

For most general trades, sealant is a sideline. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.

For a quick touch-up, site staff may be fine, but anything bigger is another matter: a specialist brings efficiency, a consistent finish and a 12-month guarantee.

Accreditations

Trusted. Accredited. Insured.