Fire Stopping in Upper Bush
Our CSCS-carded applicators take on fire-rated and intumescent sealing of service penetrations and linear gaps in Upper Bush and the surrounding area. Send details for a fixed quote.
- Expanding foam used as fire stopping
- Snag lists that include open service penetrations
- Damaged fire seals in risers and voids
Need fire stopping in Upper Bush?
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
About our fire stopping in Upper Bush
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind, often unnoticed. We close the openings listed on your schedule, using the specified sealant and detail. Site teams most often ask us about penetration schedules that need working through and open linear gaps along the top of fire-resisting walls, across joints between fire-resisting walls and floors, linear gaps at wall heads and pipe penetrations. Whoever orders the work in Upper Bush, the brief is usually the same: a clear scope, tidy work and joints that don’t fail again.
Around smaller places like Upper Bush, penetration seals come up in schools, halls, pubs with rooms, care homes and farm buildings used as offices. Any service penetration through those walls should be closed with the specified product, set out as its test evidence shows.
Our workmanship is guaranteed for 12 months, wherever the site is. If our installation lets you down in that time, we return and fix it.
- Where
- Upper Bush (ME2)
- Region
- Medway
- Cover
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Fire-rated sealing for Upper Bush buildings
Upper Bush lies roughly 24 miles out from central London. Office refits around the commuter belt bring new cabling through fire-resisting walls. Approved Document B is the English guidance that covers fire stopping around openings and penetrations. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. What we install is set by the specification, and it goes in to the tested detail.
Holiday works at schools like Cuxton Community Infant School often leave service openings to seal before pupils return. Halls and meeting rooms at places like Church of St Michael and All Angels sometimes gain new services, and any compartment wall crossed needs the specified seal. Refits at places like Strood Retail Park, 2.9 miles to the north-east of Upper Bush, often reroute services through walls between units.
Upper Bush is about 3 miles west of Rochester, in Medway. We cover Upper Bush and the rest of Medway, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. Our Medway coverage takes in 54 places, from busy centres to rural villages. There’s a separate page for London, about 24 miles away.
Commercial sites across ME2 are covered for service penetrations. Nearby places we also cover include Lower Bush (1 mile north-east), Cuxton (1 mile east), North Halling (1 mile south-east), Halling (2 miles south) and Cobham (2 miles north-west). Bigger towns within reach include Gillingham (6 miles east), Chatham (4 miles east), Rochester (3 miles east), Rainham (8 miles east), Luton (4 miles east) and Park Wood (7 miles east).
Local landmarks in Upper Bush
Locally, jobs take us to sites close to Strood Academy and the streets around them. For rail, the closest station is Cuxton station, roughly 1.2 miles east of the centre. Well-known places in the area include Rochester Castle (3 miles east) and Six Poor Travellers House (3.1 miles east). For a walk, there’s Ranscombe Farm and Gad's Hill.
Your questions answered
Can you take on a job at a hospital such as French Hospital?
Yes. Healthcare sites are among the places we work. We follow the site’s permits, sign-in and infection-control procedures in every area.
Can you work around term dates at a campus such as University for the Creative Arts - Rochester?
Yes. Education sites normally want the work in vacations or in phases during term, and we plan to suit. Tell us which site documents you need, such as RAMS, our insurance certificate or CSCS details, and they’re confirmed with the quote.
Can you reseal penetrations after our M&E works?
Yes, where there is a specification for those walls and floors. Openings left by new services are among the most common jobs we see and we close them with the specified product.
Is any job too small?
Single areas, one-off repairs and whole buildings are all quoted the same way: send details, get a fixed quote, we seal, guaranteed.
What’s the quickest route to a quote?
You can use the quote form on this site; alternatively, phone 01277 525 020 or email drawings and photos. Photos, drawings or a joint schedule help us quote quickly.
Does the weather affect the work?
It can, when the joints are outside. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so we watch the forecast and rearrange outside work if we have to. Indoors, the weather is rarely a problem.
Will you sign off the seals for us?
No. Sign-off isn’t ours to give, and we don’t hold a third-party installer certificate. We work to the specification and the manufacturer’s installation guidance.
How a job runs
In a busy building, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then reopened once the sealant allows before the next one starts. Rural sites near Upper Bush may need directions, gate codes or a contact on site. Add it to your enquiry and we’ll build it into the plan.
- We read the specification, drawings or penetration schedule you send.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Preparing the site
- Explain the parking and delivery arrangements
- Send your site hours and access windows
- Warn occupants and staff about the work
Request a quote
Let us know the site, the scope and your timescale, and a fixed quote will follow. To get it moving, ring 01277 525 020 or send details through our quote form.
Read more
Quoting for work in Upper Bush
A fixed quote reflects the actual work. It takes account of:
- Removal of failed or old sealant
- Induction, permit and paperwork requirements
- Distance, for remote addresses
- Specialist products, such as fire-rated or hygienic sealants
Access can matter as much as the joints themselves: easy-to-reach joints are quicker than those that need equipment to get to. Tell us how the joints are reached and call for a quote.
Details that help us quote
There’s no need for a formal survey. These details are enough to start:
- Where the site is, with the postcode
- Rough lengths or quantities, or drawings if you have them
- Anything awkward about access or site hours
- Specification clauses that apply
To get a fixed quote, ring 01277 525 020 or send photos by email. You can also send details through our quote form.
When something else is needed
Sealant solves a lot, but not everything, and we’d rather tell you before you spend money. It won’t fix:
- Fire doors, dampers or other fire safety equipment
- Large openings beyond what any sealant detail covers
- Walls or floors that aren’t fire-resisting to begin with
If you are not sure, just give us a call on 01277 525 020 or email the details over and we’ll give you a straight answer.
What we seal
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
- Service gaps in risers
- Pipe penetrations
- Cable penetrations
Commercial clients in Upper Bush
Main contractors use us as their sealant subcontractor, on new build and refurbishment alike. We work to your programme, your specification and your site rules.
Planned maintenance programmes are welcome: resealing failed joints building by building, on a schedule that suits your budget. Sites in Upper Bush can sit alongside others in a wider programme across Medway.
What the job involves on each surface
Drylining partitions
Holes in board are often cut larger than needed. An oversized hole may be outside the sealant’s range and we will tell you what the detail says instead.
Linear joints
Joints at the top of partitions may need to move as the slab above deflects. The specified product and backing for that movement are what goes in, along the full length of the run.
Places near Upper Bush
Other services in Upper Bush
Keeping the joints sound
For the best life from the joints:
- Check with the data sheet before painting over fire sealant
- File the specified details where the next contractor can find them
- Include service cupboards in routine inspections
- Settle who seals which penetrations at the start of a project
After every round of M&E works, check that the openings created have been sealed. Building it into each contractor’s sign-off keeps the walls intact.
Regular walk-rounds of service areas are worth the time. Catching a damaged seal early keeps the fix small.