Fire Stopping in Skeete
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Skeete and the surrounding area. Send photos or drawings for a fixed quote.
- Fire stopping installed outside its tested range
- Openings found when ceilings come down for a refit
- Fire sealant pulled out of the opening
Fire stopping for businesses in Skeete
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Fire stopping in Skeete
Penetration seals are fire tested to BS EN 1366-3 and linear joint seals to BS EN 1366-4, with results classified under BS EN 13501-2. A rating such as EI 60 only holds when the product is installed as it was tested. So our job is to reproduce that arrangement faithfully. If you are dealing with fire-rated sealant that has cracked or shrunk back and builders’ foam or ordinary silicone in compartment walls, we can put it right. One point of contact handles commercial sealant work in Skeete from the first photos to the final walk-round, whether it’s one building or several.
A job near Skeete is typically planned around one visit, so send the specification and photos first. Design and sign-off belong to the designer or building control; we install what’s specified.
Work we carry out in Kent comes with a 12-month guarantee. Should something we installed fail, call 01277 525 020 or send photos by email and we’ll come back to it.
- Location
- Skeete (CT18)
- Region
- Kent
- Guarantee
- A 12-month guarantee
- Price
- Quoted before any work starts
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Quoting for work in Skeete
The price varies from site to site. Expect it to depend on:
- Site requirements such as inductions and permits
- The size and state of each joint
- Whether the work must be split into stages
- Distance, for remote addresses
Cost follows what’s involved: removing old material, preparing the joints, the product, the access and how the work is phased. Call for a quote and we’ll explain how it’s made up.
What to include in your enquiry
However big the job, the same details help:
- A wide shot and a close-up of the area
- Approximate linear metres or a joint schedule
- When you need the work done
- Anything awkward about access or site hours
Let us know the site, the scope and your timescale, and we will put a fixed quote together. To get it moving, speak to us on 01277 525 020 or email a schedule or drawings.
How the job changes by surface
Cables and cable bundles
New data and power cables are the most common breach we see. Openings around new cables are resealed to the detail, and we tell you if the bundle exceeds what sealant covers.
Risers and ceiling voids
Voids hide a lot of unsealed openings. We follow your schedule area by area.
When to call us in Skeete
Head-of-wall joints and wall-to-wall junctions are frequent weak points. Deflection and building movement can open these gaps, and a product not tested for that movement may crack. Linear joint details set a width range and movement capability, and the seal has to sit within them.
Any of the following is a good reason to get the joints checked over:
- Damaged fire seals in risers and voids
- Head-of-wall gaps with no fire seal
- Fire-stopping items raised at inspection or handover
- Non-fire-rated filler around services
Schools such as Stowting Church of England Primary School often have new data and services installed during holidays, and penetrations through fire-resisting walls should be checked afterwards.
What your quote should include
- Who will actually carry out the work
- How long is the guarantee, and what does it include?
- Whether old or failed sealant will be cut out, not overlaid
- What site paperwork they can supply
Why it’s worth doing now in Skeete
An unsealed opening affects more than fire safety: smoke, noise and draughts pass through them every day. Sealing them to the specified detail deals with the fire risk first. One visit to deal with every failing joint makes more sense than several trips to a place like Skeete, rather than one at a time. Photos of every joint help us quote for the whole job.
The product called for affects the cost, and so does the preparation. Access, phasing and site requirements come into it too.
Why us?
- Fixed quotes based on photographs, drawings or a visit
- Sealing commercial buildings since 2005
- 12 months’ guarantee on every job
- Joints cleaned back to sound surfaces
Read what affects the cost and how we’re accredited.
After the work
To get the most from the new sealant:
- Keep product data and details in the fire safety file
- Brief every trade that openings they make must be sealed
- Keep general-purpose fillers away from compartment walls
- Settle who seals which penetrations at the start of a project
During planned inspections, look at seals in risers, cupboards and voids. Watch for cracked sealant, new services with no seal and openings that have grown, and report them promptly.
Write fire stopping into the scope of any work crossing a compartment wall or floor. Then the seal goes in while the area is open.
Questions we are asked in Skeete
Is Skeete too small for you to travel to?
No. Places such as Skeete are covered as much as the big towns. We work across Greater London and the South East. Good photographs up front let us bring everything on the first visit.
How does the removal of BS 476 from Approved Document B affect fire-rated sealing in Skeete?
From 2 September 2029, Approved Document B drops its BS 476 references in favour of BS EN 13501-2 classification, with transitional arrangements. Whichever applies, we install the specified product to its tested detail; the specification is for the designer to set.
Can you fit around our working hours?
The office is staffed Monday to Friday, from 8am until 5pm. Tell us your site hours and access windows and the work will be fitted around them.
Do you offer coloured sealant?
That depends on the product. Some ranges are wide, others limited, so we’ll confirm the colours available for the specified product with the quote.
Can you work to our specification?
Yes. Include it with the drawings when you ask for a quote, and we’ll price the work to it.
How do you deal with asbestos in old sealant?
The duty to manage asbestos sits with the building’s dutyholder, so for older buildings we ask for the asbestos register first. Work pauses if suspect material is found, until it has been tested.
How much does the work cost?
That depends on the job: the volume of work, the access, the specified product and how it’s phased. Call for a fixed quote.
Where services cross fire walls in Skeete
Skeete is about 56 miles from central London. Offices around the capital are refitted often, and the cabling that follows can breach fire-resisting walls, and the gaps need sealing with the specified product. Approved Document B is the English guidance that covers fire stopping around openings and penetrations. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. Either way, we install the specified product to its tested detail.
On a hospital site such as Royal Victoria Hospital, 5.6 miles to the south-east of Skeete, fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits.
Skeete is about 4 miles north of Hythe, in Kent. We cover Skeete and the rest of Kent, with the same fixed quotes and 12-month guarantee as everywhere else. Skeete is one of 931 places we cover in Kent for service penetrations. We also cover London, some 56 miles away.
Work on service penetrations is covered throughout CT18. Just outside Skeete, we also work in Woodland (1 mile north-east), Hemsted (1 mile north), Lyminge (1 mile east), Rhodes Minnis (1 mile north-east) and Postling (1 mile south). Bigger towns within reach include Ashford (8 miles west), Canterbury (10 miles north), Dover (10 miles east), Folkestone (6 miles south-east), Faversham (15 miles north-west) and Hythe (4 miles south).
Near you in Skeete
Skeete’s nearest station is Westenhanger station, roughly 2.5 miles south-west. Nearby you’ll also find Royal Victoria Hospital (5.6 miles south-east) and Saltwood Castle (3.4 miles south). Not far away are Hatch Park and Tolsford Hill.
Other services in Skeete
Diagnose, treat, sign off
Before we leave any area, we remove the tape, clean down and inspect every joint. Where the sealant needs time to cure before use, we tell you and sign the area. For work around Skeete, we aim to finish in one visit, so we ask for photographs and rough sizes first. Then the right materials arrive with us.
- We start with your penetration schedule, drawings or specification.
- We plan the sequence of floors, risers and voids with you.
- We compare every service penetration with its tested detail before sealing.
- Unsuitable material is removed and the opening cleaned first.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
What we need from you
- Point out any areas we must not close
- Make sure the joints can be reached
- Send your site hours and access windows
Get a fixed quote
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or call 01277 525 020 or email the details over if you’d rather talk the job through.