Fire Stopping in Paynes Green
Sealant work in Paynes Green for main contractors, managing agents and facilities managers: fire-rated and intumescent sealing of service penetrations and linear gaps, with a fixed quote first.
- Unsealed joints where partitions meet the slab
- Fire sealant pulled out of the opening
- Hidden openings found during inspections
Fire stopping near Paynes Green
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Commercial clients in Paynes Green
As a CHAS accredited contractor and Constructionline member, we’re straightforward to vet for your supplier list. We are fully insured, and our insurance certificate can go with the quote.
Housing associations and managing agents often need work done across blocks and communal areas. Work can be phased so residents and staff keep access throughout, with each stage agreed with your site contact.
Fire stopping in Paynes Green, done properly
A lot of fire-stopping work comes after M&E installation, a refit or a tenant fit-out. Each new cable, pipe or data route cut through a fire-resisting wall leaves an opening behind, and they are easy to forget. We close the openings listed on your schedule, using the specified sealant and detail. If you have fire sealant pulled out of the opening and snag lists that include open service penetrations, we can help, whatever the surface. Most enquiries from Paynes Green start with one failed joint and grow into a wider look at the building: we look at the rest while we’re there and tell you what we find.
For a smaller site near Paynes Green, we plan to do all the penetrations in one go, so send the specification and photographs first. We install to the specification and the manufacturer’s guidance, leaving design and sign-off with the designer and building control.
Every job we finish is backed by a 12-month workmanship guarantee, in Paynes Green as everywhere else we work. If our installation lets you down in that time, we return and fix it.
- Place
- Paynes Green (RH5)
- Wider area
- Surrey
- Cover
- A 12-month guarantee
- Quotes
- Quoted before any work starts
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Cost factors for service penetrations
A fixed quote reflects the actual work. It takes account of:
- How accessible the joints are
- Whether old sealant has to be cut out first
- Site requirements such as inductions and permits
- Specialist products, such as fire-rated or hygienic sealants
The product called for affects the cost, and so does the preparation, such as cutting out, priming or new backing rod. Access, phasing and site requirements come into it too.
Details that help us quote
To price the job accurately, we need a clear picture of the site. Send us:
- Anything awkward about access or site hours
- Any specification or named product
- Asbestos survey details if the building is older
- Where the site is, with the postcode
Need a figure for a tender or a budget? We will quote against your scope and drawings that you can work with. For a chat about it beforehand, give us a call on 01277 525 020 or send details through our quote form.
Also near Paynes Green
More services for Paynes Green
Why deal with it now?
Inspections and handover checks often pick up fire stopping. Late discoveries can delay handover while openings are reopened and resealed. Around Paynes Green, it’s better to renew all the failing joints at once, rather than one at a time. Send photographs of each area and we’ll quote for the lot.
Every site prices differently: the joint sizes, the specified product, access and working hours each have a bearing. A fixed quote follows once we understand the job.
What you get with us
- Health and safety: CHAS accredited
- 12-month guarantee on workmanship
- Clear, fixed quotes
- Public liability insurance in place
Read our cost guide or our accreditations.
Compartment walls and floors in Paynes Green
For England, the fire stopping of penetrations is dealt with in Approved Document B. References to the older BS 476 classes are being removed from it from 2 September 2029, after which the European classification, BS EN 13501-2, is the route, subject to transitional arrangements. We install whatever has been specified, to the product’s tested detail. Paynes Green is about 28 miles from central London. Tenant changes on commuter-belt business parks mean regular fit-outs, and new services through compartment walls, and the gaps need sealing with the specified product.
For a hospital such as Horsham Hospital, 4.2 miles south-east of Paynes Green, penetration sealing is normally phased ward by ward, with infection-control rules agreed first.
Paynes Green is about 4 miles north-west of Horsham, in Surrey. Paynes Green sits inside our coverage and the rest of Surrey, with the same fixed quotes and 12-month guarantee as everywhere else. We work across 379 places in Surrey, from busy centres to rural villages. There’s a separate page for Brighton, roughly 23 miles from Paynes Green.
Business premises anywhere in RH5 are within our area. Nearby places we also cover include Ockley (1 mile north), Kingsfold (2 miles south-east), Capel (2 miles north-east), Forest Green (3 miles north-west) and Coldharbour (4 miles north). A short drive away, we cover Guildford (12 miles north-west), Epsom (15 miles north), Horley (9 miles north-east), Redhill (11 miles north-east), Reigate (10 miles north-east) and Dorking (7 miles north).
Near you in Paynes Green
We work on buildings around Wallis Wood. The closest station to Paynes Green is Ockley station, about 2.1 miles north-east. Nearby you will also find Horsham Hospital (4.2 miles south-east). Not far away are Warnham LNR and Leith Hill.
On site: what to expect
A typical day starts with protection: masking tape along the joint edges and sheeting over anything nearby. On site, the work usually takes longer where risers, ceiling voids or occupied floors have to be worked through in sequence, and our waste is bagged and taken away as we go. Rural sites near Paynes Green may need directions, gate codes or a contact on site. Add it to your enquiry and we’ll build it into the plan.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- We apply the specified sealant to the depth and around the services as the detail shows.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Before we start on site
- Tell us your opening times and when work is allowed
- Flag any permit to work we’ll need
- Confirm the product named in the specification
Ask for a quote
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or give us a call on 01277 525 020 or email drawings and photos to discuss it first.
Advice
Honest limits
Part of a good diagnosis is knowing where sealant stops. We’ll tell you if the real problem is any of the following:
- Gaps in walls that were never built as compartment walls
- Deciding what a wall or floor needs, which belongs to the designer
- Openings that need collars, wraps, batts or boards rather than sealant
If you’re not sure, just speak to us on 01277 525 020 or email drawings and photos and we’ll give you a straight answer.
Surfaces we seal
- Linear gaps at wall heads
- Pipe penetrations
- Joints between fire-resisting walls and floors
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Cable penetrations
Your questions answered
Is a smaller place like Paynes Green outside your area?
Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. Send photos and a list of what needs doing, and we’ll plan the job to need as few trips as possible.
Can you work at a site such as Northlands Business Park, by Paynes Green?
Yes. We cover Paynes Green and the area around it, including industrial estates, business parks and retail parks such as Northlands Business Park. To start, just give us a call on 01277 525 020 or send details through our quote form with the unit, the joints involved and your access times.
Do you seal on top of existing sealant?
No. We cut the old material out and clean the joint back before sealing, because fresh silicone will not bond with aged silicone.
How soon can the area be used again?
The product and site conditions decide that. Some products skin over quickly but need longer to cure fully, and we confirm it before leaving site.
Do you need to see the site first?
Many jobs can be quoted from photographs, drawings or a joint schedule. Where they aren’t, we arrange a site visit.
What will the job cost?
Each job is quoted on its own details. To get one, speak to us on 01277 525 020 or send photos by email.
Do the same rules apply to fire stopping in Scotland?
Scotland sets its own building regulations, with Technical Handbooks, while England relies on Approved Document B. Either way, we install the specified sealant to its tested detail.
Do you need fire stopping in Paynes Green?
On a busy project, programme pressure can mean fire stopping is rushed or left to whichever trade is closest. That is when untested combinations creep in and later need putting right.
Any of the following is a good reason to get the joints checked over:
- Non-fire-rated filler around services
- Service penetrations left open after M&E works
- Damaged fire seals in risers and voids
- Fire-stopping items raised at inspection or handover
Tenant changes at parks like Northlands Business Park, 1.2 miles to the south of Paynes Green, bring new data and services, and openings through fire-resisting walls need the specified seal.
Before you book anyone
- Proof of insurance
- Are they CHAS accredited or on Constructionline?
- Will RAMS and insurance details be available?
- Whether old or failed sealant will be cut out, not overlaid