Fire-rated sealing and fire stopping in Newmachar, Aberdeenshire
Need fire stopping in Newmachar? It’s simple: send details, get a quote, we seal, guaranteed.
- Openings left by services added after handover
- Improvised or mixed-product fire seals
- Fire seals cut back for extra cables and never reinstated
Fire stopping for businesses in Newmachar
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Fire-rated sealing for Newmachar buildings
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, and products should be tested for their end use. Our part is installing the specified fire-rated sealant to its tested detail.
For a hotel such as Newmachar Hotel (under half a mile north-west of Newmachar), penetration seals are worth checking after any refit or services upgrade. Theatres, wards and plant rooms at sites like Kingseat Hospital (to the east of Newmachar) all have compartment walls crossed by services. In a school such as New Machar Primary School, fire-rated sealant goes in around service penetrations where it is specified.
Newmachar is about 7 miles east of Inverurie, in Aberdeenshire. Newmachar sits inside our coverage, with the same fixed quotes and 12-month guarantee as everywhere else. Newmachar is one of 179 places we cover in Aberdeenshire. For work in that direction, see our Aberdeen page (8 miles or so).
Commercial sites across AB21 are covered for service penetrations. We cover commercial and managed buildings on Station Road, Elrick Gardens and Disblair Avenue. Just outside Newmachar, we also work in Kinmundy (1 mile south), Kingseat (1 mile east), Whitecairns (2 miles east), Corsehill (3 miles south-east) and Udny Station (3 miles north-east). Further afield, our area takes in Inverurie (7 miles west), Westhill (9 miles south-west), Ellon (8 miles north-east), Portlethen (14 miles south), Garioch (7 miles west) and Kemnay (10 miles west).
Landmarks near Newmachar
For rail, the closest station is Dyce station, about 4.1 miles south. Well-known places in the area include Kingseat Hospital (1.1 miles east). Open spaces near Newmachar include Corby Loch and Temple Hill.
Fire stopping in Newmachar
Facilities managers in Newmachar often find open service penetrations when ceilings come down for other work. If a specification already covers those walls and floors, we can reseal to it, matching the product and detail it names. With no specification in place, the first step sits with your designer or fire engineer, not with us. We work on cable penetrations, service gaps in risers and pipe penetrations, and the usual reasons a site gets in touch are fire stopping installed outside its tested range and openings found when ceilings come down for a refit. Whoever orders the work in Newmachar, the brief is usually the same: a fixed quote, no surprises on site and a 12-month guarantee behind the result.
Hotels and care homes around smaller places like Newmachar often have services added during refurbishment. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
Our 12-month guarantee is about workmanship, not wear and tear. How long a sealant joint lasts depends on movement, exposure, cleaning and use, so we spell out the cover before we begin.
- Location
- Newmachar (AB21)
- Region
- Aberdeenshire
- Cover
- A 12-month guarantee
- Quotes
- Fixed quote, scope in writing
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Keeping the joints sound
Cleaning and maintenance staff play a part too. Pass these on to them:
- Settle who seals which penetrations at the start of a project
- File the specified details where the next contractor can find them
- Check risers and ceiling voids after each round of works
- Have penetrations checked while they can still be seen
Allow the manufacturer’s stated cure time before boxing in or decorating. Not every fire-rated product can be painted.
Ask every contractor who works in risers or voids to report openings they create. It costs little and catches breaches early.
Honest limits
Honesty saves time and money. New sealant won’t cure:
- Gaps in walls that were never built as compartment walls
- Openings that need collars, wraps, batts or boards rather than sealant
- Reviewing a building’s overall fire safety
If in doubt, give us a call on 01277 525 020 or email us and we will say what we think before you book.
Surfaces we seal
- Joints between fire-resisting walls and floors
- Small duct penetrations where the tested detail allows
- Cable penetrations
- Pipe penetrations
- Linear gaps at wall heads
- Service gaps in risers
Surface by surface
Risers and ceiling voids
Service risers and the voids above ceilings are where openings collect. Access is often tight, so we agree it with you in advance along with any permits your site needs.
Drylining partitions
Service holes through plasterboard are frequently oversized or ragged. If the gap exceeds the tested range, sealant alone won’t do, and the detail may call for board patching or another product.
Building owners, agents and FMs in Newmachar
If you look after buildings for someone else, clear figures and clear communication matter. You get a fixed quote, an agreed scope and a walk round at the end.
Agents, factors and owners’ representatives all follow the same route: send the details, accept a fixed quote, and we carry out and guarantee the work. Keys, access and contacts can be agreed in advance.
Our process
A typical day starts with protection: tape along each joint edge and covers over finishes, stock and equipment close by. The work itself normally takes anything from one day to a planned run of visits, depending on the number of seals and the access, and we clear our waste as we work. For a building near Newmachar, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- Each opening is checked for wall or floor type, service, gap and depth.
- Foam, ordinary sealant and debris come out first.
- Backing and fire-rated sealant are installed to the detail and tooled.
- We tell you about openings that need a different product.
What we need from you
- Send your site hours and access windows
- Make sure the joints can be reached
- Tell staff and tenants when we will be in
Get a fixed quote
A handful of photos and a postcode is the fastest way to a quote. Send them through the quote form, or call the office on 01277 525 020 or email drawings and photos if you’d rather talk the job through.
Related advice
Towns and villages near Newmachar
More services for Newmachar
Newmachar: questions and answers
Is Bridgehaugh Industrial Estate, near Newmachar, within your area?
Yes, sites like Bridgehaugh Industrial Estate are within our area, along with the rest of Newmachar. Photos and a short description are enough for a first look.
Is a smaller place like Newmachar outside your area?
No. Places such as Newmachar are covered as much as the big towns. Every Scottish council area is within our area. Where we can, we group nearby jobs to make the most of each trip.
Can you reseal penetrations after our M&E works?
Yes. Send the schedule or marked-up drawings and the specified product details and a fixed quote follows. Work can run area by area behind the M&E trades keeping pace with the programme.
How do we ask for a quote?
You can use the quote form on this site; alternatively, ring 01277 525 020 or use the quote form. Photos, drawings or a joint schedule help us quote quickly.
Is any job too small?
Whatever the size, the process is the same: details, then a fixed price, then sealing, then a 12-month guarantee.
Can you work to our specification?
Yes. The specification and the manufacturer’s installation guidance are what we work to.
How many days will you need on site?
That varies with the scale of the job, though a typical visit normally takes a single visit for a short list of penetrations, or a phased programme for a whole building. For bigger or phased jobs, we’ll set out a timescale with the quote.
General trades versus a specialist
There’s also the paperwork. Many sites expect CSCS cards, RAMS and proof of insurance, and our CSCS-carded applicators are used to working under those rules.
Redoing a failed joint normally costs more than getting it right at the outset, since all of it has to come out and the faces be cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.