Fire stopping in Kirkton of Auchterhouse
We carry out fire-rated and intumescent sealing of service penetrations and linear gaps in Kirkton of Auchterhouse and the surrounding area. Send photos or drawings for a fixed quote.
- Service penetrations left open after M&E works
- Unsealed penetrations discovered above suspended ceilings
- Unsealed joints where partitions meet the slab
Fire stopping near Kirkton of Auchterhouse
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
How we handle fire stopping in Kirkton of Auchterhouse
It helps to set out our role at the start. The designer, fire engineer or building control decides which fire stopping is required. What we bring is careful installation of the specified sealant, to the maker’s guidance on buildings around Kirkton of Auchterhouse. The enquiries we see most involve penetration schedules that need working through and open linear gaps along the top of fire-resisting walls, on small duct penetrations where the tested detail allows, linear gaps at wall heads and service gaps in risers. One point of contact handles commercial sealant work in Kirkton of Auchterhouse from the first photographs to the final walk-round, whether it’s one building or several.
Around smaller places such as Kirkton of Auchterhouse, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
We stand by our work: 12 months, guaranteed. That covers our preparation and application, and if something we did falls short, we return to it.
- Location
- Kirkton of Auchterhouse (DD3)
- Wider area
- Angus
- Cover
- 12 months on our workmanship
- Quotes
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Updated
- 3 November 2026
Compartments and services around Kirkton of Auchterhouse
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, using products tested for the way they’re used. We install what’s specified, to the product’s tested detail.
Around Kirkton of Auchterhouse, we install fire-rated and intumescent sealant to the product’s tested detail wherever it is the specified product.
Kirkton of Auchterhouse is about 5 miles north-west of Dundee, in Angus. Kirkton of Auchterhouse sits inside our coverage and the rest of Angus, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. 65 places across Angus fall within our area, Kirkton of Auchterhouse among them.
We take on service penetrations across the DD3 postcode area, for business premises of every kind. For a building on Parkside, Piper's Way and The Brae or nearby, send details and we’ll quote for service penetrations. Close to Kirkton of Auchterhouse, our area also takes in Muirhead (3 miles south), Birkhill (3 miles south), Bridgefoot (3 miles south-east), Strathmartine (3 miles south-east) and Piperdam (3 miles south-west). Bigger towns within reach include Forfar (10 miles north-east), Monifieth (10 miles east), Carnoustie (13 miles east), Kirriemuir (10 miles north), Hunter's Town (13 miles east) and Gardynebourg (13 miles east).
Near you in Kirkton of Auchterhouse
Other landmarks nearby include Auchterhouse Castle (1.2 miles south-west) and Royal Dundee Liff Hospital (3.6 miles south). For a walk, there’s Trottick Mill Ponds and Auchterhouse Hill.
Common questions from Kirkton of Auchterhouse clients
Is Kirkton of Auchterhouse too small for you to travel to?
Not at all: smaller places are covered as well as towns. We cover the whole of Scotland. We plan jobs in smaller places so return trips are kept to a minimum.
Which Scottish guidance covers penetration seals in Kirkton of Auchterhouse?
Scotland’s non-domestic Technical Handbook covers it in clause 2.1.14: penetrations keep at least the element’s fire resistance duration, with products tested for their end use. Design sits with the designer and the verifier; installation to the tested detail is our part.
Can one quote cover more than one building?
Yes. Several buildings can share a single quote, with one point of contact across South East England, Greater London and Scotland.
Do you work to architects’ specifications?
Yes. Send it with your enquiry, and the quote will be based on it.
What if there’s asbestos in the old mastic?
Some older mastics, especially in pre-2000 buildings, can contain asbestos. We check the asbestos register before cutting out old sealant in an older building, and if asbestos is suspected, work stops until it’s tested. We don’t remove asbestos-containing materials.
Can staff carry on working while you are here?
Typically, yes. Phased work can be planned so areas stay in use, with each area protected and signed.
Do your applicators hold CSCS cards?
Yes. Our applicators hold CSCS cards, as many construction sites ask for.
What the job involves on each surface
Metal pipes
Sealant details often cover copper and steel pipework. The tested detail sets the pipe size range, gap, depth and whether insulation can stay on and we confirm each before sealing.
Small ducts
Ducts are only sealed with sealant where the detail allows it. The ductwork, its supports and any dampers are for the ductwork contractor.
Honest limits
Honesty saves time and money. New sealant won’t cure:
- Deciding what a wall or floor needs, which belongs to the designer
- Issuing fire ratings or certificates for seals
- Reviewing a building’s overall fire safety
Not sure which it is? You can ring 01277 525 020 or email us and we will tell you honestly.
What we seal
- Small duct penetrations where the tested detail allows
- Service gaps in risers
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Pipe penetrations
- Cable penetrations
Why it’s worth doing now in Kirkton of Auchterhouse
An open or wrongly sealed service penetration lets fire and smoke reach the next compartment much sooner than the building was designed for. Putting it right is typically a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Buildings that aren’t in daily use, such as halls and seasonal premises, may let water in unnoticed, so a failed joint has time to cause damage. Early resealing prevents it.
Access often affects the price as much as the sealing: easy-to-reach joints are quicker than those that need equipment to get to. Tell us how the joints are reached and call for a quote.
Why us?
- Failed material removed, not covered up
- Fully insured, including public liability cover
- Health and safety: CHAS accredited
- CSCS-carded applicators
See what affects the cost and our accreditations.
Building owners, agents and FMs in Kirkton of Auchterhouse
Hospitality, education, healthcare, office and retail clients book us directly too. We plan around the way the building is used, so the building keeps working while we do.
Planned maintenance programmes are welcome: working through a building or an estate in stages that fit your budget. Kirkton of Auchterhouse can form part of a wider programme across Angus.
Signs you need fire stopping in Kirkton of Auchterhouse
Most open service penetrations are left by later work. New cabling, rerouted pipework or a data route drilled through a riser leaves an opening that nobody returns to. Across several fit-outs, the openings add up.
Most enquiries start with something like this:
- Fire-rated sealant that has cracked or shrunk back
- Open linear gaps along the top of fire-resisting walls
- Openings found when ceilings come down for a refit
- Fire stopping installed outside its tested range
On a hospital site such as Royal Dundee Liff Hospital, 3.6 miles to the south of Kirkton of Auchterhouse, fire-rated sealant goes in where the specification calls for it, with the work planned around the estates team’s permits.
Before you book anyone
- Their public liability cover
- Can the work be phased to keep areas open?
- Their approach to joint depth and backing
- Whether primer will be used where the manufacturer specifies it
Nearby places to Kirkton of Auchterhouse
More services for Kirkton of Auchterhouse
Our process
Site rules come first: sign-in, induction and whatever permit system the building uses. With the paperwork done, the joints are worked through in the order agreed with your site contact, and each area is checked before we leave it. For a building near Kirkton of Auchterhouse, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
- Every penetration is compared with its detail: wall or floor type, service, gap size and depth.
- Unsuitable fillers and loose debris are taken out of each opening.
- We fit the backing the detail asks for, to the stated depth.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
What we need from you
- Tell us which areas need to stay in use
- Send your site hours and access windows
- Let us know about inductions and permits
Quotes
If there’s a specification, drawings or a tender package, send it with your enquiry, and we will price against exactly what is specified. Smaller jobs need nothing more than photographs and a few notes.