Kinrossie fire stopping
Work needed on a service penetration in Kinrossie? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Snag lists that include open service penetrations
- Improvised or mixed-product fire seals
- Head-of-wall gaps with no fire seal
Fire stopping for Kinrossie sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Fire stopping for commercial buildings in Kinrossie
The test standards are BS EN 1366-3 for penetration seals and BS EN 1366-4 for linear joints. A rating such as EI 60 only holds when the product is installed as it was tested. Reproducing the tested arrangement on site is the part we take care of. We work on joints between fire-resisting walls and floors, small duct penetrations where the tested detail allows and linear gaps at wall heads, and what we are called in for most is service penetrations left open after M&E works and builders’ foam or ordinary silicone in compartment walls. For commercial sealant work in Kinrossie, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
Refurbishments in small hotels, schools and care homes around places like Kinrossie can leave gaps around new services. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
Every job we finish is backed by a 12-month workmanship guarantee. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Place
- Kinrossie (PH2)
- Region
- Perth and Kinross
- Guarantee
- 12 months on every job
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
How the job changes by surface
Plastic pipes
In a fire, plastic pipework melts away and leaves an opening. Some intumescent sealants are tested on smaller plastic pipes. We check the pipe material and diameter against the detail before we start.
Risers and ceiling voids
Risers and ceiling voids hold most of a building’s service penetrations. Access to these areas is planned with you in advance, including keys, permits and any isolations.
FAQs: Kinrossie
How do the Scottish rules apply to fire-rated sealing in Kinrossie?
Under Scotland’s non-domestic Technical Handbook (clause 2.1.14), service penetrations should keep at least the wall or floor’s fire resistance duration, using products tested for their end use. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
Is Kinrossie too small for you to travel to?
Not at all. Kinrossie is within our area. Our area covers all of Scotland, cities, towns and islands alike. Where we can, we group nearby jobs to make the most of each trip.
Can the building stay open while you work?
Yes, with some planning. Tell us your site hours and access windows and we’ll plan around them.
What do you charge?
We don’t publish prices, as every site differs. Send photos or drawings and we’ll price it at a fixed figure.
What about RAMS and site documents?
Each site asks for different documents, so tell us what you need and we will confirm it when we quote.
Which sealant will you use?
If the job is specified, we follow the specification. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Does weather matter for sealant work?
It can, for external work. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so external work may be moved if conditions aren’t right. Internal work is far less affected.
Where services cross fire walls in Kinrossie
In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, and products should be tested for their end use. We install fire-rated sealant to that tested detail where it is specified.
Wherever the building is near Kinrossie, design and sign-off of fire stopping sit with the designer, fire engineer or building control; we install what has been specified. Buildings near Kinrossie get the fire-rated product that’s specified, installed to its tested detail.
Kinrossie is about 7 miles north-east of Perth, in Perth and Kinross. Businesses, contractors and managing agents in Kinrossie use us for work on service penetrations. We work across 114 places in Perth and Kinross. Our Dundee page has more on work in that area.
Commercial sites across PH2 are covered for service penetrations. For a building on Mercat Green, Dunsinnan View and Thorngreen Road or nearby, we can quote for service penetrations. If your building is just outside Kinrossie, we cover Balbeggie (2 miles south-west), Wolfhill (2 miles west), Burrelton (3 miles north), Woodside (3 miles north) and Guildtown (3 miles west). Further afield, our area takes in Perth (7 miles south-west), Blairgowrie and Rattray (8 miles north), Letham (8 miles south-west), Scone (5 miles south-west), Tulloch (7 miles south-west) and Alyth (11 miles north).
What’s near Kinrossie
Nearby you’ll also find Castle Hill (3.7 miles north-west). Open spaces near Kinrossie include Dunsinane Hill.
On site: what to expect
We begin with a short walk round with whoever looks after the building, agreeing which joints are in scope, where to start and what must stay open. After that, any old or failed material is removed, each joint is prepared and the new sealant goes in. For a building near Kinrossie, directions, keys and a contact on the day are worth sorting early. We will confirm the plan with the fixed quote.
- We start with your penetration schedule, drawings or specification.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Foam, ordinary sealant and debris come out first.
- Backing and fire-rated sealant are installed to the detail and tooled.
- Anything outside the detail is reported to you rather than sealed.
What we need from you
- Tell staff and tenants when we’ll be in
- Have the specification and drawings to hand
- Agree which areas must stay open
Get a fixed quote
For a fixed quote, give us a call on 01277 525 020 or use the quote form, telling us the site location and the nature of the job. You can also send details through our quote form.
Related advice
Cost factors for service penetrations
A fixed quote reflects the actual work. It takes account of:
- How accessible the joints are
- The total length or number of joints
- Specialist products, such as fire-rated or hygienic sealants
- Induction, permit and paperwork requirements
The price depends on the quantity of joints, what has to come out first and the access. Call for a fixed quote once you have the details.
What to include in your enquiry
We can often quote from photos and a few details. It helps to include:
- The postcode of the building
- Asbestos survey details if the building is older
- Drawings or a marked-up plan, if available
- Specification clauses that apply
Quotes are fixed against the scope you send, so you know the figure before anyone is on site. To start the process, call 01277 525 020 or email us.
Why deal with it now?
An improvised seal can look finished while offering no tested performance. Correcting it means cutting it out and starting again with the specified product, and doing it once, properly, is cheaper. Around smaller places like Kinrossie, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Early resealing prevents it.
There’s no price list, because the scope varies so much from one building to the next. For a fixed figure, call for a quote.
Why clients in Kinrossie choose us
- Public liability insurance in place
- Constructionline member
- Specification-led, product-correct work
- Sealing commercial buildings since 2005
Read how commercial sealant jobs are priced or our accreditations.
What sealant work can’t fix
Sealant solves a lot, but not everything, and we’re upfront when that’s the case. It won’t fix:
- Plastic pipes whose detail calls for a collar or wrap
- Issuing fire ratings or certificates for seals
- Designing or specifying fire stopping, which sits with the designer or fire engineer
If in doubt, phone 01277 525 020 or use the quote form and we’ll say what we think.
What we seal
- Service gaps in risers
- Pipe penetrations
- Cable penetrations
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
For managing agents and facilities managers
Blocks and communal areas make up much of the work for housing associations and agents. We phase the work so people keep access, with each stage agreed with your site contact.
Whether you’re a managing agent, a property factor or an owner’s representative: send details, get a fixed quote, we seal, guaranteed. We can agree access arrangements and keyholder contacts beforehand.