Fire-rated sealing and fire stopping in Kilmartin, Argyll and Bute
Our CSCS-carded applicators take on fire-rated and intumescent sealing of service penetrations and linear gaps in Kilmartin. Send photos or drawings for a fixed quote.
- Fire-rated sealant that has cracked or shrunk back
- Seals disturbed by maintenance and left open
- Open linear gaps along the top of fire-resisting walls
Need fire stopping in Kilmartin?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
On site: what to expect
We begin with a short walk round with whoever looks after the building, to confirm the scope, the order of work and any areas we must keep clear. Then we strip out anything that has failed, prepare every joint and seal it. Jobs near Kilmartin are often grouped with others in the same area. Tell us how flexible your dates are.
- First we go through the drawings, schedule or specification for the seals and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- Openings that need a collar, wrap, batt or other product are flagged to you rather than filled with sealant.
Preparing the site
- Point out parking and an unloading spot
- Share the asbestos register for older buildings
- Agree which areas must stay open
Getting a fixed quote
Send details, get a quote, we seal, guaranteed: that’s how every job runs. To take the first step, phone 01277 525 020 or use the quote form.
Related advice
Fire stopping in Kilmartin
On a fit-out or refurbishment, we follow the services contractors floor by floor. We work from your penetration schedule or marked-up drawings alongside the manufacturer’s details. Tell us what records you need and we’ll confirm with the quote. Site teams most often ask us about openings left by services added after handover and improvised or mixed-product fire seals, on small duct penetrations where the tested detail allows, joints between fire-resisting walls and floors and service gaps in risers. Whoever orders the work in Kilmartin, the brief is normally the same: a clear scope, tidy work and joints that don’t fail again.
Refurbishments in small hotels, schools and care homes around places like Kilmartin can leave gaps around new services. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
Our workmanship is guaranteed for 12 months, in Kilmartin as everywhere else we work. If our installation lets you down in that time, we return and fix it.
- Where
- Kilmartin (PA31)
- Region
- Argyll and Bute
- Guarantee
- 12 months on every job
- Quote
- Quoted before any work starts
- Call
- 01277 525 020
- Updated
- 3 November 2026
Signs you need fire stopping in Kilmartin
Plenty of openings were simply never closed. Inspections, refurbishments and ceiling access normally bring them to light.
Clients normally get in touch after noticing something like this:
- Seals disturbed by maintenance and left open
- Builders’ foam or ordinary silicone in compartment walls
- Penetration schedules that need working through
- Service penetrations left open after M&E works
In a hotel such as Kilmartin Hotel, which lies south of Kilmartin, new pipework or cabling through bedroom and corridor walls needs sealing with the specified product.
Comparing quotes
- How the existing material will be dealt with
- How the joint faces will be prepared and primed
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- Will CSCS-carded applicators be on site?
When something else is needed
Part of a good diagnosis is knowing where sealant stops. We will tell you if the real problem is one of these:
- Gaps in walls that were never built as compartment walls
- Signing off or certifying a building’s fire stopping
- Large openings beyond what any sealant detail covers
Not sure which it is? You can call the office on 01277 525 020 or send details through our quote form and we will tell you honestly before you book.
Where we work in Kilmartin
- Joints between fire-resisting walls and floors
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Pipe penetrations
- Service gaps in risers
- Cable penetrations
Different surfaces, different methods
Cables and cable bundles
New data and power cables are the most common breach we see. Openings around new cables are resealed to the detail, and we tell you if the bundle exceeds what sealant covers.
Risers and ceiling voids
Voids hide a lot of unsealed openings. We follow your schedule area by area, and note anything we find that isn’t on it.
Nearby places to Kilmartin
Also in Kilmartin
After the work
Sealant joints are maintenance items, and how long they last depends on how they’re treated. Our advice:
- Keep product data and details in the fire safety file
- Report damaged or disturbed seals as soon as they’re spotted
- Settle who seals which penetrations at the start of a project
- Arrange inspection before areas are covered up
Store the specified product details somewhere the next contractor can find them. Anyone resealing later needs to know which product and detail were used.
Looking at service areas on a regular cycle pays off. Catching a damaged seal early keeps the fix small compared with dozens found at once.
Leave it or put it right?
Leave a penetration open and smoke and fire can cross into the next compartment far earlier than intended. Putting it right is usually a modest job when the openings are accessible. Wait until ceilings close or areas are occupied and the same work becomes harder to reach. Around smaller places like Kilmartin, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Early resealing prevents it.
The work involved drives the cost: stripping out, preparation, sealing, access and phasing. Call for a quote.
Why choose Mastic Doctor in Kilmartin
- Commercial sealant work since 2005
- Work to your specification and the manufacturer’s guidance
- Joints cleaned back to sound surfaces
- One phone line for London, the South East and Scotland
Take a look at what affects the cost and how we’re accredited.
Questions about Kilmartin
How do Scotland’s building standards affect fire-rated sealant in Kilmartin?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. The detail is set by the designer and goes through the warrant process; we install the specified product to its tested detail.
Do you design the fire stopping for buildings in Kilmartin?
No. Fire-stopping design and sign-off belong to the designer, principal designer, fire engineer or building control. We install fire-rated and intumescent sealant around service penetrations and linear gaps where it is specified, to the manufacturer’s tested detail.
What do you charge?
It depends on the job: quantities, access, the product and any phasing. Call for a quote.
When is resealing likely to be due?
It depends on movement, UV and weather, cleaning, traffic and the product. Sealant joints are maintenance items, so inspect them regularly.
Can you follow the specification on our project?
Yes. The specification and the manufacturer’s installation guidance are what we work to, and any queries are raised before we start.
Do you seal on top of existing sealant?
No. Sealing over old material is one of the classic causes of early joint failure, so everything comes out first.
Can one quote cover more than one building?
Yes. A group of buildings can go on one quote, with one point of contact across South East England, Greater London and Scotland.
Where services cross fire walls in Kilmartin
Under the Scottish non-domestic Technical Handbook, clause 2.1.14, penetrations should be fire stopped to at least the wall or floor’s fire resistance duration, and products should be tested for their end use. We install what’s specified, to the product’s tested detail.
Halls and meeting rooms at places like Kilmartin Parish Church sometimes gain new services, and any compartment wall crossed needs the specified seal.
Kilmartin is about 30 miles north-west of Greenock, in Argyll and Bute. Looking for fire stopping in Kilmartin? We can help. Our Argyll and Bute coverage takes in 124 places. We also cover Glasgow, around 51 miles from Kilmartin.
Anyone looking for fire stopping in PA31 gets the same process as the rest of our area: send details, get a quote, we seal, guaranteed. We also cover Kilmichael Glassary (4 miles south-east), Ardfern (4 miles north-west), Bridgend (4 miles south), Cairnbaan (5 miles south) and Barravullin (5 miles north). A short drive away, we cover Ceann Loch Gilb (7 miles south), Lochgilphead (7 miles south) and Ardrishaig (8 miles south). For island and remote sites, we plan travel and materials carefully, so the full address helps from the start.
What’s near Kilmartin
Other landmarks nearby include Carnasserie Castle (1.2 miles north) and Kilmartin Museum (less than half a mile south-west). Not far away are Lochan Add and Druim an Achanarnich.