Fordoun fire stopping
Planning work on a service penetration in Fordoun? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Builders’ foam or ordinary silicone in compartment walls
- Openings left by services added after handover
- Seals that don’t match their tested detail
Fire stopping in Fordoun
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Fire stopping in Fordoun
The test standards are BS EN 1366-3 for penetration seals and BS EN 1366-4 for linear joints. That classification, such as EI 60 or EI 120, belongs to the product in its tested arrangement. So our job is to reproduce that arrangement faithfully. If you’re dealing with unsealed penetrations discovered above suspended ceilings and fire stopping installed outside its tested range, we can put it right, whatever the surface. Sealant applicators who only do sealant are a different proposition from a general trade with a gun in the van: on jobs in Fordoun, preparation and product choice get the time they need.
Hotels and care homes around smaller places like Fordoun often have services added during refurbishment. We fit the specified fire-rated sealant as its published detail shows and raise it if another product is needed.
Our workmanship is guaranteed for 12 months. If a joint we sealed fails because of how it was installed, we come back and put it right.
- Where
- Fordoun (AB30)
- Wider area
- Aberdeenshire
- Guarantee
- 12 months on our workmanship
- Quotes
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Leave it or put it right?
An unsealed opening affects more than fire safety: they also carry noise, draughts and smells between rooms. Sealing them to the specified detail deals with the fire risk first, and the other benefits follow. For buildings near Fordoun, dealing with all the failing joints at once saves return trips. Send photographs and we will quote for everything together.
The product called for affects the cost, as does the preparation each joint needs. Access, phasing and site rules also count.
What you get with us
- CSCS-carded applicators
- Joints cleaned back to sound surfaces
- Specification-led, product-correct work
- Clear, fixed quotes
Read what affects the cost and our accreditations.
Work for main contractors and building owners
Whether you’re a managing agent, a property factor or an owner’s representative: send details, get a fixed quote, we seal, guaranteed. Keys, access and contacts can be agreed in advance.
If you look after buildings for someone else, clear figures and clear communication matter. We quote a fixed sum, confirm the scope and walk the finished work with you or your representative.
Nearby places to Fordoun
Other services in Fordoun
From enquiry to sign-off
On arrival, we sign in, go through any site induction and check how permits are handled. Everything around the joints gets protected before any cutting starts, and the work typically takes a single visit for a short list of penetrations, or a phased programme for a whole building. Jobs near Fordoun are often grouped with others in the same area. Let us know if your dates have any give.
- First we go through the drawings, schedule or specification for the seals and raise any questions before we price.
- On site, each opening is checked against the tested detail it is meant to follow.
- Anything that doesn’t belong in the opening, such as expanding foam or general-purpose filler, is removed.
- Mineral wool or other backing goes in wherever the detail asks.
- Fire-rated or intumescent sealant is gunned in to the specified depth, then tooled.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Make sure the joints can be reached
- Send any specification or drawings in advance
- Share your working hours and any access restrictions
Getting a fixed quote
Send details, get a quote, we seal, guaranteed: that’s how every job runs. To take the first step, give us a call on 01277 525 020 or email us.
Read more
When it isn’t the sealant
We seal joints; we don’t mend everything behind them. Sealant alone won’t deal with:
- Gaps in walls that were never built as compartment walls
- Large openings beyond what any sealant detail covers
- Reviewing a building’s overall fire safety
Not sure which it is? You can call the office on 01277 525 020 or email us and we’ll tell you honestly.
Joints and surfaces we work on
- Service gaps in risers
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Cable penetrations
- Pipe penetrations
- Joints between fire-resisting walls and floors
How the quote is worked out
Before we quote, we look at:
- The site’s rules and procedures
- Quantities, in metres or numbers
- Location, for remote and island sites
- Whether the work must be split into stages
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we’ll put a fixed figure on it.
Before you send an enquiry
We can often quote from photos and a few details. It helps to include:
- The postcode of the building
- Anything awkward about access or site hours
- Rough lengths or quantities, or drawings if you have them
- The product your specification calls for
Need a figure for a tender or a budget? We will quote against your scope and drawings you can plan around. If you have questions first, speak to us on 01277 525 020 or email a schedule or drawings.
Service penetrations in Fordoun buildings
In Scotland, clause 2.1.14 of the non-domestic Technical Handbook expects service penetrations to keep at least the fire resistance duration of the wall or floor, and products should be tested for their end use. We install what’s specified, to the product’s tested detail.
For any site around Fordoun, we work to the specification and the manufacturer’s installation guidance, leaving design and sign-off with the designer. For buildings in and around Fordoun, fire-rated sealant is installed where it is specified, to the manufacturer’s tested detail.
Fordoun is about 11 miles north of Montrose, in Aberdeenshire. We cover Fordoun and the rest of Aberdeenshire, with the same fixed quotes and 12-month guarantee as everywhere else. Fordoun is one of 179 places in Aberdeenshire on our list for service penetrations. Our Aberdeen page has more on work in that area, about 22 miles away.
Commercial sites across AB30 are covered for service penetrations. We cover commercial and managed buildings on Station Road, Redhall Avenue and Redhall Place and the roads nearby. Close to Fordoun, our area also takes in Auchenblae (2 miles north-west), Arbuthnott (3 miles east), Glenbervie (3 miles north), Laurencekirk (4 miles south-west) and Drumlithie (4 miles north-east). Bigger towns within reach include Stonehaven (10 miles north-east), Banchory (13 miles north), Newtonhill (15 miles north-east), St Cyrus (7 miles south), Johnshaven (6 miles south-east) and Chapelton (14 miles north-east).
Landmarks near Fordoun
The closest station to Fordoun is Laurencekirk station, roughly 3.2 miles south-west of the centre. Nearby you’ll also find Drumtochty Castle (4 miles north-west). The countryside around Fordoun includes Herscha Hill.
FAQs: Fordoun
Is Fordoun too far out for you?
No. Small places get the same service as large ones. Our area covers all of Scotland, cities, towns and islands alike. Good photos up front let us bring everything on the first visit.
Which Scottish guidance covers penetration seals in Fordoun?
The non-domestic Technical Handbook, clause 2.1.14, expects a penetration to keep at least the wall or floor’s fire resistance period, with proprietary products tested for the use they’re put to. We install what has been specified, to the manufacturer’s tested detail, while design and approval sit with the designer and the verifier.
Can you send site paperwork?
Each site asks for different documents, so list what you need, whether RAMS, insurance or CSCS details, and we’ll confirm with the quote.
How long does a job like this take?
We plan the time on site around your programme and access. We’ll give you an estimate of time on site when we quote.
Can you quote from photographs?
Photos, drawings or a schedule are often enough to quote. If the job needs a look first, we’ll arrange a visit.
Which sealant will you use?
A specification, where there is one, decides it. Without one, the joint decides: its movement, its surfaces and what it has to cope with.
Can you work while the building is occupied?
In the majority of cases, yes. Phased work can be planned so areas stay in use.
When to bring in a specialist
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class, which is what makes a joint last.
A short, simple internal joint is often within reach of a maintenance team. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.