Fire Stopping in Castledykes
Need fire stopping in Castledykes? Send us the details for a fixed quote, backed by a 12-month guarantee on the work.
- Openings found when ceilings come down for a refit
- Snag lists that include open service penetrations
- Expanding foam used as fire stopping
Fire stopping in Castledykes
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
How we handle fire stopping in Castledykes
Sealant is the specified answer for plenty of openings, such as metal pipes, cables and some small ducts where the detail covers them. Larger openings and some plastic pipes call for collars, wraps, batts or boards instead. If the detail calls for something other than sealant, we say so rather than force sealant into it. Most enquiries involve fire seals cut back for extra cables and never reinstated and unsealed openings around new pipes and cables, on pipe penetrations, joints between fire-resisting walls and floors and linear gaps at wall heads. One point of contact handles commercial sealant work in Castledykes from the first photos to the final walk-round, whether it’s one building or several.
Around smaller places such as Castledykes, compartment walls and floors tend to be in schools, hotels, care homes and community buildings. Where services pass through, specified fire-rated sealant is installed following the manufacturer’s guidance for that wall or floor.
What our 12-month guarantee covers is the way we did the job: preparation, application and finish. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Location
- Castledykes (DG2, DG1)
- Region
- Dumfries and Galloway
- Guarantee
- 12 months on every job
- Price
- Quoted before any work starts
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
Where services cross fire walls in Castledykes
Scotland has its own building standards: the non-domestic Technical Handbook (clause 2.1.14) says service penetrations should be fire stopped to at least the fire resistance duration of the wall or floor, with proprietary products, intumescent ones included, tested for their end use. We install fire-rated sealant to that tested detail where it is specified. There are several hotels within about 2 miles of Castledykes. In hotels, bedroom and corridor walls are typically fire-resisting, so services added in a refit need sealing with the specified product.
For a hospital such as Midpark Hospital (0.7 miles south-east of Castledykes), penetration sealing is normally phased ward by ward, with infection-control rules agreed first. On estates like St. Mary's Industrial Estate, 1.4 miles to the north of Castledykes, the wall between office and warehouse is often fire-resisting, and cables through it need the specified seal.
Castledykes is about 1 mile south of Dumfries, in Dumfries and Galloway. Castledykes sits inside our coverage and the rest of Dumfries and Galloway, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. Across Dumfries and Galloway, 139 places are covered, including Castledykes. There’s a separate page for Glasgow, roughly 61 miles from Castledykes.
Postcode districts covered here: DG2 and DG1. If your site is on Moat Road, Beck Avenue and Hill Avenue or close by, we can quote for service penetrations. Just outside Castledykes, we also work in Troqueer (1 mile north), Kingholm Quay (1 mile south), Dumfries (1 mile north), Cargenbridge (1 mile west) and Newbridge Drive (2 miles north-west). Nearby towns on our patch include Annan (15 miles east), Lockerbie (11 miles north-east), Dalbeattie (12 miles south-west), Castle Douglas (15 miles south-west), Heathhall (3 miles north-east) and Lochmaben (8 miles north-east).
Near you in Castledykes
Around Castledykes, our work takes us to commercial buildings near Queen O' The South Public House and the streets around them. Castledykes’s nearest station is Dumfries station, roughly 1.2 miles north of the centre. Nearby you will also find Crichton Royal Museum (0.5 miles south-east) and Dumfries and Galloway Royal Infirmary (under half a mile east). Not far away are Lochaber Loch.
After the work
A few simple habits keep the new joints working:
- Record which product was used where
- Get seals inspected before ceilings and boxing close
- Check risers and ceiling voids after each round of works
- Brief every trade that openings they make must be sealed
Allow the manufacturer’s stated cure time before boxing in or decorating. Not every fire-rated product can be painted, so check the product data first.
Ask every contractor who works in risers or voids to report openings they create. It costs little and catches breaches early.
What we can’t put right
Part of a good diagnosis is knowing where sealant stops. You’ll hear from us if the cause turns out to be any of the following:
- Walls or floors that aren’t fire-resisting to begin with
- Plastic pipes whose detail calls for a collar or wrap
- Fire doors, dampers or other fire safety equipment
If you’re not sure, just give us a call on 01277 525 020 or send photos by email and we’ll give you a straight answer before you book.
Surfaces we seal
- Linear gaps at wall heads
- Small duct penetrations where the tested detail allows
- Joints between fire-resisting walls and floors
- Cable penetrations
- Pipe penetrations
- Service gaps in risers
How the quote is worked out
To price the job, we consider:
- How much existing material needs removing
- Backing rod, priming and other preparation
- How much there is to seal
- Travel to remote or island sites
There’s no price list, because the scope varies so much from one building to the next. Call for a quote.
Before you send an enquiry
To price the job accurately, we need to understand the site. Send us:
- Specification clauses that apply
- When you need the work done
- Whether an asbestos survey exists
- What the building is and how it’s used
The quickest route to a quote is a few photos and the site postcode. Send them through the quote form, or call the office on 01277 525 020 or email a schedule or drawings to discuss it first.
Also near Castledykes
What else we do in Castledykes
How a job runs
At the end of each section, we remove the tape, clean down and inspect every joint, ready for your sign-off. Where the sealant needs time to cure before use, we tell you and sign the area. Tell us who will meet us and how to get in at your building near Castledykes. That goes into the plan alongside the quote.
- We ask for the product and detail your designer has specified.
- We sort the openings by the detail each one needs.
- Improvised fillers and failed sealant are removed.
- Mineral wool or other backing is fitted where required.
- Fire-rated or intumescent sealant goes in around the services and is tooled off.
- Completed areas are checked with you, with the records agreed when we quoted.
Getting the site ready
- Send your site hours and access windows
- Agree which areas must stay open
- Clear stock, furniture or equipment away from the joints
Getting a fixed quote
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, ring 01277 525 020 or send details through our quote form.
Related advice
FAQs: Castledykes
Will you plan work around the academic year at somewhere like Crichton University Campus?
Yes. Tell us the term dates, vacation periods and access windows, and we will plan the work around them. We are CHAS accredited and a Constructionline member, and paperwork such as RAMS is confirmed with the quote.
Is Castledykes too far out for you?
Not at all. Castledykes is within our area. Our area covers all of Scotland, cities, towns and islands alike. Send photographs and a list of what needs doing, and we will plan the job to need as few trips as possible.
What site paperwork can you supply?
Tell us what site paperwork you need (RAMS, insurance certificate, CSCS details) and we will confirm with the quote.
How do we ask for a quote?
It works in four steps: send details, receive a fixed quote, we carry out the work, and it’s guaranteed. The first step only needs photographs and a postcode.
Can you fire stop behind the services contractors?
Yes. Share the penetration schedule and product details and a fixed quote follows. Work can run area by area behind the M&E trades.
Do you seal on top of existing sealant?
No. Sealing over old material is one of the classic causes of early joint failure, so everything comes out first.
Is colour matching possible?
It depends on the product specified. Some ranges are wide, others limited, so we will confirm the colours available for the specified product with the quote.
What the job involves on each surface
Masonry and concrete
Block walls and concrete floors are common substrates for penetration seals. Dust and debris are cleared from the opening.
Risers and ceiling voids
Openings above suspended ceilings are easy to miss. We follow your schedule area by area, and note anything we find that isn’t on it.
When to call us in Castledykes
When a seal departs from its tested detail, the evidence no longer covers it. An oversized gap, too shallow a bead, missing backing or two makers’ products combined are what we find most often.
It’s worth sending us details if you spot any of the following:
- Snag lists that include open service penetrations
- Unsealed openings around new pipes and cables
- Expanding foam used as fire stopping
- Open linear gaps along the top of fire-resisting walls
At a college such as Dumfries & Galloway College - Dumfries Campus (0.9 miles south-east of Castledykes), checking penetration seals after summer M&E works is good practice.
What to look for in a quote
- Whether their applicators hold CSCS cards
- Is the sealant right for the movement and the substrate?
- Are they CHAS accredited or on Constructionline?
- What the guarantee covers, and for how long