Fire stopping in Cannich
Work needed on a service penetration in Cannich? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Openings left by services added after handover
- Fire sealant pulled out of the opening
- Penetration schedules that need working through
Fire stopping near Cannich
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Quoting for work in Cannich
Quotes vary with the job. Expect it to depend on:
- Site requirements such as inductions and permits
- Backing rod, priming and other preparation
- Location, for remote and island sites
- Working within restricted access windows
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote and we will put a fixed figure on it.
What to include in your enquiry
However big the job, these details speed things up:
- Anything awkward about access or site hours
- When you need the work done
- Rough lengths or quantities, or drawings if you have them
- Specification clauses that apply
We quote a fixed sum against the scope you give us, so you know the figure before anyone is on site. To start the process, ring 01277 525 020 or email a schedule or drawings.
About our fire stopping in Cannich
No fire sealant works on its own: the evidence covers a specific product, wall or floor type, service, gap, depth and backing. Before we seal anything, we check the opening against the detail it is meant to follow. The enquiries we see most involve head-of-wall gaps with no fire seal and improvised or mixed-product fire seals, on small duct penetrations where the tested detail allows, pipe penetrations and service gaps in risers. A single leaking joint is often how a building in Cannich first comes to us: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Travel to smaller places like Cannich is planned so every penetration is sealed on one trip. Send the specification and photos of the openings, with sizes if you have them.
The 12-month guarantee covers our workmanship: preparation, application and finish. Damage, later alterations by others and movement beyond what the joint was designed for sit outside it.
- Location
- Cannich (IV4)
- Wider area
- Highland
- Cover
- 12 months on every job
- Quotes
- Quoted before any work starts
- Call
- 01277 525 020
- Page updated
- 3 November 2026
Fire stopping in Cannich: the local picture
Scottish guidance (non-domestic Technical Handbook, clause 2.1.14) asks that penetrations match at least the fire resistance period of the element they pass through, with products tested for that end use. We install fire-rated sealant to that tested detail where it is specified.
Around Cannich, we install fire-rated and intumescent sealant to the product’s tested detail wherever it is the specified product.
Cannich is about 22 miles south-west of Inverness, in Highland. Cannich sits inside our coverage and the rest of Highland, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. We work across 256 places in Highland.
Work on service penetrations is covered throughout IV4. Streets here include Bein Achairen View and Maccoll Road, and sites on any of them can send details for a fixed quote. Nearby places we also cover include Invermoriston (10 miles south-east), Drumnadrochit (10 miles east), Lewiston (11 miles east), Glen Moriston (12 miles south) and Kiltarlity (12 miles north-east). Where a site is remote or on an island, travel and materials need planning ahead, so the full address helps from the start.
Landmarks near Cannich
Green spaces nearby include Loch Craskie.
Looking after the joints
Your facilities or cleaning team can help the joints last. Share these points with them:
- Arrange inspection before areas are covered up
- Flag new cables with no seal around them
- Settle who seals which penetrations at the start of a project
- Keep general-purpose fillers away from compartment walls
Give the sealant its full cure time before ceilings, boxing or decoration go over it. Not every fire-rated product can be painted, so check the product data first.
Ask every contractor who works in risers or voids to report openings they create. Small habits like this stop openings building up.
When to call us in Cannich
When a seal departs from its tested detail, the evidence no longer covers it. An oversized gap, too shallow a bead, missing backing or two makers’ products combined are the usual culprits.
What tends to prompt an enquiry:
- Hidden openings found during inspections
- Unsealed openings around new pipes and cables
- Penetration schedules that need working through
- Seals that don’t match their tested detail
For a building such as Our Lady and St Bean's Rc Chapel, new heating or data runs are the usual reason penetrations need sealing.
Questions to ask before you book
- Health and safety accreditation such as CHAS
- Their public liability cover
- Whether primer will be used where the manufacturer specifies it
- How they’ll work around occupants
What the job involves on each surface
Small ducts
We seal around ducts only within what the tested detail covers. Dampers and ductwork systems themselves are outside our work.
Metal pipes
Heat travels along metal pipework, and some details add wrapping or a set length of insulation. If the detail needs something beyond sealant, we tell you.
Common questions from Cannich clients
Is Cannich too far out for you?
No. Places such as Cannich are covered as much as the big towns. Our area covers all of Scotland, cities, towns and islands alike. We plan jobs in smaller places so return trips are kept to a minimum.
Do you decide the fire-stopping details for buildings in Cannich?
No. The designer or fire engineer sets the detail and building control accepts it. Our part is installing the specified product to its tested detail, and telling you if the detail calls for something other than sealant.
What about RAMS and site documents?
Each site asks for different documents, so list what you need, whether RAMS, insurance or CSCS details, and we’ll confirm with the quote.
Do your applicators hold CSCS cards?
Yes. If you need card details for site access, let us know and we will send them with the quote.
Can the building stay open while you work?
Yes, with some planning. We agree a sequence with your contact so just one area at a time is disrupted.
How long do sealant joints last?
There isn’t a single answer, since movement, weather, cleaning and use all affect it. Regular inspection is the best way to catch problems early.
Who decides which product is used?
If the job is specified, we follow the specification. Otherwise, we recommend a product to suit the joint’s movement, the substrate and the conditions, following the manufacturer’s guidance.
Nearby places to Cannich
Other services in Cannich
When to bring in a specialist
Redoing a failed joint usually costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. That’s why many clients bring in a specialist from the beginning.
For most general trades, sealant is a sideline. A specialist prepares properly, controls joint depth and picks a product with the right movement class.
How a job runs
Our CSCS-carded applicators arrive with the sealants, primers and backing rod the job calls for. Any old material is cut back to clean, sound faces, primer goes on where the manufacturer specifies it, and each bead is tooled to a neat concave finish. For work around Cannich, we aim for one trip, which is why we ask for photos and a full list first. Outside work also needs a suitable weather window.
- The specification and schedule come first, so we know which details apply.
- Access, permits and the order of areas are agreed with the site team.
- We compare every service penetration with its tested detail before sealing.
- Foam, ordinary sealant and debris come out.
- The specified backing and sealant go in to depth and are finished neatly.
- Anything outside the detail is reported to you rather than sealed.
Before we start on site
- Clear stock, furniture or equipment away from the joints
- Let building users know which areas are affected
- Arrange parking or a loading space
Quotes
Send details, get a quote, we seal, guaranteed: that’s how every job runs. The first step is to call the office on 01277 525 020 or send photos by email with what you know.