Fire-rated sealing and fire stopping in Aldborough Hatch, Greater London
Work needed on a service penetration in Aldborough Hatch? We assess it, carry out the work and guarantee our workmanship for 12 months.
- Head-of-wall gaps with no fire seal
- Fire-rated sealant that has cracked or shrunk back
- Hidden openings found during inspections
Fire stopping for Aldborough Hatch sites
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
How a job runs
At the end of each section, we remove the tape, clean down and inspect every joint with your site contact. If an area should be left alone while the sealant cures, we say how long and put signs out. For a job in Aldborough Hatch, access comes first: booked loading, goods lifts, the building’s permit system and a spot to keep materials. Give us the hours we can be on site and we’ll schedule to suit.
- We read the specification, drawings or penetration schedule you send and ask about anything unclear.
- On site, each opening is checked against the tested detail it is meant to follow.
- Unsuitable fillers and loose debris are taken out of each opening.
- We fit the backing the detail asks for, to the stated depth.
- We apply the specified sealant to the depth and around the services as the detail shows.
- If an opening needs something other than sealant, we tell you instead of improvising.
Before we start on site
- Let us know about inductions and permits
- For older buildings, check the asbestos register before work
- Explain the parking and delivery arrangements
Getting a fixed quote
To get a fixed quote, ring 01277 525 020 or email drawings and photos. You can also send details through our quote form.
Advice
Fire stopping in Aldborough Hatch, done properly
Where pipes, cables and other services cross a compartment wall or floor, the opening around them has to be closed so fire and smoke can’t move between compartments. Our job is fitting fire-rated and intumescent sealant at those service penetrations, and along linear gaps, where it is the specified product. Each seal follows the manufacturer’s tested detail. We work on linear gaps at wall heads, service gaps in risers and pipe penetrations, and the usual reasons a site gets in touch are expanding foam used as fire stopping and old intumescent sealant that has split away. Searching for sealant specialists in Aldborough Hatch? We’ve been sealing commercial buildings since 2005, with CSCS-carded applicators.
In a London area such as Aldborough Hatch, buildings are refitted often, and every new cable, pipe or duct through a fire-resisting wall or floor leaves a gap. Each service penetration gets fire-rated or intumescent sealant if that’s what is specified, laid to the product’s tested arrangement.
Every job is signed off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Where
- Aldborough Hatch (IG2, IG3, RM6)
- Region
- Greater London
- Guarantee
- 12 months on our workmanship
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
What affects the price in Aldborough Hatch
We price every job individually. The main factors are:
- The size and state of each joint
- Whether the work must be split into stages
- How much there is to seal
- How accessible the joints are
We don’t publish prices, because the scope varies so much from one building to the next. Call for a quote and we’ll price your job on its own details.
Sending details for a quote
The more we know, the firmer the quote. Helpful details to send:
- Any dates the work must fit around
- A wide shot and a close-up of the area
- How the joints are reached, and at what height
- Rough lengths or quantities, or drawings if you have them
Photos, drawings or a schedule of the joints and a fixed quote comes back to you. If the job needs a look first, we will arrange a site visit.
Should maintenance staff do it?
Paperwork matters too. Many sites expect CSCS cards, RAMS and proof of insurance, and we will confirm the paperwork you need with the quote.
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
FAQs: Aldborough Hatch
What happens to BS 476 references for fire stopping in Aldborough Hatch?
Approved Document B loses its BS 476 references from 2 September 2029, and BS EN 13501-2 becomes the route, subject to transitional arrangements. Our part doesn’t change: the specified product, to its tested detail.
Can you seal around new services in a hotel near Aldborough Hatch?
Yes. We install fire-rated and intumescent sealant where it is specified. Work is done room by room so the hotel keeps trading; design and sign-off stay with the designer and building control.
What do you charge?
That depends on the job: the volume of work, the access, the specified product and how it’s phased. Call for a fixed quote.
Can you follow the specification on our project?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and any queries are raised before we start.
Will your applicators have CSCS cards?
Yes. We use CSCS-carded applicators, as many construction sites ask for.
Are you insured?
Yes. Mastic Doctor is fully insured, public liability included.
What happens if old sealant might contain asbestos?
The duty to manage asbestos sits with the building’s dutyholder, so we’ll ask for the register before work on an older building. Work pauses if suspect material is found, until it has been tested.
What we’re called out for in Aldborough Hatch
Some seals fail because the wrong product went in: builders’ foam or ordinary silicone used to fill a hole. It may look closed, but it has no tested fire performance in that position.
Things that usually lead to an enquiry:
- Old intumescent sealant that has split away
- Penetration schedules that need working through
- Improvised or mixed-product fire seals
- Unsealed joints where partitions meet the slab
At a healthcare site like King George Hospital, less than half a mile east of Aldborough Hatch, new services through compartment walls are a constant, and each needs the specified seal.
Comparing quotes
- Whether primer will be used where the manufacturer specifies it
- How the existing material will be dealt with
- How long is the guarantee, and what does it include?
- Health and safety accreditation such as CHAS
Surface by surface
Metal pipes
Heat travels along metal pipework, and some details add wrapping or a set length of insulation. We follow whatever the detail requires and flag anything we can’t match.
Drylining partitions
Service holes through plasterboard are frequently oversized or ragged. An oversized hole may be outside the sealant’s range and we will tell you what the detail says instead.
Fire stopping around Aldborough Hatch: points for this area
The 2 miles around Aldborough Hatch include two care or nursing homes. In a care home, any new pipe or cable through a fire-resisting wall should be sealed to the specified detail. The area within 2 miles of Aldborough Hatch holds plenty of hotels. Bedroom-to-corridor walls in hotels are normally fire-resisting, so new cabling or pipework through them has to be sealed to the tested detail.
Workshops and IT rooms at colleges like New City College, 0.8 miles to the east of Aldborough Hatch, are re-serviced often, leaving penetrations to seal. Refits at places like Newbury Retail Park (0.9 miles south-west of Aldborough Hatch) often reroute services through walls between units.
Aldborough Hatch is about 2 miles north-east of Ilford, in Greater London. Commercial clients in Aldborough Hatch use us for work on service penetrations. Aldborough Hatch is one of 764 places in Greater London on our list for service penetrations. We also cover London, around 10 miles from Aldborough Hatch.
We cover the IG2, IG3 and RM6 postcode districts. Buildings on Oaks Lane, Chase Lane and Mendip Road are within our area. Being close to the A12, Aldborough Hatch is easy to get to with materials and equipment. If your building is just outside Aldborough Hatch, we cover Little Heath (1 mile east), Goodmayes (1 mile south), Chadwell Heath (2 miles east), Marks Gate (2 miles north-east) and Becontree Heath (2 miles south-east). Nearby towns on our patch include London (10 miles south-west), City of Westminster (12 miles south-west), Marylebone (12 miles west), Kensington (14 miles south-west), St Pancras (10 miles west) and Shoreditch (9 miles south-west).
Landmarks near Aldborough Hatch
Recent enquiries here include premises near Oaks Park High School and Fairlop Waters, among other places. Aldborough Hatch’s nearest station is Goodmayes station, roughly 1.2 miles south-east of the centre. Well-known places in the area include Redbridge Museum (2 miles south-west) and King George Hospital (under half a mile east). Not far away are Hollow Pond and Hainault Lodge.
Also near Aldborough Hatch
More services for Aldborough Hatch
What happens if it’s left?
Sealing behind the M&E trades area by area beats a sweep at the end. Openings are visible, access is open and nothing has to be taken down. Failed sealant in a building in Aldborough Hatch can quickly affect neighbours, tenants or the floor below: water travels through shared structures, and a small leak becomes a dispute between occupiers. Dealing with it early is simpler for everyone.
Small jobs and large programmes are priced from the same things: what’s in scope, how we reach it, what’s specified and when it needs doing. Call for a quote, and you will have a fixed figure to work with.
Why us?
- Fully insured, including public liability cover
- Work to your specification and the manufacturer’s guidance
- A fixed quote before work starts
- Constructionline member
Take a look at how commercial sealant jobs are priced and how we’re accredited.