Dial Post facade sealing
Work needed on a facade joint in Dial Post? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Air leaks through failed facade joints
- Staining on stone next to old sealant
- Failed sealant on precast panel joints
Facade sealing in Dial Post
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Facade sealing in Dial Post
Weather decides a lot in facade sealing. Joints have to be dry and the air and surface temperature within the product’s range, so frosty or damp mornings can hold work back. We plan for that and keep you updated. We work on stone and brick facade joints, window and door perimeters and shopfront frames, and the usual reasons a site gets in touch are failed seals around shopfront and entrance frames and facade joints cracked through the middle. A single leaking joint is often how a building in Dial Post first comes to us: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Around smaller places like Dial Post, building work normally means conversions of farm buildings, a few new houses or an extension to a hall or school. Perimeters, facade joints and internal sealant all need doing properly, however small the scheme.
Our 12-month guarantee is about workmanship, not wear and tear. Sealant wears with time, and movement, weather, cleaning and use decide how fast, so we spell out the cover before we begin.
- Place
- Dial Post (RH13)
- Wider area
- West Sussex
- Cover
- 12 months on our workmanship
- Quote
- Fixed quote, scope in writing
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
When something else is needed
A proper diagnosis includes knowing what sealant can’t do. You will hear from us if the cause turns out to be any of the following:
- Leaks from roofs, gutters or failed flashings rather than sealant joints
- Work on the window or framing system itself
- Specialist high-level access methods
If you’re not sure, just call the office on 01277 525 020 or email a schedule or drawings and we’ll give you a straight answer before you book.
Joints and surfaces we work on
- Shopfront frames
- Stone and brick facade joints
- Perimeter joints where frames meet the structure
- Cladding panel joints
- Window and door perimeters
- Coping and flashing joints
On site: what to expect
In a busy building, the work is phased so only one area is out of use at a time. Each section is protected, cleaned back and sealed, then reopened once the sealant allows before the next one starts. Smaller jobs around Dial Post can be grouped with others nearby, which keeps travel down. A fixed quote is given before anything starts.
- Access, site rules and timing are settled with the client up front.
- We only seal when joints are dry and within the product’s temperature range.
- Each joint is cut out and the edges inspected.
- Faces are cleaned, primed where needed and backed.
- Sealant is gunned in and tooled hard onto both faces.
- We hand over with our 12-month workmanship guarantee.
Preparing the site
- For older buildings, check the asbestos register before work
- Point out any areas we must not close
- Tell staff and tenants when we will be in
Quotes
Pricing a project or setting a maintenance budget? We will quote against your scope and drawings you can plan around. If you have questions first, speak to us on 01277 525 020 or use the quote form.
Advice
When to call us in Dial Post
Most facade joints fail through age and weathering. UV and weather harden the sealant until it can’t stretch with the building.
It’s worth sending us details if you spot any of the following:
- Old perimeter mastic that has dried out
- Weathered joints at frame-to-structure perimeters
- Cladding panel joints that have opened up
- Facade joints cracked through the middle
On any site in or around Dial Post, the mastic follows the specification and the programme.
Comparing quotes
- Do they follow the manufacturer’s priming guidance?
- Whether old or failed sealant will be cut out, not overlaid
- Is depth set with backing rod, or bond-breaker tape in shallow joints?
- Which product they’ll use, and why it suits the joint
What the job involves on each surface
Perimeter joints at frames and structure
Where framed systems such as shopfronts meet the building structure, there is a perimeter joint to seal. We seal those perimeter joints, not the framing or glazing itself.
Precast concrete panels
Joints between precast panels carry real movement. A sealant of the right movement class goes in over backing rod with primer where the product requires it.
Dial Post: questions and answers
Is a smaller place like Dial Post outside your area?
Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. Good photos up front let us bring everything on the first visit.
Is Pondtail Farm (Business Park), near Dial Post, within your area?
Yes. Estates, retail parks and business parks around Dial Post, Pondtail Farm (Business Park) among them, are all within reach. Photos and a short description are enough for a first look.
How is access to upper-level joints handled?
Access is planned with you before we quote. Tell us about access: existing scaffold, what you are arranging and any site restrictions.
Do you have public liability insurance?
Yes. Our insurance certificate can be sent alongside the quote.
Do you guarantee your work?
Yes. It runs for twelve months and covers how we prepared and sealed the joints, but not damage, misuse or other trades’ work.
Does the weather affect the work?
It can, for external work. Wet joints and cold, damp or frosty conditions stop the sealant bonding properly, so external work may be moved if conditions aren’t right. Internal work is far less affected.
Do you need to see the site first?
It depends on the job. Straightforward work can often be priced from photos and measurements, while larger or less clear jobs get a site visit first.
Mastic packages on Dial Post sites
The South East is one of the drier parts of the UK. That doesn’t stop wet spells, or frosty starts that leave panels too damp to seal, which is why external dates are agreed with the site manager. At about 39 miles from central London, Dial Post is within reach of the capital. Construction around the commuter belt mixes station-side flats with refurbished offices and units, and each scheme needs its mastic sealed to programme.
For contractors refurbishing units at places like Pondtail Farm (Business Park), which lies north of Dial Post, the mastic covers cladding panels, roller-door and window perimeters.
Dial Post is about 7 miles south of Horsham, in West Sussex. Dial Post sits inside our coverage, and jobs here get the same fixed quote and 12-month guarantee as anywhere else. We work across 373 places in West Sussex, from busy centres to rural villages. We also cover Brighton, around 13 miles from Dial Post.
Anyone looking for facade sealing in RH13 gets the same process as the rest of our area: details, then a fixed price, then sealing and a 12-month guarantee. Streets here include The Green, Swallows Lane and Bentons Lane, and sites on any of them can send details for a fixed quote. Just outside Dial Post, we also work in Whitehall (2 miles north-west), Shipley (2 miles north), West Grinstead (2 miles north-east), Broomer's Corner (2 miles north-west) and Partridge Green (2 miles east). Bigger towns within reach include Crawley (13 miles north-east), Horsham (7 miles north), Worthing (10 miles south), Haywards Heath (12 miles east), Burgess Hill (10 miles east) and Littlehampton (13 miles south-west).
Local landmarks in Dial Post
The countryside around Dial Post includes Knepp Wildland and Chanctonbury Hill.
Why it’s worth doing now in Dial Post
Topping up a failed joint usually buys very little time. A full cut-out and reseal costs more on the day but lasts much longer. Older rural buildings around Dial Post move with the seasons, and rigid or tired sealant can’t keep up. A sealant with the right movement capability, correctly sized, lasts far better.
The product called for affects the cost, and so does the preparation, from cutting out to priming and backing rod. Access, phasing and site rules also count.
Why appoint us
- 12 months’ guarantee on every job
- A Constructionline member, so easy to vet
- Coloured sealants to suit the setting, where available
- CHAS accredited contractor
Take a look at how commercial sealant jobs are priced and our accreditations and insurance.
Should maintenance staff do it?
Site maintenance staff can often handle a short internal joint. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
There’s also the paperwork. Main contractors and clients often ask for CSCS cards, RAMS and insurance details, and our CSCS-carded applicators are used to working under those rules.