Expansion and movement joint sealing in Tobermory, Argyll and Bute
Expansion and movement joint sealing in walls, decks and floors in Tobermory and across Argyll and Bute. CHAS accredited, Constructionline member, with a 12-month guarantee on workmanship.
- Hardened, cracked sealant on exposed facades
- Expansion joints filled with dirt and stones
- Previous reseals laid over old sealant
Expansion joint sealing for Tobermory sites
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
When it isn’t the sealant
Our job is the joint, not everything around it. Sealant alone won’t deal with:
- Crumbling edges that would give a new bead nothing sound to grip
- Cracking or settlement that calls for an engineer’s assessment
- Waterproofing layers buried beneath the sealant
Not sure which it is? You can phone 01277 525 020 or send details through our quote form and we’ll tell you honestly before you book.
Where we work in Tobermory
- Car park decks and ramps
- Cladding panel joints
- Brickwork movement joints
- Blockwork control joints
- Podiums and floor movement joints
- Precast concrete panel joints
About our expansion joint sealing in Tobermory
A movement joint only works while its seal does. When the sealant splits or lets go, the gap fills with dirt and water. Dealt with early, it stays a sealant job rather than a concrete or masonry repair. The enquiries we see most involve weathered movement joint sealant that no longer flexes and sealant peeling off one face of the joint, on car park decks and ramps, cladding panel joints and blockwork control joints. Whether you call it commercial sealant work, mastic application or joint sealing, the work in Tobermory is the same: failed joints cut out, faces prepared and the right sealant laid to the right depth.
For floor or movement joints around smaller places like Tobermory, we plan to finish in one visit where we can. Photos, approximate widths and what uses the floor help us bring the right materials.
Building owners and contractors get the same cover: a 12-month guarantee on our workmanship. It doesn’t extend to damage, faults in the building or work by others, and we’re upfront about that.
- Where
- Tobermory (PA75)
- Region
- Argyll and Bute
- Guarantee
- A 12-month guarantee
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Updated
- 3 November 2026
Also in Tobermory
Surface by surface
Concrete and precast panel joints
Precast and concrete panel joints move daily. The sealant needs the right movement capability and a controlled depth.
Podium joints
Podiums take foot traffic, planters and weather. A sealant suited to both traffic and exposure is used.
When to bring in a specialist
Using site staff can make sense for a small touch-up, but larger jobs are different: a specialist brings efficiency, a consistent finish and a 12-month guarantee.
Redoing a failed joint typically costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
Work for main contractors and building owners
Blocks and communal areas make up much of the work for housing associations and agents. Work can be phased so residents and staff keep access throughout, and each stage is agreed with your contact.
Whether you are a managing agent, a property factor or an owner’s representative: send the details, accept a fixed quote, and we carry out and guarantee the work. We can agree access arrangements and keyholder contacts beforehand.
On site: what to expect
On arrival, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before anything is cut or cleaned, and the work normally takes anything from part of a day to a couple of weeks, depending on joint lengths, widths and access. For work around Tobermory, we aim for one trip, which is why we ask for photographs and a full list first. Outside work also needs a suitable weather window.
- We start with photographs, approximate lengths and any drawings, visiting where needed.
- We compare each joint’s width with the movement and the sealant’s capability and tell you if the design looks wrong for the movement.
- Old sealant and debris are cut out of every joint.
- Edges are checked, and we tell you if any need repairing before sealing.
- A sealant suited to the movement and traffic is laid to depth and tooled.
- Each area is handed back after its cure time, under our 12-month guarantee.
Getting the site ready
- Tell us which areas need to stay in use
- Flag any permit to work we’ll need
- Point out parking and an unloading spot
Request a quote
Tell us about the building, the joints and when you need the work done, and a fixed quote will follow. To get it moving, phone 01277 525 020 or send photos by email.
Read more
Leave it or put it right?
Patching the worst lengths of a joint can make sense short term. But if the rest of the run is the same age and product, it’s usually not far behind. We can price a patch and a full reseal side by side. Exposed buildings in Scotland take a lot of weather, and for a smaller place like Tobermory, a repair visit takes planning, so it’s better to act early.
No two sites price the same: joint size, product, access and site hours all play a part. A fixed quote follows once we understand the job.
What you get with us
- A fixed quote before work starts
- A range of standard colours, depending on the product
- Public liability insurance in place
- A Constructionline member, so easy to vet
See our cost guide and how we’re accredited.
Expansion joint sealing around Tobermory: points for this area
With the shore within about 1 mile, Tobermory counts as a coastal location. External movement joints in car parks, ramps and yards near the coast take salt and wind-driven rain on top of traffic, and edges left open tend to break up faster. Tobermory is in the west of Scotland, the wetter side of the country. Rainwater through open yard and deck joints is a bigger issue here than in the drier east. External sealing is booked for dry spells, with some give in the dates.
Schools such as Tobermory High School have movement joints in their walls and floors that are easy to overlook. On industrial estates such as Baliscate Industrial Estate, 0.5 miles to the south of Tobermory, saw-cut floor joints, loading bay slabs and yard joints take the heaviest traffic.
Tobermory is in Argyll and Bute. Our applicators travel to Tobermory for work on movement joints, handled exactly as we handle every other area. We work across 124 places in Argyll and Bute.
We take on movement joints across the PA75 postcode area, for business premises of every kind. Streets here include Main Street, Breadalbane Street and Albert Street, and sites on any of them can send details for a fixed quote. Tobermory sits on or close to the A848 and B882, useful when we plan access and materials. Just outside Tobermory, we also work in Baliscate (1 mile south), Kilchoan (5 miles north), Ballygown (9 miles south-west), Salen (9 miles south-east) and Lochaline (13 miles south-east). Remote and island addresses take more planning, from travel and ferries to the weather, so give the site location in your enquiry.
Local landmarks in Tobermory
Around Tobermory, our work takes us to commercial buildings near Aros Park. A little further out are Mull Museum (under half a mile east) and St Columba's Roman Catholic Church and Drimnin Castle (2.8 miles east). The countryside around Tobermory includes 'S Àirde Beinn and Loch Peallach.
Your questions answered
Does a coastal location like Tobermory affect which sealant is used?
It can. Wind-driven rain and, closer to the shore, salt air are harder on external joints. That puts more weight on product choice, primers where the manufacturer specifies them, and correct joint sizing.
Is Tobermory too small for you to travel to?
Not at all: smaller places are covered as well as towns. Every Scottish council area is within our area. Send photographs and a list of what needs doing, and we’ll plan the job to need as few trips as possible.
Do you seal on top of existing sealant?
No, never. Sealing over old material is one of the classic causes of early joint failure, so everything comes out first.
Are expansion joints and movement joints the same thing?
They’re closely related. Both let materials grow and shrink with temperature, moisture and load.
Is movement joint sealing guaranteed?
The workmanship is guaranteed for 12 months from sign-off and we hold public liability insurance. Keeping joints clear of debris helps them last.
Which product is best for expansion joints?
The right product depends on the joint. Facades often take a low-modulus silicone; floors and decks typically need a polyurethane unless the specification names something else.
How long does movement joint sealing take?
It typically takes a short visit for a handful of joints, or several days or more for a car park deck or long runs of facade joints. We confirm the timescale with the quote along with the phasing plan.