Expansion joint sealing in Camore
Expansion and movement joint sealing in walls, decks and floors throughout Camore and nearby, carried out by CSCS-carded applicators. CHAS accredited and fully insured.
- Car park joints leaking onto vehicles below
- Sealant peeling off one face of the joint
- Damp inside where a wall movement joint has failed
Expansion joint sealing in Camore
Share the site address and what’s failing, and we’ll reply with a fixed quote or arrange a visit.
Site staff or a sealant specialist?
Using site staff can make sense for a small touch-up, but larger jobs are different: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
General builders and handymen seal joints, but it isn’t their main trade. A specialist prepares properly, controls joint depth and picks a product with the right movement class, which is what makes a joint last.
How we handle expansion joint sealing in Camore
Joints in car park decks and ramps are among the hardest-working in any building. Wheel loads, grit and de-icing salts attack the seal and the concrete either side, so failed seals soon lead to leaks onto the level below and broken edges. We reseal deck and ramp joints with a trafficable sealant chosen for the movement. The enquiries we see most involve chipped joint edges on forklift routes and debris jammed in movement joints, on podiums and floor movement joints, brickwork movement joints and car park decks and ramps. A single leaking joint is often how a building in Camore first comes to us: we look at the rest while we are there and tell you what we find.
Weather windows decide external joint work around a place like Camore: dry faces and the right temperature are essential, so dates have some give. Internal floors can be done whenever suits the site.
A 12-month guarantee applies to all our work in Highland. Should something we installed fail, ring 01277 525 020 or send details through our quote form and we will come back to it.
- Where
- Camore (IV25)
- Wider area
- Highland
- Cover
- 12 months on every job
- Quote
- Quoted before any work starts
- Call
- 01277 525 020
- Last updated
- 3 November 2026
Towns and villages near Camore
What else we do in Camore
How the job changes by surface
Podium joints
Podium joints often sit within a waterproofing system. Where the specification calls for sealant, we reseal.
Cladding panel joints
Cladding panels move more than masonry as they heat and cool. A sealant with the right movement class is chosen in a colour confirmed for that product.
What we are called out for in Camore
Sealant peeling cleanly off one side is an adhesion failure. Poor preparation, a skipped primer, or sealant bonded to the back of the joint are typical reasons.
Things that usually lead to an enquiry:
- Previous reseals laid over old sealant
- Chipped joint edges on forklift routes
- Water getting into the wall through a failed joint
- Sealant peeling off one face of the joint
For floors and slabs around Camore, the product is chosen for the traffic and the movement at each joint.
What to look for in a quote
- Whether primer will be used where the manufacturer specifies it
- Their public liability cover
- The named product and why it was chosen
- Will RAMS and insurance details be available?
Looking after the joints
Regular inspection catches problems early. Specifically:
- Act on the first tear or lifting edge rather than waiting
- Reopen bays and walkways only after the stated cure time
- Plan racking layouts so feet don’t land on a joint
- Look over external and deck joints after a hard winter
Floor joints on main traffic routes need watching more closely than the rest. Keep racking feet and heavy point loads off joint lines, and report any chipped edges early.
Rain gets into walls through torn brick and block movement joints. The first sign is often a damp patch indoors by which time the joint has been open for a while. Catching it early keeps the water outside.
How a job runs
We schedule the visit to fit the site hours and access windows you give us. While we’re working, the area stays contained and tidy, and we check in with your contact before moving on to each new area. For a building near Camore, directions, keys and a contact on the day are worth sorting early. We’ll confirm the plan with the fixed quote.
- We assess the joints on site or from photos, noting widths and how each has failed.
- You receive a fixed quote stating the product and the movement it is rated for.
- Phasing is agreed so decks, floors or entrances can stay in use where needed.
- The failed seal is cut out and both joint faces cleaned back to sound material.
- Backing rod or bond-breaker sets the depth, primer goes on where specified, and the sealant is applied and tooled.
- Finished joints are inspected, the cure time confirmed and the 12-month guarantee applies.
What we need from you
- Have the specification and drawings to hand
- Tell us what induction or permit system the site runs
- Move anything stored against the joints
Getting a fixed quote
Every quote starts with the facts: the joints involved, quantities, access and the product called for. Share whatever details you have and we will fill any gaps with a visit.
Read more
Traffic, movement and joints around Camore
Camore sits close to the coast, within about 1 mile. Coastal yards and decks give their joints salt and wet weather to deal with, not just wheels, so a failed joint lets more in and the edges break up sooner. The west of Scotland, where Camore is, gets more rain than the east. Open joints in car parks and yards let in more water than in drier areas. We wait for dry, workable days to seal them.
In a school such as Dornoch Academy, movement joints in brick, block and hall floors tend to be forgotten until they leak.
Camore is about 22 miles north of Nairn, in Highland. Anywhere in IV25, it works the same way: send details, get a fixed quote, we seal, and the work is guaranteed. Camore is one of 256 places we cover in Highland.
Commercial sites across IV25 are covered for movement joints. Among the streets we cover are Camore Crescent and Camore Gardens, and sites on any of them can send details for a fixed quote. If your building is just outside Camore, we cover Dornoch (1 mile east), Hilton (2 miles north-east), Skelbo Muir (3 miles north), Embo (3 miles north-east) and Littleferry (4 miles north-east). Further afield, our area takes in Tain (5 miles south), Alness (15 miles south-west), Invergordon (14 miles south), Golspie (7 miles north-east), Brora (12 miles north-east) and Cromarty (14 miles south). Island and remote sites need extra planning, with travel, ferry crossings where needed and weather to allow for, so mention the location when you ring 01277 525 020 or email a schedule or drawings.
Landmarks near Camore
Locally, jobs take us to sites close to Pilgudy Holiday Park and the streets around them. Camore’s nearest station is Tain station, roughly 4.9 miles south of the centre. Other landmarks nearby include Dornoch Castle (1.3 miles east) and Historylinks Museum (1.3 miles east). The countryside around Camore includes Loch Lànnsaidh and Loch Fleet National Nature Reserve.
How the quote is worked out
What shapes the price:
- Which sealant the job calls for
- The site’s rules and procedures
- Travel to remote or island sites
- Joint width, depth and condition
We don’t publish prices, because the scope varies so much from one building to the next. For a fixed figure, call for a quote and we will price your job on its own details.
What we need to price the job
Good information means a firmer quote. When you get in touch, include:
- The asbestos register, for older buildings
- Rough lengths or quantities, or drawings if you have them
- Where the site is, with the postcode
- The type of building and who uses it
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, give us a call on 01277 525 020 or send photos by email.
Common questions from Camore clients
Is Camore too far out for you?
Not at all. Camore is within our area. We work across every Scottish council area. Good photographs up front let us bring everything on the first visit.
Does a site in Camore have to shut while its joints are sealed?
Normally not: we work in sections and hand each one back once it has cured. We agree the sequence and timings with you before we start.
Can you quote from photos?
Many jobs can be quoted from photos, drawings or a joint schedule. Where they aren’t, we arrange a site visit.
Are you fully insured?
Yes. We are fully insured, and the certificate can go with your quote.
Can you fit around our working hours?
We are in the office from 8am until 5pm, Monday to Friday. Let us know your site hours and access windows, and the work will be planned around them.
Is colour matching possible?
In many cases, yes. Many products come in a range of standard colours, and matching to RAL references or surrounding finishes is often possible. We confirm what’s available for the specified product when we quote.
How soon can the area be used again?
We’ll confirm how long the chosen product needs to cure, and flag anything to keep off until it has cured.