Coloured and colour-matched sealant in Strathy, Highland
Work needed on a colour-matched joint in Strathy? We look at it, seal it with the right product and hand it over with a 12-month guarantee.
- Dirty, discoloured joints in public areas
- Discoloured joints on a visible elevation
- Old colour-matched joints lifting at the edges
Coloured sealant for Strathy sites
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
From enquiry to sign-off
A typical day starts with protection: masking tape along the joint edges and sheeting over anything nearby. On site, the work normally takes a few hours or a phased programme, depending on joint lengths and how many colours are involved, and our waste is bagged and taken away as we go. Jobs near Strathy are often grouped with others in the same area. Let us know if your dates have any give.
- First we agree which sealant type the joint needs.
- Your RAL reference, sample or photo is checked against that product’s colours.
- The nearest colour is agreed, with a sample bead where needed.
- The existing bead comes out, then faces are cleaned and backed.
- Edges are masked and the coloured sealant applied and tooled.
- We remove the masking and walk the finished joints with you.
Preparing the site
- Agree which areas must stay open
- Tell us your opening times and when work is allowed
- Send asbestos survey details if the building is pre-2000
Get a fixed quote
Quotes are fixed against the scope you send, so the cost is agreed before work starts. To start the process, call the office on 01277 525 020 or use the quote form.
Read more
Coloured sealant in Strathy, done properly
Colour-matched joints are often among the last items before handover. Adjacent finishes are masked and protected while we work, and we leave the area clean. Our workmanship carries a 12-month guarantee. Most enquiries involve colour changes after a rebrand or refit and failed coloured sealant that has split or peeled, across hotel bathrooms and public areas, powder-coated and anodised frames and cladding panels. For commercial sealant work in Strathy, you deal with one contact from quote to sign-off, for single jobs and planned programmes alike.
Travel to smaller places such as Strathy is planned so the whole job is finished in one visit where possible, so it helps to have photographs and a full list first. Several jobs nearby can also be put together.
Work we carry out in Highland comes with a 12-month guarantee. If an installation problem shows up, give us a call on 01277 525 020 or email drawings and photos and we’ll arrange a return visit.
- Where
- Strathy (KW14)
- Wider area
- Highland
- Cover
- 12 months on every job
- Price
- A fixed quote before we start
- Call
- 01277 525 020
- Last updated
- 3 November 2026
Commercial clients in Strathy
Hospitality, education, healthcare, office and retail clients come to us directly as well. We plan around the way the building is used, so the building keeps working while we do.
Facilities managers want contractors who arrive with the paperwork sorted. Let us know the documents you need (RAMS, insurance certificate, CSCS details) and we will confirm them with the quote.
Why deal with it now?
It’s far cheaper to approve a sample than to strip and redo a full run. A short trial bead costs very little. Around smaller places like Strathy, halls, stores and seasonal buildings may not be checked often, so a failed joint has time to cause damage. Early resealing prevents it.
Access can matter as much as the joints themselves: joints within easy reach take less time than ones that need access equipment. Mention the access as part of your enquiry.
What you get with us
- Health and safety: CHAS accredited
- Our applicators hold CSCS cards
- A fixed quote before work starts
- 12 months’ guarantee on every job
Take a look at our cost guide and our accreditations and insurance.
Sealant on show in Strathy’s commercial buildings
Strathy is within about 1 mile of the coast. Shopfronts, frames and external joints on commercial buildings there take wind-driven rain and, closer to the shore, salt in the air. A matched colour is only half the brief on an exposed frontage. Strathy is in the west of Scotland, the wetter side of the country. We plan external joints for dry spells and keep internal work in reserve. Shopfronts and frames facing the prevailing weather are where failures show first
For premises around Strathy where the joint is seen, colour options for the product are confirmed with the quote.
Strathy is about 17 miles west of Thurso, in Highland. We send applicators to Strathy for colour-matched joints. Strathy is one of 256 places in Highland on our list.
We cover the KW14 postcode districts. Close to Strathy, our area also takes in Portskerra (3 miles east), Melvich (3 miles east), Reay (8 miles east), Am Blàran Odhar (8 miles west) and Forss (13 miles east). Remote and island addresses take more planning, from travel and ferries to the weather, so mention the location when you give us a call on 01277 525 020 or email a schedule or drawings.
Around Strathy
For a walk, there’s Lochan Ealach.
Doing it in-house
Using site staff can make sense for a small touch-up, but anything bigger is another matter: a specialist works through quantities efficiently, leaves a consistent finish and backs it with a 12-month guarantee.
For most general trades, sealant is a sideline. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
FAQs: Strathy
Is Strathy too far out for you?
No. Small places get the same service as large ones. We cover the whole of Scotland. We plan jobs in smaller places so return trips are kept to a minimum.
Does a coastal location like Strathy affect which sealant is used?
It can. Driven rain and salt are tougher on outside sealant than sheltered inland conditions. We check the specified product suits the exposure and pay close attention to preparation.
Is it fine to apply new sealant on top of old?
No. Sealing over old material is one of the classic causes of early joint failure, so everything comes out first.
What happens if old sealant might contain asbestos?
The duty to manage asbestos sits with the building’s dutyholder, so we’ll ask for the register before work on an older building. If anything suspect turns up, we stop until it’s tested.
Do your applicators hold CSCS cards?
Yes. Should the site need card details in advance, tell us and we’ll confirm them with the quote.
Will the sealant be an exact match to our finish?
No. We can’t promise an exact custom match. Sealants come in a wide range of standard colours, and we will confirm the colours available for the specified product so you can choose.
Does weather matter for sealant work?
It can, when the joints are outside. Sealant won’t bond properly to a wet or frosty joint, so we watch the forecast and rearrange outside work if we have to. Internal work is far less affected.
Signs you need coloured sealant in Strathy
A change of finish can leave existing sealant mismatched. New cladding colours, repainted frames or a refreshed shop fit all prompt colour changes that the sealant has to follow.
What tends to prompt an enquiry:
- Sealant that no longer suits recoated frames
- Marked sealant in hotel bathrooms
- Old colour-matched joints lifting at the edges
- Untidy coloured beads with ragged edges
A lasting commercial joint around Strathy begins with the old bead fully out and the faces clean and dry.
Comparing quotes
- Can the work be phased to keep areas open?
- The named product and why it was chosen
- What level of public liability insurance do they hold?
- What the guarantee covers, and for how long
Aftercare for building managers
To get the most from the new sealant:
- Protect fresh coloured sealant from dust and handling
- Put the colour reference on the finishes schedule
- Clean coloured joints with mild products
- Reseal whole runs rather than patching single joints
Keep a record of the product and colour reference used. It makes matching later repairs much easier.
Put the sealant colour into the specification or finishes schedule. When colour is left to the last minute, it is often wrong; fixing it early prevents rework.