Washroom Sealing contractors in Inverness
Washroom sealing in Inverness, backed by over 20 years in commercial sealing. Fully insured, with a 12-month guarantee.
- Failed sealant in a tea point or staff kitchen
- Users noticing mouldy joints
- Failed sealant behind washroom basins
Washroom sealing near Inverness
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
General trades versus a specialist
Site maintenance staff can often handle a short internal joint. Where it goes wrong is preparation: sealing over old material, sealing onto damp or dusty surfaces, or a product that can’t take the movement.
Redoing a failed joint usually costs more than getting it right at the outset, because the whole bead must be removed and the faces cleaned back again. That’s why many clients bring in a specialist from the beginning.
Washroom sealing for commercial buildings in Inverness
Accessible toilets, shower rooms and changing rooms have joints that work harder than most: wet-floor edges, tray perimeters, basin tops and the line where flooring meets the wall. An open joint there lets water track under flooring or behind wall panels, so we look at them closely. If you have mould spotting along silicone joints and resealing that didn’t last because the old bead stayed, we can put it right. Whoever orders the work in Inverness, the brief is typically the same: a clear scope, tidy work and joints that don’t fail again.
Care homes and sheltered housing in a Scottish town like Inverness need washroom resealing done while keeping disruption for residents low. We agree times and rooms with the manager and work a few at a time.
Our 12-month guarantee is about workmanship, not wear and tear. Sealant wears with time, and movement, weather, cleaning and use decide how fast, so we spell out the cover before we begin.
- Where
- Inverness (IV2, IV3, IV1)
- Region
- Highland
- Guarantee
- A 12-month guarantee
- Quote
- A fixed quote before we start
- Telephone
- 01277 525 020
- Last updated
- 3 November 2026
What we can’t put right
Some faults sit outside our scope, and we say so rather than covering them up:
- Leaks through tanking or membranes below the finishes
- Fittings that move too much to hold a bead
- Vanity carcasses that have swollen
Not sure which it is? You can phone 01277 525 020 or email the details over and we will tell you honestly.
Joints and surfaces we work on
- Kitchens and tea points
- Vanity units and basins
- Urinals and WCs
- Showers, trays and wet room floors
- IPS panels and cubicles
- Accessible toilets and changing rooms
What we are called out for in Inverness
We often find acrylic caulk or general-purpose sealant in joints that should have sanitary silicone. They aren’t made for constant wetting, and they stain, crack or wash out.
Things that normally lead to an enquiry:
- Panel joints letting water behind
- Sealant laid over old silicone and now peeling
- Users noticing mouldy joints
- Stained or open joints at kitchen sinks and worktops
Customer toilets and staff facilities at retail sites such as Telford Retail Park, 1.1 miles to the north-west of Inverness, need sealant that stays clean under heavy use.
What your quote should include
- Which product they’ll use, and why it suits the joint
- How joint depth will be controlled
- Their plan for phasing and protecting the area
- Health and safety accreditation such as CHAS
Building owners, agents and FMs in Inverness
CHAS accredited and a Constructionline member, we make supplier vetting simple. Our insurance certificate can be sent along with the quote.
We work for building owners and managing agents on sealant work across single buildings or whole portfolios. Several sites can go on one quote, which keeps the paperwork simple.
On site: what to expect
On arrival, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before anything is cut or cleaned, and the work normally takes between a morning and a week or so, set by the number of rooms and the phasing you need. Jobs in Inverness are planned with two things in mind: the forecast for external joints and the building’s hours for internal ones. Photos or drawings let us give a fixed quote and a realistic plan.
- Every room is surveyed and the failed joints listed.
- The fixed quote sets out the rooms, the products and the phasing.
- The whole of the old bead is removed.
- Each joint is cleaned and left dry.
- New anti-mould sealant goes in and is tooled neat.
- Each area is handed back when ready.
Getting the site ready
- Point out parking and an unloading spot
- Tell staff and tenants when we will be in
- Agree which areas must stay open
Ask for a quote
Every quote starts with the facts: what’s there, how much of it, how we reach it and what’s specified. Send what you have, and we will arrange a site visit if anything is unclear.
Read more
Sanitary sealant for Inverness buildings
The sea is no more than about 2 miles from Inverness, and coastal hotels, guest houses and holiday sites tend to fill up in the busy months. Heavy seasonal use is hard on shower and basin sealant, so we plan the work for quieter weeks where possible. Being in the west of Scotland, Inverness gets more rain than eastern areas. In a damp climate, washrooms that aren’t well ventilated stay wet for longer, and sealant in a room that never dries out moulds faster.
For a college such as Inverness College UHI, 1.6 miles to the east of Inverness, half-term and summer give the windows for washroom work. In a centre such as Eastgate Shopping Centre (0.7 miles north of Inverness), public washrooms are resealed a block of facilities at a time.
Inverness (Gaelic: Inbhir Nis) is in Highland. We cover commercial sites throughout Inverness. Across Highland, 256 places are covered, Inverness among them.
Postcode districts covered here: IV2, IV3 and IV1 for washrooms and wet areas. If your site is on High Street, Market Brae and Falcon Square or close by, send details and we’ll quote for washrooms and wet areas. You’ll find Inverness on or near the A9 and A82, so getting applicators and materials to site is simple. Sites close to Inverness are covered too, including Ballifeary (1 mile west), Crown (1 mile north-east), Hilton (1 mile south-east), Millburn (1 mile north-east) and Lochardil (1 mile south). Bigger towns within reach include Nairn (15 miles north-east), Cradlehall (3 miles east), Dingwall (12 miles north-west), Muir of Ord (9 miles west), Fortrose (8 miles north-east) and Conon Bridge (10 miles north-west). As one of the bigger centres in Highland, Inverness has a broad mix of commercial, public and industrial buildings, and we cover them all. For island and remote sites, we plan travel and materials carefully, so the full address helps from the start.
What’s near Inverness
In Inverness, that means premises near Cavell Gardens and Maple Court Hotel and the streets around them. For rail, the closest station is Inverness station, about 0.7 miles north of the centre. Well-known places in the area include Inverness Castle (0.5 miles north) and Inverness Museum and Art Gallery (0.5 miles north). The countryside around Inverness includes Tomnahurich.
Why it’s worth doing now in Inverness
Waiting for a holiday closure can leave failing joints in place for a long time. With phasing, the work can go ahead while most facilities stay open. Buildings in towns like Inverness often have joints of similar age across a whole building or estate. One programme for all of them saves time.
The price depends on the quantity of joints, what has to come out first and how the joints are reached. Call for a fixed quote once you have the details.
Why choose Mastic Doctor in Inverness
- Colour options checked against the specified product
- Standard and matched colours in many product ranges
- Colours chosen to suit frames, cladding or finishes where possible
- Fully insured, including public liability cover
Common questions from Inverness clients
Can you take on a job at a hospital such as Royal Northern Infirmary?
Yes, provided the work is planned with the site’s estates team. Before anything starts, the estates team agrees permits, inductions and infection-control measures with us.
Can work at a site such as University of the Highlands & Islands fit around teaching?
Yes. We plan campus work around teaching, exams and residence turnarounds. Tell us which site documents you need, such as RAMS, our insurance certificate or CSCS details, and they’re confirmed with the quote.
Is old silicone taken out first?
We always remove it. New silicone won’t stick to the old so a bead over the top fails quickly.
Will all the toilets be closed at once?
Just the room being resealed is out of use. Rooms go back into use once the sealant has cured and we start the next.
Does weather matter for sealant work?
Outside, yes. The joint has to be dry and within the product’s temperature range, so frost, rain or cold mornings can delay outside work. Inside work is seldom held up.
How long do sealant joints last?
There isn’t a single answer, because life depends on how much the joint moves, how exposed it is and how it’s cleaned and used. Regular checks let you plan resealing before leaks or damage.
Can you work to our specification?
Yes. We follow the specification, along with the manufacturer’s installation guidance, and we raise anything unclear before work begins.