Little Ann floor joint sealing
Our CSCS-carded applicators take on floor joint sealing and filling in warehouses, factories and industrial units in Little Ann. Send details for a fixed quote.
- Filler that has parted from one face
- Drivers complaining about joints on a route
- Chipped and spalling edges along forklift routes
Floor joint sealing for Little Ann sites
Send drawings, photos or a joint schedule, or tell us about the site, and we’ll come back with a fixed quote.
Doing it in-house
Redoing a failed joint normally costs more than getting it right at the outset, since all of it has to come out and the faces be cleaned back again. For that reason, many FMs and contractors use a sealant specialist from the outset.
For most general trades, sealant is a sideline. A specialist brings correct preparation, depth control with backing rod and a product suited to that particular joint.
Floor joint sealing for commercial buildings in Little Ann
Open joints take a beating from forklift and pallet-truck wheels. Every pass chips at the bare concrete edge, and over time a neat cut turns into a ragged channel. Filling the joint properly gives the edges back their support. It also smooths the route for drivers and stock. We work on joints along racking aisles, retail and showroom floors and loading bays, and the failures we are asked to look at most are a gap opening alongside old joint filler and failing joints at loading bays and dock doors. A single leaking joint is often how a building in Little Ann first comes to us: we check the joints around it and give you an honest view of what needs doing now and what can wait.
Smaller community and commercial buildings around Little Ann have their own movement joints in walls and floors. They tend to be overlooked until something leaks or cracks.
We sign every job off with a 12-month guarantee. It’s a plain promise: if our work fails within that year, we put it right.
- Place
- Little Ann (SP11)
- Wider area
- Hampshire
- Guarantee
- 12 months on every job
- Quotes
- A fixed quote before we start
- Phone
- 01277 525 020
- Page updated
- 3 November 2026
Places near Little Ann
More services for Little Ann
When it isn’t the sealant
Part of a good diagnosis is knowing where sealant stops. You’ll hear from us if the cause turns out to be any of the following:
- Joint edges that have already broken away, which need repairing before filling (we’ll tell you if so)
- Structural cracking in the slab
- Damaged or worn floor coatings and screeds
Not sure which it is? You can call 01277 525 020 or email the details over and we will tell you honestly before you book.
What we seal
- Retail and showroom floors
- Loading bays
- Saw-cut induced joints
- Joints along racking aisles
- Construction joints
- Forklift and pallet-truck routes
Why it’s worth doing now in Little Ann
Every jolt over a broken joint passes into the truck, the load and the driver. That means extra wear on wheels and a rougher ride for staff, adding costs nobody plans for. A properly filled joint smooths the route. For buildings around smaller places like Little Ann, water damage can go unnoticed for longer, especially where a building isn’t used daily, which gives a failed joint time to do damage. Resealing early avoids that.
Pricing floor joints depends on quantities, condition and access, and any specification that applies. Ask us for a fixed quote.
Why appoint us
- Fully insured
- Commercial sealant work since 2005
- Constructionline member
- Specification-led, product-correct work
Take a look at how commercial sealant jobs are priced and our accreditations.
Joints that move: notes for Little Ann
Central London is about 65 miles from Little Ann. Distribution warehouses and industrial estates are common around the motorway corridors that serve the capital. Little Ann is in the South East, one of the UK’s drier regions. Outside joints in yards and car parks still have to be dry before sealing, and winter de-icing salt on car parks and ramps works into any open joint.
Office parks like Plot 5 Andover Business Park (1.5 miles north of Little Ann) have decks, ramps and clad elevations whose joints take movement every day. Sites like Andover War Memorial Hospital (to the north-east of Little Ann) carry ambulances, deliveries and visitors’ cars over their road and deck joints. At places like Glenmore Business Park (1.5 miles north-east of Little Ann), joints are sealed a section at a time so operations carry on.
Little Ann is about 2 miles south-west of Andover, in Hampshire. We cover commercial sites throughout Little Ann, for single jobs and planned programmes alike. 723 places across Hampshire fall within our area, Little Ann among them. Southampton is covered too, some 19 miles away.
We take on floor joints across the SP11 postcode area, whatever the building. For a building on Salisbury Road, The Old Coach Road and Old Salisbury Road or nearby, send details and we’ll quote for floor joints. Just outside Little Ann, we also work in Abbotts Ann (1 mile west), Anna Valley (1 mile north-east), Red Rice (1 mile south), Monxton (2 miles north-west) and Amport (2 miles west). Further afield, our area takes in Winchester (13 miles south-east), Chandler's Ford (15 miles south), Romsey (14 miles south), Hyde (12 miles south-east), Tidworth (7 miles north-west) and Weeke (11 miles south-east).
Landmarks near Little Ann
Around Little Ann, our work takes us to commercial buildings near Redrice School, John Hanson Community School and The Eagle pub and the streets around them. The nearest railway station is Andover station, about 2 miles north-east of the centre. A little further out are Andover War Memorial Hospital (2.2 miles north-east) and Andover Museum (2.4 miles north-east). The countryside around Little Ann includes Anton Lakes and Mill Lake.
After the work
Regular inspection catches problems early. Specifically:
- Start with the dock areas, where joints fail soonest
- Hold traffic back until the product has cured
- Expect fillers on young slabs to need a top-up
- Keep photos of joints that look like they’re failing
Young concrete carries on shrinking, so some fillers part slightly from one face. It is a known trait of new floors and a later top-up deals with it in most cases.
Treating joints while the arrises are sound keeps the work simple. After the edges go, repairs come into it and that takes longer and closes areas for longer.
Your questions answered
Does your area include sites such as Plot 5 Andover Business Park, near Little Ann?
Yes. Our area takes in Little Ann and its surroundings, with estates and business parks such as Plot 5 Andover Business Park included. Send details of the unit and the work through our quote form for a quick quote.
Can you take on a job at a hospital such as Andover War Memorial Hospital?
Yes. We work in healthcare settings as well as offices and schools. We follow the site’s permits, sign-in and infection-control procedures in every area.
How long does a job like this take?
We plan the time on site around your programme and access. We will give you an estimate of time on site when we quote.
Do your applicators hold CSCS cards?
Yes. We use CSCS-carded applicators, as many construction sites ask for.
Are you fully insured?
Yes. Our insurance certificate can be sent alongside the quote.
How long before trucks can use the joints?
Cure times vary with the product and how cold the slab is. You will get a reopening time for each area when we agree the phasing.
Is the floor joint work guaranteed?
A 12-month guarantee covers the work we do. It applies to our workmanship rather than structural movement or accidental damage.
Our process
On arrival, we report to your site contact and complete whatever induction the building runs. Everything around the joints gets protected before anything is cut or cleaned, with the work itself normally taking between a day and a number of days, set by the joint lengths, the edge condition and the phasing you need. For work around Little Ann, we aim to finish in one visit, so photographs and measurements up front really help. Then the right materials arrive with us.
- First, the zones and order of work are agreed with you.
- We point out joints whose edges need repairing first.
- We clear each run back to clean concrete.
- The chosen filler or sealant goes in flush with the slab.
- You get a time for each zone to reopen.
Preparing the site
- Share your working hours and any access restrictions
- Send asbestos survey details if the building is pre-2000
- Point out parking and an unloading spot
Quotes
The quickest route to a quote is a few photographs and the site postcode. Send them through the quote form, or phone 01277 525 020 or use the quote form to discuss it first.
Read more
How the quote is worked out
A fixed quote reflects the actual work. It allows for:
- Whether old sealant has to be cut out first
- Joint width, depth and condition
- Working within restricted access windows
- How much there is to seal
We don’t publish prices, since every building and every scope is different. Call for a quote.
What we need to price the job
The more we know, the firmer the quote. Helpful details to send:
- Specification clauses that apply
- Drawings or a marked-up plan, if available
- Whether an asbestos survey exists
- Photos of the joints, close up and from further back
Specifications, drawings and tender packages are welcome with any enquiry, and we will price the work to it. For smaller jobs, photographs and a description will do.