Innerwick floor joint sealing
Floor joint sealing and filling in warehouses, factories and industrial units in Innerwick. CHAS accredited and fully insured, with a 12-month guarantee.
- Dock area joints that have failed first
- Sealant pulled out along a truck route
- Brittle joint filler breaking up
Need floor joint sealing in Innerwick?
Tell us what needs sealing and where, with photos or drawings if you have them, and we’ll price it.
Your questions answered
Is Innerwick too small for you to travel to?
Not at all: smaller places are covered as well as towns. We work across every Scottish council area. Send photos and a list of what needs doing, and we will plan the job to need as few trips as possible.
Is a hospital such as Belhaven Hospital somewhere you can work?
Yes. Healthcare sites are among the places we work. Work is phased so departments keep running, under the site’s own rules.
Can you phase floor joint work around operations?
The work is phased. Areas are taken out of use a section at a time around the site hours and access windows you give us.
How soon can traffic go back on the floor?
Cure times vary with the product and how cold the slab is. We will give you a time for each zone before we start.
Why is there a gap next to the joint filler?
It can be shrinkage, contamination on the joint faces or a product unsuited to the movement. We diagnose the cause before suggesting a fix.
Do you use semi-rigid filler or flexible sealant on floor joints?
We decide joint by joint. Where hard wheels cross, a semi-rigid filler is typically right and perimeter or movement joints need flexibility. The quote sets out what goes where.
Is it fine to apply new sealant on top of old?
No. Overlaying old sealant is a frequent cause of early failure, so it all comes out first.
Floor joint sealing for commercial buildings in Innerwick
Across Innerwick and the rest of East Lothian, it runs the same way: send details, get a fixed quote, we seal, and the work is guaranteed. A rough length of joint, photos of the worst areas and a site plan let us give a quick quote and a visit can be arranged where that is easier. Site teams most often ask us about joint fill separating from the concrete and scruffy, dirty joint lines on a shop or showroom floor, on joints along racking aisles, forklift and pallet-truck routes and loading bays. One point of contact handles commercial sealant work in Innerwick from the first photographs to the final walk-round, for single jobs and planned programmes alike.
For floor or movement joints around smaller places like Innerwick, we plan to finish in one visit where we can. Send photographs, joint widths and details of the traffic first.
Every job ends the same way: guaranteed. Our workmanship is backed for 12 months, and we explain exactly what that covers when we quote.
- Location
- Innerwick (EH42)
- Region
- East Lothian
- Guarantee
- A 12-month guarantee
- Price
- A fixed quote before we start
- Phone
- 01277 525 020
- Last updated
- 3 November 2026
Why act early in Innerwick
Holding off until the whole floor can close can take a long time. Zone by zone, the worst aisles can be dealt with now and the remainder follows on a plan that suits you. Renewing every failing joint on one visit is the sensible approach for a place like Innerwick. Photos of each area help us quote the whole job.
We don’t publish prices, because the scope varies so much from one building to the next. For a fixed figure, call for a quote and we’ll price your job on its own details.
Why us?
- One number for every site we cover
- CHAS accredited
- CSCS-carded applicators
- Fully insured
Take a look at what affects the cost or how we’re accredited.
When to call us in Innerwick
Loading bay joints are exposed to wind, wet tyres and bigger temperature swings on top of the heaviest turning movements. That is usually where joint failure starts.
Site and facilities staff are often the first to spot these:
- Soft sealant dragged out of trafficked joints
- Dock area joints that have failed first
- Joint fill separating from the concrete
- Chipped and spalling edges along forklift routes
In and around Innerwick, the right filler or sealant for each joint depends on the traffic and the movement it takes.
Questions to ask before you book
- Their public liability cover
- How they handle RAMS and site documents
- Whether old or failed sealant will be cut out, not overlaid
- Do they follow the manufacturer’s priming guidance?
What sets the cost
Each job is priced on its own details. The main factors are:
- Travel to remote or island sites
- The total length or number of joints
- Removal of failed or old sealant
- Any access equipment needed
Cost follows what’s involved: stripping out, preparation, sealing, access and phasing. Call for a quote and we will explain how it’s made up.
Sending details for a quote
For an accurate fixed quote, we need a clear picture of the site. Send us:
- The postcode of the building
- Whether the building will be occupied during the work
- Rough lengths or quantities, or drawings if you have them
- Any dates the work must fit around
Let us know the site, the scope and your timescale, and we’ll put a fixed quote together. To get it moving, ring 01277 525 020 or send photos by email.
Towns and villages near Innerwick
What else we do in Innerwick
Doing it in-house
Putting right a botched joint often costs more than sealing it well at the start, since all of it has to come out and the faces be cleaned back again. That’s why many clients bring in a specialist from the beginning.
A short, simple internal joint is often within reach of a maintenance team. The usual problems come from preparation: new sealant over old, damp or dusty faces, or the wrong product for the movement.
Maintenance after handover
Once the work is signed off, a little attention goes a long way:
- Plan for a top-up on newer floors
- Treat loading bay joints first if they’re failing
- Sweep debris out of open joints until they can be filled
- Record damaged joints with a photo and a location
Young concrete carries on shrinking, so some fillers part slightly from one face. That is common and is typically dealt with by topping up once the slab has settled down.
A broken joint on a main route is crossed by every truck on that route. Early treatment protects wheels, loads and drivers as much as the floor.
How a job runs
Where the site stays busy, the work is phased so only one area is out of use at a time. Each area is protected, prepared and sealed, then handed back before we move to the next. Tell us who will meet us and how to get in at your building near Innerwick. That goes into the plan alongside the quote.
- We look at joint widths, edge condition and the traffic on each route.
- A fixed quote follows, listing the treatment for each area and the order of work.
- Each joint is cleared of old fill and dirt and taken back to clean, sound edges.
- We vacuum each run and prime it if the chosen product requires a primer.
- The chosen product is placed to its specified depth and trimmed level with the floor.
- The area is handed back once it has cured enough to take traffic.
Getting the site ready
- Warn occupants and staff about the work
- Agree which areas must stay open
- Share your working hours and any access restrictions
Ask for a quote
To get a fixed quote, call the office on 01277 525 020 or email us. You can also send details through our quote form.
Advice
Floors, slabs and movement joints in Innerwick
Innerwick is within about 2 miles of the coast. Open joints in coastal car parks and yards let in salt-laden water as well as grit, so it pays to keep them sealed. Being in the east of Scotland, Innerwick gets less rain than the west coast. Frost and de-icing salt still find their way into open external joints. Sealing them before winter limits the damage.
A healthcare site such as Belhaven Hospital (4.3 miles north-west of Innerwick) depends on car parks, ramps and service yards whose joints take traffic all day.
Innerwick is about 13 miles east of Haddington, in East Lothian. Commercial clients in Innerwick use us for work on floor joints. Across East Lothian, 48 places are covered, Innerwick among them. Edinburgh is covered too, around 29 miles from Innerwick.
Postcode districts covered here: EH42. Buildings on Back Lane, Manse View and Kirk Brae are within our area for floor joints. If your building is just outside Innerwick, we cover Broxburn (3 miles north-west), Spott (3 miles west), Cockburnspath (4 miles south-east), Dunbar (4 miles north-west) and Cove (4 miles east). Further afield, our area takes in Haddington (13 miles west), North Berwick (13 miles north-west), Gullane (15 miles west) and East Linton (8 miles west).
What’s near Innerwick
The nearest railway station is Dunbar station, about 3.8 miles north-west of the centre. Nearby you’ll also find Innerwick Castle (0.9 miles east) and Belhaven Hospital (4.3 miles north-west). For a walk, there’s Doon Hill and Pease Dean.